ISO 16841:2014
钢丝绳. 绳索安装的拉孔. 类型和最低要求
Steel wire ropes - Pulling eyes for rope installation - Types and minimum requirements
说明：
- 此图仅显示与当前标准最近的5级引用；
- 鼠标放置在图上可以看到标题编号；
- 此图可以通过鼠标滚轮放大或者缩小；
- 表示标准的节点，可以拖动；
- 绿色表示标准：ISO 16841:2014 ， 绿色、红色表示本平台存在此标准，您可以下载或者购买，灰色表示平台不存在此标准；
- 箭头终点方向的标准引用了起点方向的标准。
- 标准号
- ISO 16841:2014
- 发布
- 2014年
- 发布单位
- 国际标准化组织
- 当前最新
- ISO 16841:2014
- 引用标准
- ISO 10425:2003 ISO 17558:2006 ISO 17893:2004 ISO 2408:2004 ISO 7500-1:2004
- 适用范围
- This International Standard identifies the different types of pulling eyes prepared at, or attached to, a steel wire rope end for connection to another rope when installing a new rope or re-reeving an existing rope on a machine. This International Standard also specifies the minimum requirements for pulling eyes, including their geometry, strength, maximum line pull to which the pulling eye is intended to be subjected and information for use to be provided by the manufacturer. The pulling eyes covered by this International Standard are not intended to be subjected to a load when the machine performs a service operation. This International Standard applies to those pulling eyes prepared at, or attached to, ends of steel wire ropes conforming to ISO 2408 and ISO 10425. This International Standard does not apply to steel wire ropes with fibre cores. This International Standard does not cover those separate end connection accessories, which slide over the end of a rope and comprise an eye- and tubular-type braided rope, often referred to as a “wire rope stocking” or “cable sock”.