SAE J1730-2019
SAE J 1730-2019
ABS Exciter Ring Location Standardization
SAE J1730-2019 发布历史
This SAE Recommended Practice establishes the Antilock Brake System [ABS] sensor interface and envelope dimensions for standardizing the location of the ABS rings mounted on the inner end of spoke wheels@ hubs and hub-rotor assemblies on the following axle designations. a. FF b. FL c. FC d. FH e. L f. R g. U h. W j. N k. P Purpose This document provides standardized wheel end ABS sensor interface dimensions for spoke wheels@ hubs@ and hub-rotor assemblies intended for normal highway use on trucks@ buses@ truck trailers and multi-purpose vehicles. The illustrations given in the document are for reference only. These illustrations show typical sensor ring designs and mountings@ but are not limited to those shown. Serviceability considerations are not covered in this document.
SAE J1730-2019由SAE - SAE International 发布于 2019-02-01，并于 2019-02-13 实施。
SAE J1730-2019的历代版本如下：
- 1996年10月01日 SAE J1730-1996 SAE J 1730-1996
- 1999年10月01日 SAE J1730-1999 ABS励磁环定位标准化
- 2004年07月01日 SAE J1730-2004 SAE J 1730-2004
- 2012年03月15日 SAE J1730-2012 ABS励磁环定位标准化
- 2019年02月01日 SAE J1730-2019 SAE J 1730-2019
- 标准号
- SAE J1730-2019
- 发布日期
- 2019年02月01日
- 实施日期
- 2019年02月13日
- 废止日期
- 无
- 中国标准分类号
- /
- 国际标准分类号
- /
- 发布单位
- SAE - SAE International
- 引用标准
- 10
- 适用范围
- This SAE Recommended Practice establishes the Antilock Brake System [ABS] sensor interface and envelope dimensions for standardizing the location of the ABS rings mounted on the inner end of spoke wheels@ hubs and hub-rotor assemblies on the following axle designations. a. FF b. FL c. FC d. FH e. L f. R g. U h. W j. N k. P Purpose This document provides standardized wheel end ABS sensor interface dimensions for spoke wheels@ hubs@ and hub-rotor assemblies intended for normal highway use on trucks@ buses@ truck trailers and multi-purpose vehicles. The illustrations given in the document are for reference only. These illustrations show typical sensor ring designs and mountings@ but are not limited to those shown. Serviceability considerations are not covered in this document.