BS 8726-2:2002
矩形和方型线材和棒材制的圆柱形螺旋式弹簧.计算和设计指南.扭力弹簧

Cylindrical helical springs made from rectangular and square section wire and bar - Guide to calculation and design - Torsion springs

标准号

BS 8726-2:2002

发布

2002年

发布单位

英国标准学会

当前最新

BS 8726-2:2002

 

 

被代替标准

02/702404 DC-2002 BS 1726-3:1989

适用范围

This British Standard provides guidance on the design of parallel sided helical torsion springs manufactured from rectangular and square section wire and bar. 1 Limitation on material section dimensions This standard applies only to springs made from rectangular section material where the ratio of radial dimension, b, to the axial dimension, h, termed the shape factor, m, is not greater than 2.5 and not less than 0.4. NOTE 1 This applies because, outside the shape factor range 2.5 to 0.4, it is difficult to coil a spring accurately. NOTE 2 There are numerous methods of calculating the parameters necessary for the design of springs and initially the designer is free to use any one of these. This standard differentiates between springs that have or have not been stress relieved after forming, designated group A springs, and springs, the material of which has undergone a structural change by heat treatment after forming, designated group B springs. This British Standard gives two methods of specifying springs for general purposes and one method of testing springs

BS 8726-2:2002相似标准

推荐