13.060.20;91.140.60 标准查询与下载
共找到 142 条与 相关的标准，共 10 页
This European Standard specifies requirements relating to the construction, performance and methods of testing for active media filters for drinking water installations inside buildings, with a maximum working pressure of at least 1000 kPa and a maximum working temperature of less than 30 °C. It only concerns units, which are permanently connected to the mains supply at the point of entry or point of use. This standard applies only to filter systems comprising a housing and filter media tested together. It includes capsule type units where both the element and its outer housing are disposable. NOTE Products intended for use in water supply systems are to comply, when existing, with national regulations and testing arrangements that ensure fitness for contact with drinking water. The Member States relevant regulators and the EC Commission agreed on the principle of a future unique European Acceptance Scheme (EAS) which would provide a common testing and approval arrangement at European level. If and when the EAS is adopted, European Standards on products will be amended by the addition of an Annex Z/EAS under Mandate M/136 which will contain formal references to the testing, certification and product marking requirements of the EAS. Until the EAS comes into force, the current national regulations remain applicable.
Water conditioning equipment inside buildings - Active media filters - Requirements for performance, safety and testing
- ICS
- 13.060.20;91.140.60
- CCS
- P42
- 发布
- 2007-06
- 实施
This European Standard specifies definitions, principles of construction (but not dimensions) and design, requirements on performance and operation as well as methods for testing the performance of chemical preset dosing systems for conditioning water intended for human consumption inside buildings (see [8]) which are permanently connected to the mains supply.
Water conditioning equipment inside buildings - Chemical dosing systems - Pre-set dosing systems - Requirements for performance, safety and testing
- ICS
- 13.060.20;91.140.60
- CCS
- P42
- 发布
- 2007-06
- 实施
This European Standard specifies requirements relating to the construction, performance and methods of testing for membrane separation systems with a particle rating below 1 µm, namely microfiltration (MF), ultrafiltration (UF), nanofiltration (NF) and reverse osmosis (RO) for drinking water installations inside buildings, intended to remove from the drinking water marginal concentrations of suspended and colloidal solids, microorganisms, organic molecules and/or to reduce the dissolved solids concentration and applies to systems with a minimum pressure of PN 10, connections between DN 15 and DN 100 and a maximum working temperature of at least 30 °C. This European Standard applies to membrane separation systems, whose elements may be partly or entirely cleanable or disposable in accordance with the type of system. It only concerns units which are permanently connected to the mains supply at the point-of-entry or the point-of-use. A membrane separation system may include, together with the separation device pre- and /or post-treatment devices. For the scope of this European Standard: separation device shall comply with this European Standard, i.e. without pre-and/or post-treatments; where pre-and/or post-treatment devices are incorporated in the system, each of them shall conform to the relevant standard. If this is the case, the complete system shall be considered as conforming as a whole.
Water conditioning equipment inside buildings - Membrane separation devices - Requirements for performance, safety and testing
- ICS
- 13.060.20;91.140.60
- CCS
- P42
- 发布
- 2007-06
- 实施
Drinking water supply from small units and non stationary plants - Part 1: Small units - Guidelines for drinking water, planning, construction, operation and maintenance of plants; Technical rule of the DVGW; Supplement 1: Example for a checklist for the
- ICS
- 13.060.20;91.140.60
- CCS
- X04;Q81
- 发布
- 2007-05
- 实施
Drinking water supply from small units and non stationary plants - Part 1: Small units - Guidelines for drinking water, planning, construction, operation and maintenance of plants; Technical rule of the DVGW
- ICS
- 13.060.20;91.140.60
- CCS
- X04;Q81
- 发布
- 2007-05
- 实施
This European Standard specifies requirements relating to the construction and mode of operation and relevant methods for testing automatic, salt-regenerated, anion exchange nitrate removal devices for drinking water installations inside buildings, which are permanently connected to the mains supply. NOTE Products intended for use in water supply systems are to comply, when existing, with national regulations and testing arrangements that ensure fitness for contact with drinking water. The Member State's relevant regulators and the EC Commission agreed on the principle for a future unique European Acceptance Scheme (EAS) which would provide a common testing and approval arrangement at European level. If and when the EAS is adopted, European Standards on products will be amended by the addition of an Annex Z/EAS under Mandate M/136, which will contain formal references to the testing, certification and product marking requirements of the EAS. Until the EAS comes into force, the current national regulations remain applicable.
Water equipment inside buildings - Nitrate removal devices - Requirements for performance, safety and testing; German version EN 15219:2006
- ICS
- 13.060.20;91.140.60
- CCS
- P42
- 发布
- 2007-02
- 实施
To increase the level of protection provided by Standard 61 by lowering the drinking water acceptance criteria for lead.
Drinking water system components - Health effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
The proposed revision is to lower the maximum contaminant concentration (MCC) for lead for material extraction testing from 0.015 mg/L to 0.010 mg/L in Table 1 of the Drinking Water Treatment Unit Standards.
Drinking water treatment units - health effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
To include explicit and uniform guidance for overtime testing protocols into sections 4 (4.5.4.3), 5 (5.5.5.5), 6 (B.3.7), 8 (B.4.5) and 9 (B.5.6) on Multiple Time Point Protocols.
Drinking water system components - Health effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
To include USEPA methods 524.2 and 525.2 in Tables 1 and 2 and include language to ensure when using the GC/MS (method 625) an adequate analytical library has been developed.
Drinking water treatment units - Health effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
To incorporate POE drinking water treatment unit systems into Standard 61.
Drinking Water System Components - Health Effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
To provide requirements for drinking fountain type outlets on DWTU devices.
Drinking water treatment units - Health effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
To specifically identify flexible plumbing connectors in the scope of section 9 and transfer the evaluation of riser tubing to section 9, rather than section 4.
Drinking water system components - Health effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
Add a required labeling distinction for POE systems only that NSF/ANSI 61 does not cover performance and structural integrity certifications.
Drinking Water System Components - Health Effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
To revise requirements for filter media.
Drinking water treatment units - Health Effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
Allow a toxicology assessment to determine the most appropriate exposure water for "all other process media" to be consistent with the other test procedures throughout Standard 61.
Drinking Water System Components - Health Effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
To establish sample sizes for mechanical reduction tests other than cyst reduction..
Drinking water treatment units - Health effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
To incorporate recent additions of Organics/Pesticides considered contaminants by the U.S. Environmental Protection Agency and Health Canada.
Drinking Water System Components - Health Effects
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2007
- 实施
This document specifies definitions, principles of construction, requirements and methods for testing the performance of UV devices for drinking water installations inside buildings which are permanently connected to the mains supply at the point of entry into a building or within the water distribution system inside the building. UV devices in the sense of this standard are UV bactericidal treatment devices or UV disinfection devices.
Water conditioning equipment inside buildings - Devices using mercury low-pressure ultraviolet radiators - Requirements for performance, safety and testing
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2006-09-29
- 实施
- 2006-09-29
This European Standard specifies requirements relating to the construction, performance and methods of testing for active media filters for drinking water installations inside buildings, with a maximum working pressure of at least 1 000 kPa and a maximum working temperature of less than 30 °C. It only concerns units, which are permanently connected to the mains supply at the point of entry or point of use. This standard applies only to filter systems comprising a housing and filter media tested together. It includes capsule type units where both the element and its outer housing are disposable. NOTE Products intended for use in water supply systems are to comply, when existing, with national regulations and testing arrangements that ensure fitness for contact with drinking water. The Member States relevant regulators and the EC Commission agreed on the principle of a future unique European Acceptance Scheme (EAS) which would provide a common testing and approval arrangement at European level. If and when the EAS is adopted, European Standards on products will be amended by the addition of an Annex Z/EAS under Mandate M/136 which will contain formal references to the testing, certification and product marking requirements of the EAS. Until the EAS comes into force, the current national regulations remain applicable.
Water conditioning equipment inside buildings - Active media filters - Requirements for performance, safety and testing
- ICS
- 13.060.20;91.140.60
- CCS
- Q81
- 发布
- 2006-09-29
- 实施
- 2006-09-29
