SPEC 12P-2008

Specification for Fiberglass Reinforced Plastic Tanks (Third Edition; Effective Date: April 1@2009)

SPEC 12P-2008 发布历史

General This specification covers material@ design@ fabrication@ and testing requirements for fiberglass reinforced plastic (FRP) tanks. Only shop-fabricated@ vertical@ cylindrical tanks are covered. Tanks covered by this specification are intended for above ground and atmospheric pressure service. Unsupported cone bottom tanks are outside the scope of this specification. This specification is designed to provide the petroleum industry with various standard sizes of FRP tanks. Because of the versatility of FRP tanks@ the user shall be responsible for determining the suitability of FRP tanks for the intended service. The consequences of exposing the FRP tank to high temperatures created by exposure fires should be considered. This material loses strength as the temperature increases. FRP tanks should be suitably protected against fire exposure or so located that any spills resulting from the failure of these materials could not unduly expose persons@ buildings@ structures or other equipment to the above. Compliance The manufacturer is responsible for complying with all of the provisions of this specification.

SPEC 12P-2008由API - American Petroleum Institute 发布于 2008-10-01，并于 2016-02-11 实施。

SPEC 12P-2008的历代版本如下：

• 1986年09月01日 SPEC 12P-1986
• 1995年01月01日 SPEC 12P-1995
• 2008年10月01日 SPEC 12P-2008
• 2016年02月01日 SPEC 12P-2016

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 SPEC 12P-2008 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

SPEC 12P-2008

发布日期

2008年10月01日

实施日期

2016年02月11日

废止日期

无

中国标准分类号

/

国际标准分类号

/

发布单位

API - American Petroleum Institute

引用标准

38

适用范围

General This specification covers material@ design@ fabrication@ and testing requirements for fiberglass reinforced plastic (FRP) tanks. Only shop-fabricated@ vertical@ cylindrical tanks are covered. Tanks covered by this specification are intended for above ground and atmospheric pressure service. Unsupported cone bottom tanks are outside the scope of this specification. This specification is designed to provide the petroleum industry with various standard sizes of FRP tanks. Because of the versatility of FRP tanks@ the user shall be responsible for determining the suitability of FRP tanks for the intended service. The consequences of exposing the FRP tank to high temperatures created by exposure fires should be considered. This material loses strength as the temperature increases. FRP tanks should be suitably protected against fire exposure or so located that any spills resulting from the failure of these materials could not unduly expose persons@ buildings@ structures or other equipment to the above. Compliance The manufacturer is responsible for complying with all of the provisions of this specification.