This standard applies to all rotating electrical machines, except motors specified by other national standards and IEC standards, such as IEC60349. Motors within the scope of this standard may also comply with the requirements of other national standards and IEC standards that have been replaced, modified or supplemented, such as IEC60079 and IEC60092. Note: If certain provisions of this standard need to be modified in order to be suitable for special purposes such as radiation-tolerant motors or aerospace motors, all other provisions will remain valid as long as they are applicable.
GB/T 755-2019 Referenced Document
CISPR 11 Industrial, scientific and medical equipment - Radio-frequency disturbance characteristics - Limits and methods of measurement*, 2024-02-13 Update
GB/T 21210-2016 Starting Performance of Single-speed Three-phase Cage Induction Motor
IEC 60027-1 Letter symbols to be used in electrical technology - Part 1: General; Corrigendum 1
IEC 60027-4 Letter symbols to be used in electrical technology - Part 4: Rotating electric machines
IEC 60034-3 Rotating electrical machines - Part 3: Specific requirements for synchronous generators driven by steam turbines or combustion gas turbines and for synchronous compensators*, 2020-05-26 Update
IEC 60034-5 Corrigendum 1 - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification*, 2024-01-19 Update
IEC 60034-6 Rotating electrical machines; part 6: methods of cooling (IC code)
IEC 60038 IEC standard voltages CONSOLIDATED EDITION*, 2021-12-01 Update
IEC 60060-1 High-voltage test techniques - Part 1: General definitions and test requirements
IEC 60085 Electrical insulation - Thermal evaluation and designation
IEC 60204-1 Safety of machinery - Electrical equipment of machines - Part 1: General requirements*, 2024-06-12 Update
IEC 603 Connectors for frequencies below 3 MHz for use with printed boards; part 8: two-part connectors for printed boards for basic grid of 2, 54 mm (0, 1 in), with square male contacts of 0, 63 mm * 0, 63 mm
IEC 60445 Basic and safety principles for man-machine interface, marking and identification - Identification of equipment terminals, conductor terminations and conductors*, 2021-07-16 Update