A5.35/A5.35M-2015

Specification for Covered Electrodes for Underwater Wet Shielded Metal Arc Welding

A5.35/A5.35M-2015 发布历史

This specification prescribes requirements for the classification@ based on underwater wet welding test and associated evaluation@ of covered electrodes for underwater wet shielded metal arc welding. Requirements for certification of test results are also shown herein. The specification covers ferritic steel@ austenitic stainless steel@ and nickel filler metals plus any auxiliary coatings applied over the electrode covering. Unless otherwise specified herein@ the term ??manufacturer?? refers to the provider of the finished product (the electrode ready for underwater use). The requirements herein are intended to classify electrodes without consideration for potential base metals to be welded; suitability for specific base metals should be established by the customer during welding procedure qualification testing (see Annex A for further considerations). This specification does not govern depth of water capability or maximum exposure time for wet welding electrodes classified to this document. However@ such information shall be clearly shown as required by the marking requirements of Clause 14. Safety and health issues and concerns are beyond the scope of this standard and@ therefore@ are not fully addressed herein. Some safety and health information can be found in informative Annex A. Safety and health information is available from other sources@ including@ but not limited to@ ANSI Z49.1@ Safety in Welding@ Cutting@ and Allied Processes@ and applicable federal and state regulations.

A5.35/A5.35M-2015由AWS - American Welding Society 发布于 2015-01-01，并于 2015-12-22 实施。

A5.35/A5.35M-2015的历代版本如下：

• 2015年01月01日 A5.35/A5.35M-2015

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 A5.35/A5.35M-2015 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

A5.35/A5.35M-2015

发布日期

2015年01月01日

实施日期

2015年12月22日

废止日期

无

中国标准分类号

/

国际标准分类号

/

发布单位

AWS - American Welding Society

引用标准

34

适用范围

This specification prescribes requirements for the classification@ based on underwater wet welding test and associated evaluation@ of covered electrodes for underwater wet shielded metal arc welding. Requirements for certification of test results are also shown herein. The specification covers ferritic steel@ austenitic stainless steel@ and nickel filler metals plus any auxiliary coatings applied over the electrode covering. Unless otherwise specified herein@ the term ??manufacturer?? refers to the provider of the finished product (the electrode ready for underwater use). The requirements herein are intended to classify electrodes without consideration for potential base metals to be welded; suitability for specific base metals should be established by the customer during welding procedure qualification testing (see Annex A for further considerations). This specification does not govern depth of water capability or maximum exposure time for wet welding electrodes classified to this document. However@ such information shall be clearly shown as required by the marking requirements of Clause 14. Safety and health issues and concerns are beyond the scope of this standard and@ therefore@ are not fully addressed herein. Some safety and health information can be found in informative Annex A. Safety and health information is available from other sources@ including@ but not limited to@ ANSI Z49.1@ Safety in Welding@ Cutting@ and Allied Processes@ and applicable federal and state regulations.