GB 18352.5-2013
Limits and measurement methods for emissions from light-duty vehicles (CHINA 5)

Be replaced

Standard No.

GB 18352.5-2013

Language

Chinese

Release Date

2014

Published By

General Administration of Quality Supervision, Inspection and Quarantine of the People‘s Republic of China

Replace By

GB 18352.6-2016

Lastest

GB 18352.6-2016

Replace

GB 18352.3-2005

Scope

This standard specifies the emission limits and measurement methods of exhaust pollutants, dual-idle exhaust pollutants, crankcase pollutants, and evaporative pollutants at room temperature and low temperature for light vehicles equipped with ignition engines, and the durability of pollution control devices. , On-board diagnostics (OBD) system (referred to as OBD system) technical requirements and measurement methods. This standard specifies the emission limits and measurement methods of exhaust pollutants and free acceleration smoke at room temperature for light vehicles equipped with compression ignition engines, the durability of pollution control devices, the technical requirements and measurement methods of OBD systems. This standard specifies the requirements for type approval of light vehicles, inspection and judgment methods for production consistency and in-use compliance. This standard also specifies the special requirements for light-duty vehicles fueled with liquefied petroleum gas (LPG) or natural gas (NG). This standard also specifies the type approval procedures for pollutant emissions of alternative pollution control devices intended to be installed on light-duty vehicles as independent technical assemblies. This standard also stipulates the technical requirements for vehicles using reactants in the exhaust aftertreatment system, and the emission test procedures for vehicles equipped with periodic regeneration systems. This standard applies to light-duty vehicles (including hybrid electric vehicles) powered by ignition engines or compression ignition engines with a maximum design speed greater than or equal to 50km/h. Under the requirements of the manufacturer, vehicles of categories M₁, M₂ and N₂ whose maximum gross mass exceeds 3 500 kg but whose reference mass does not exceed 2 610 kg can be tested according to this standard. Type approval; for models that have obtained the type approval of this standard, it can be extended to M₁, M₂, N₁ and N₂ class cars. This standard does not apply to vehicles that have obtained Phase V type approval in accordance with the provisions of GB 17691-2005.

GB 18352.5-2013 Referenced Document

• EN 1822 High efficiency air filters (EPA, HEPA and ULPA) - Part 5: Determining the efficiency of filter elements*， 2023-06-29 Update
• GB 1495 Limits and measurement methods for noise emitted by accelerating motor vethicles
• GB 17691-2005 Limits and measurement methods for exhaust pollutants from compression ignition and gas fuelled positive ignition engines of vehicles (Ⅲ,Ⅳ,Ⅴ)
• GB 18285 Limits and measurement methods for emissions from gasoline vehicles under two-speed idle conditions and simple driving mode conditions*， 2018-09-27 Update
• GB 3847-2005 Limits and measurement methods for exhaust smoke from C.I.E. (Compression Ignition Engine) and vehicle equiped with C.I.E.
• GB 7258 Amendment No. 2 to Technical Conditions for Motor Vehicle Operation Safety
• GB/T 15089-2001 Classification of power-driven vehicles and trailers
• GB/T 19001-2008 Quality management systems.Requirements
• GB/T 19755 Measurement methods for emissions from light-duty hybrid electric vehicles
• HJ 509 Determination of Platinum,Palladium and Rhodium loading in the vehicle-used ceramic catalytic converters.Inductive coupled plasma-optical emission spectrometry and inductive coupled plasma-mass spectrometry
• HJ/T 390 Technical requirement for environmental protection product Control system of fuel evaporative pollutants from vehicle with petrol engine
• ISO 14230-4 Road vehicles - Diagnostic systems; Keyword protocol 2000 - Part 4: Requirements for emission-related systems
• ISO 15031-3 Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 3: Diagnostic connector and related electrical circuits: Specification and use*， 2023-02-06 Update
• ISO 15031-4 Road vehicles - Communication between vehicle and external equipment for emissions-related diagnostics - Part 4: External test equipment*， 2014-02-01 Update
• ISO 15031-5 Road vehicles - Communication between vehicle and external equipment for emissions-related diagnostics - Part 5: Emissions-related diagnostic services*， 2015-08-01 Update
• ISO 15031-6 Road vehicles - Communication between vehicle and external equipment for emissions-related diagnostics - Part 6: Diagnostic trouble code definitions*， 2015-08-01 Update
• ISO 15031-7 Road vehicles.Communication between vehicle and external equipment for emissions-related diagnostics.Part 7: Data link security
• ISO 15765-4 Road vehicles — Diagnostics on Controller Area Networks (CAN) — Part 4: Requirements for emissions-related systems*， 2021-07-30 Update
• ISO 2575:1982 Road vehicles; Symbols for controls, indicators and tell-tales
• ISO 8422:1991 Sequential sampling plans for inspection by attributes
• ISO 9141-2 Road vehicles - Diagnostic systems - Part 2: CARB requirements for interchange of digital information; Amendment 1
• SAE J1850 Class B Data Communications Network Interface*， 2022-12-20 Update

GB 18352.5-2013 history

• 2016 GB 18352.6-2016 Limits and measurement methods for emissions from light-duty vehicles（CHINA 6）
• 2014 GB 18352.5-2013 Limits and measurement methods for emissions from light-duty vehicles (CHINA 5)
• 2005 GB 18352.3-2005 Limits and measurement methods for emissions from light-duty vehicles (Ⅲ, Ⅳ)
• 2001 GB 18352.2-2001 Limits and measurement methods for emissions from light-duty vehicles(Ⅱ)

GB 18352.5-2013 Limits and measurement methods for emissions from light-duty vehicles (CHINA 5) has been changed from GB 18352.3-2005 Limits and measurement methods for emissions from light-duty vehicles (Ⅲ, Ⅳ).

GB 18352.5-2013 Limits and measurement methods for emissions from light-duty vehicles (CHINA 5) was changed to GB 18352.6-2016 Limits and measurement methods for emissions from light-duty vehicles（CHINA 6）.

GB 18352.5-2013 -All Parts