This standard specifies the emission limits of exhaust pollutants, real driving emissions (RDE) exhaust pollutants, crankcase pollutants, evaporation pollutants, and refueling process pollutants at room temperature and low temperature for light vehicles equipped with ignition engines. and measurement methods, durability of pollution control devices, technical requirements and measurement methods of on-board diagnostic (OBD) systems. This standard specifies the emission limits and measurement methods of exhaust pollutants, real driving emissions (RDE) exhaust pollutants and crankcase pollutants at room temperature and low temperature for light vehicles equipped with compression ignition engines, and the durability of pollution control devices. performance, technical requirements and measurement methods of on-board diagnostic (OBD) systems. This standard specifies the requirements and confirmation of light-duty steam type inspection, inspection and judgment methods of production consistency and in-use compliance. This standard also specifies the special requirements for light vehicles fueled with liquefied petroleum gas (LPG) or natural gas (NG). This standard also stipulates the type inspection procedures for pollutant emissions of alternative pollution control devices intended to be installed on light-duty vehicles as independent technical assemblies. This standard also stipulates the technical requirements for vehicles using reactants in the exhaust aftertreatment system, and the emission test procedures for vehicles equipped with periodic regeneration systems. This standard applies to light-duty vehicles (including hybrid electric vehicles) powered by ignition engines or compression ignition engines with a maximum design speed greater than or equal to 50km/h. Under the requirements of the manufacturer, the type inspection of M1, M2, N1 and N2 vehicles with a maximum design total mass exceeding 3500kgR can be carried out according to this standard. This standard does not apply to vehicles that have passed the sixth stage type inspection according to the provisions of GB 17691. Vehicles using fuel types not included in Appendix K can refer to the relevant provisions of this standard.
GB 18352.6-2016 history
2016GB 18352.6-2016 Limits and measurement methods for emissions from light-duty vehicles(CHINA 6)
2014GB 18352.5-2013 Limits and measurement methods for emissions from light-duty vehicles (CHINA 5)
2005GB 18352.3-2005 Limits and measurement methods for emissions from light-duty vehicles (Ⅲ, Ⅳ)
2001GB 18352.2-2001 Limits and measurement methods for emissions from light-duty vehicles(Ⅱ)