This SAE Standard provides general and dimensional specifications for the most common hose fittings used in conjunction with hydraulic hoses specified in SAE J517 and utilized in hydraulic systems on mobile and stationary equipment. The general specifications contained in Sections 1 through 15 are applicable to all hydraulic hose fittings and supplement the detailed specifications for the 100R-series fittings contained in the later sections of this document. This document shall be utilized as a procurement document only to the extent agreed upon by the manufacturer and user. Refer to SAE J517 for specifications of hose and information on hose assemblies. SAE J1273 contains information on application factors affecting hose fittings@ hose@ and hose assemblies. The following are hose fitting types contained in this document: a. Male dryseal pipe thread hose fittings shall be as shown in Figure 1A to 1C for the respective styles@ and in Table 1A to 1M for the applicable hoses and sizes. b. Male straight thread O-ring hose fittings shall be as shown in Figure 2A to 2B or the respective styles@ and in Table 2A to 2G for the applicable hoses and sizes. c. Male 37 degrees flared hose fittings shall be as shown in Figure 3A to 3C for the respective styles@ and in Table 3A to 3K for the applicable hoses and sizes. d. Female 37 degree flared hose fittings shall be as shown in Figures 4A to 7B for the respective styles and shapes@ and in Tables 4A to 4M for the applicable hoses and sizes. e. Male 45 degrees flared hose fittings shall be as shown in figures 8A and 8B for the respective styles@ and in tables. 5A to 5E for the applicable hoses and sizes f. Female 45 degrees flared hose fittings shall be as shown in figures 9A and 12B for the respective styles@ and shapes @ and in tables. 6A to 6E for the applicable hoses and sizes. g. Male flareless type hose fittings shall be as shown in Figures 13A and 13B for the respective styles@ and in Table 7A and 7B for the applicable hoses and sizes. h. Female flareless type hose fittings shall be as shown in Figure 14A to 14C for the respective styles@ and in Table 8A and 8B for the applicable hoses and sizes. i. 4-bolt split flange type hose fittings shall be as shown in Figures 15A to 21C for the respective styles and shapes@ and in Tables 9A to 9I2 for the applicable hoses and sizes. j. Female O-ring face seal hose fittings shall be as shown in Figure 22A to 25B for the respective styles@ and in Table 10A to 10L for the applicable hoses and sizes. It is recommended that where step sizes or additional types of fittings are required@ they be designed to conform with the specifications of this document insofar as they may apply. The following general specifications shall supplement the dimensional data contained in the tables with respect to all unspecified detail.