60034-14-2003 Machines électriques tournantes Partie 14: Vibrations mécaniques de certaines machines de hauteur d?axe supérieure ou égale à 56 mm Mesurage@ évaluation et limites de l?intensité vibratoire (Edition 3.0)
Rotating electrical machines Part 14: Mechanical vibration of certain machines with shaft heights 56 mm and higher Measurement@ evaluation and limits of vibration severity (Edition 3.0)
Machines électriques tournantes Partie 14: Vibrations mécaniques de certaines machines de hauteur d?axe supérieure ou égale à 56 mm Mesurage@ évaluation et limites de l?intensité vibratoire (Edition 3.0) 是非强制性国家标准,您可以免费下载前三页
This part of IEC 60034 specifies the factory acceptance vibration test procedures and vibration limits for certain electrical machines under specified conditions@ when uncoupled from any load or prime mover.It is applicable to d.c. and three-phase a.c. machines@ with shaft heights 56 mm and higher and a rated output up to 50 MW@ at operational speeds from 120 min-1 up to and including 15000 min-1. This standard is not applicable to machines mounted in situ@ three-phase commutator motors@ single-phase machines@ three-phase machines operated on single-phase systems@ vertical waterpower generators@ turbine generators greater than 20 MW and machines with magnetic bearings or series-wound machines.NOTE For machines measured in situ refer to applicable parts of ISO 10816 and ISO 7919.