This part specifies the acceptance rules for electrical fittings. This part applies to power fittings (hereinafter referred to as fittings) used for overhead power lines with rated voltages of 10kV and above, substations and power distribution devices in power plants. Similar fittings used for low-voltage distribution network can refer to this part. The fittings used in severe corrosion, polluted environment, high altitude area, alpine area and other conditions should still meet the relevant calibration of other standards.
GB/T 2317.4-2008 Referenced Document
DL/T 1098 Spacer technical conditions and test methods*, 2016-01-07 Update
DL/T 1099 Anti-vibration hammer technical conditions and test methods
DL/T 768.7 Manufacture quality specification for electric power fittings hot dip galvanized coatings on fabricated iron and steel articles*, 2012-08-23 Update
GB/T 2314 General technical requirements for electric power fittings
GB/T 2317.1 Test method for electric power fittings.Part 1: Mechanical tests
GB/T 2317.2 Test methods for electrical fittings - Part 2: Corona and radio disturbance tests*, 2009-10-01 Update
GB/T 2317.3 Test method for electric power fittings.Part 3:Heat cycle tests for electric power fittings
GB/T 2317.4-2008 history
2023GB/T 2317.4-2023 Test methods for electrical fittings - Part 4: Rules for acceptance
2008GB/T 2317.4-2008 Test method for electric power fittings.Part 4:Acceptance inspection for electric power fittings
2000GB/T 2317.4-2000 Acceptance inspection,marking and packing for electric power fittings