This British Standard provides guidance on the design of parallel sided helical torsion springs manufactured from rectangular and square section wire and bar. 1 Limitation on material section dimensions This standard applies only to springs made from rectangular section material where the ratio of radial dimension, b, to the axial dimension, h, termed the shape factor, m, is not greater than 2.5 and not less than 0.4. NOTE 1 This applies because, outside the shape factor range 2.5 to 0.4, it is difficult to coil a spring accurately. NOTE 2 There are numerous methods of calculating the parameters necessary for the design of springs and initially the designer is free to use any one of these. This standard differentiates between springs that have or have not been stress relieved after forming, designated group A springs, and springs, the material of which has undergone a structural change by heat treatment after forming, designated group B springs. This British Standard gives two methods of specifying springs for general purposes and one method of testing springs
BS 8726-2-2002由英国标准学会 GB-BSI 发布于 2002-09-25,并于 2002-09-25 实施。
BS 8726-2-2002 在中国标准分类中归属于: J26 弹簧,在国际标准分类中归属于: 21.160 弹簧。
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号