This specification establishes general requirements for the processes listed in 3.3.1 for heat treatment of steel parts (See 8.2.1) by users or their vendors or subcontractors. Reference to AMS 2759 on a drawing, fabrication order, purchase order, etc constitutes a requirement to conform to the applicable provisions of the documents listed in 3.3.1 for the hear treatment of steel parts of the particular alloy described. Parts made from steels orther than those specified in the detail specifications may be heat treated in accordance with the applicable requirements using processing temperatures, times, and other parameters recommended by the material producer unless otherwise specified by purchaser. The conditions (temperatures, soaking times, cooling rates, etc) used by material producers, forge shops, and foundries for qualification of response to heat treatment of their products shall conform to the requirements of the specifications listed in 3.3.1. Heat treatment of raw material by raw material producers, forge shops, or foundries should be in accordance with the material procurement specification. Processes such as vacuum-furnace heat treating, flame hardening, induction through-hardening, austempering, martempering, and hot oil quenching are recognized heat treating processes, but their requirements are not completely covered by this specification. While the materials, methods, applications, and processes described or referenced in this specification may involve the use of hazardous materials, this specification does not address the hazards that may be involved in such use. It is the sole responsibility of the user to ensure familiarity with the safe and proper use of any hazardous materials and to take necessary precautionary measures to ensure the health and safety of all personnel involved.