DIN EN 1845:2008
制鞋机械.鞋模机械.安全要求

Footwear manufacturing machines - Footwear moulding machines - Safety requirements; English version of DIN EN 1845:2008-06

被代替

标准号

DIN EN 1845:2008

发布

2008年

发布单位

德国标准化学会

替代标准

DIN EN 1845:2008-06

当前最新

DIN EN 1845:2008-06

 

 

引用标准

EN 294:1992 EN 547-1:1996 EN 547-2:1996 EN 574:1996 EN 614-1:2006 EN 626-1:1994 EN 626-2:1996 EN 811:1996 EN 894-2-19 EN ISO 12100-2:2003 EN ISO 13732-1:2006 EN ISO 13849-1:2006 EN ISO 13850:2006 EN ISO 14121-1:2007 EN ISO 14122-1:2001 EN ISO 14122-2:2001

被代替标准

DIN EN 1845:1999 DIN EN 1845:2007

适用范围

1.1 This European Standard applies to footwear moulding machines which are intended for use in the shoe industry for the production of footwear and footwear components. These machines are: -- direct-on sole moulding machines (see Figures 1, 2 and 3); -- unit sole and footwear component moulding machines (see Figures 4 to 10); -- full shoe and boot moulding machines (see Figure 11). This European Standard applies also to the mentioned machines when used for other products than footwear and footwear components, as far as these products require no other changes than a different mould. 1.2 This European Standard specifies safety requirements for construction, transport, installation, adjustment, setting, teaching or process change-over, operation, cleaning, maintenance, decommissioning, dismantling and, as far as safety is concerned, disposal for machines mentioned in 1.1. It deals with all significant hazards, hazardous situations and events relevant to footwear moulding machines, when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4). 1.3 The following machines are excluded from the scope of this European Standard unless used for direct- on sole moulding or reaction moulding: -- moulding machines with static injection units and static mould stations (clamping units); -- moulding machines with static metering and mixing units and mobile stations with linear configuration (mould carriers). 1.4 The European Standard does not deal with hazards created by the mixing and metering unit. NOTE For metering and mixing units, see EN 1612-1. The use of machines within the scope of this European Standard in industries other than those specified in 1.1 may give rise to hazards not considered during its preparation. NOTE For this application see also EN 201 and prEN 1612-2. 1.5 This European Standard also applies to the following additional equipment for material handling and operation which are an integral part of the machine: -- spraying devices, injection units, casting units, nozzle cleaners, sprue pullers, mould front edge cleaners, activating devices, robots and equipment for preparatory and subsequent treatment (see Figure M.1). 1.6 This European Standard assumes the machines: -- are operated by adequately trained persons; -- are used with adequate workplace lighting (see EN 12464-1). 1.7 This document is not applicable to footwear moulding machines which are manufactured before the date of publication of this European Standard by CEN.

DIN EN 1845:2008相似标准

推荐