"This specification covers established manufacturing tolerances applicable to sheet@ strip@ and plate of nickel@ nickel alloys@ and cobalt alloys ordered to metric dimensions. These tolerances apply to all conditions@ unless otherwise noted. The term ""excl"" is used to apply only to the higher figure of a specified range. Where the terms ""nickel""@ ""nickel-copper""@ ""nickel-chromium""@ ""nickel-molybdenum""@ ""nickel-molybdenum-chromium""@ and ""cobalt"" are used without qualification@ they refer to both non-heat-treatable and heat-treatable alloys as applicable@ unless otherwise noted. Throughout this specification the term ""metric"" is intended to refer to the SI system. These tables are based upon metric values and preferred metric sizes. AMS 2262@ specified in inch/pound units@ is the equivalent of this MAM. "