These requirements are intended to cover both self-ballasted lamps and self-ballasted lamp adapters rated 120 to 347 V AC nominal for connection to screw-base@ pin-base@ or recessed single contact (RSC or R7) lampholders. These devices are intended for use in accordance with the National Electrical Code@ ANSI/NFPA 70@ and the Canadian Electrical Code@ Part I@ in non-hazardous locations@ and the Instalaciones El??ctricas (utilizaci??n)@ NOM-001-SEDE. These devices incorporate resistance@ reactance@ or electronic (solid-state) type ballasts or power supplies. These devices employ various lamp technologies including@ but not limited to@ incandescent@ fluorescent@ high-intensity discharge lamps@ light-emitting diodes. These requirements also include Supplemental Requirements for Light-Emitting Diodes (LED)@ Supplement SA@ for: a) Self-contained LED lamps@ rated 120 to 347 V AC nominal for connection to screw-@ pinbase@ and recessed single contact (RSC or R7) lampholders@ b) Lamps for replacement of an ANSI standardized fluorescent lamp@ and consisting of lightemitting- diode (LED) lamp technologies@ with control circuitry@ and a driver or power supply. The LED driver and control circuitry will be either integral with the lamp or remote from the lamp@ and c) Component LED lamps@ with or without control circuitry@ an ANSI base other than bases mentioned in (a)@ for connection to LED driver having a low voltage output@ such as replacement for tungsten-halogen@ MR11 and MR16 shaped lamps. This standard does not apply to medium-to-medium base (E26) fittings that incorporate controls such as photocells@ motion detectors@ radio controls@ or dimmers covered by other standards. These devices are not intended for use with emergency exit fixtures or emergency exit lights.