13.060.30 污水 标准查询与下载

DB37/T 5248-2023 《城镇污水处理设施臭气处理技术规程》

本规程适用于新建、改（扩）建的城镇污水处理厂（站）等污水处理设施、城镇污水提升泵站和污泥处理过程中除臭工程的设计、施工、验收和运行管理。

"Technical Regulations for Odor Treatment of Urban Sewage Treatment Facilities"

ASTM D5761-23 多相流体废料的乳化/悬浮的标准实施规程

1.1 This practice covers the generation of a uniform mixture or emulsion from multiphase samples which are primarily liquid in order to facilitate sample preparation, transfer, and analysis. 1.2 This practice is designed to keep a multiphase fluid sample in an emulsified/suspended state long enough to take a single, composite sample that is representative of the sample as a whole. The sample may reform multiple layers after standing. 1.3 The emulsion/suspension generated by following this practice can be used only for analytical procedures designed for the total sample and procedures not significantly affected by the emulsifier or the presence of an emulsion/suspension. 1.4 This practice assumes that a representative sample of not more than 1 L has been obtained. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Practice for Emulsification/Suspension of Multiphase Fluid Waste Materials

DB31/ 1405-2023 水产养殖尾水排放标准

Aquaculture tail water discharge standards

T/SDSES 007-2023 智慧污水处理厂感知层设备布设规范

本文件规定了城镇智慧污水处理厂感知层设备的布设原则，为城镇污水处理厂全工艺流程中感知层设备的设计、选型和安装点位等给出了技术指导。 本文件适用于新建、改建和扩建城镇污水处理厂感知层设备布设。

Layout specification for sensing layer devices of smart sewage treatment plant

T/SDSES 006-2023 智慧污水处理厂建设规范（生产运行）

本文件规定了城镇智慧污水处理厂生产运行管理方面数字化、自动化、智慧化建设方面的要求。 本文件适用于城镇智慧污水厂建设和既有污水厂智慧化升级改造。

Construction specification for smart sewage treatment plants (production run)

T/QDAS 109-2023 零碳源投加污水脱氮技术规程

本文件规定了零碳源投加污水脱氮的核心工艺参数调控和出水水质要求等方面的内容。 本文件适用于零碳源投加的污水脱氮处理。

Technical specification for zero carbon source dosing wastewater denitrification

ASTM G210-13(2023) 操作严重废水分析测试装置的标准实施规程

Standard Practice for Operating the Severe Wastewater Analysis Testing Apparatus

ASTM E1366-23 标准化水生微宇宙的标准实施规程:淡水

1.1 This practice covers procedures for obtaining data concerning toxicity and other effects of a test material to a multi-trophic level freshwater community, independent of the location of the test. 1.2 These procedures also might be useful for studying the fate of test materials and transformation products, although modifications and additional analytical procedures might be necessary. 1.3 Modification of these procedures might be justified by special needs or circumstances. Although using appropriate procedures is more important than following prescribed procedures, results of tests conducted using unusual procedures are not likely to be comparable to results of many other tests. Comparison of results obtained using modified and unmodified versions of these procedures might provide useful information concerning new concepts and procedures for conducting multitrophic level tests. 1.4 This practice is arranged as follows: Section Referenced Documents 2 Terminology 3 Summary of Practice 4 Significance and Use 5 Apparatus 6 Facilities 6.1 Container 6.2 Equipment 6.3 Hazards 7 Microcosm Components 8 Medium 8.1 Medium Preparation 8.2 Sediment 8.3 Microcosm Assembly 8.4 Test Material 9 General 9.1 Stock Solution 9.2 Nutrient Control 9.3 Test Organisms 10 Algae 10.1 Animals 10.2 Specificity of Organisms 10.3 Sources 10.4 Algal Culture Maintenance 10.5 Animal Culture Maintenance 10.6 Procedure 11 Experimental Design 11.1 Inoculation 11.2 Culling 11.3 Addition of Test Material 11.4 Measurements 11.5 Reinoculations 11.6 Analytical Methodology 12 Data Processing 13 Calculations of Variables from Measurements 14 Statistical Analyses 15 Acceptability of Test 16 Interpretation of Results 17 Report 18 Annex Annex A1 Appendices Relationship of Media Appendix X1 Statistical Guidance Appendix X2 1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.Specific hazard statements are given in Section 7. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Practice for Standardized Aquatic Microcosms: Fresh Water

T/AHEPI 0003-2023 医疗机构污水处理设施运行管理技术规范

本文件规定了医疗机构污水处理设施的术语和定义、总体要求、运行维护管理要求、运行维护技术要求、应急管理要求、取样与监测要求、安全、健康、环境等相关要求。 本文件适用于医疗机构污水处理设施的运行维护管理。临时性医疗机构污水处理设施的运行维护管理，可参照本文件执行。

Technical specification for the operation and management of sewage treatment facilities in medical organizations

T/AHEPI 0007-2023 农村生活污水小立方模块化生态处理技术规范

本文件规定了小立方模块化生态处理(以下简称“小立方生态系统”)的术语和定义、总体要求、设计、设备安装、施工和验收、运行与维护的技术要求。 本文件适用于处理规模小于5m3/d的农村生活污水中灰水的处理与资源化利用，其他类似农村生活污水水质处理等可参照此规范使用。

Technical specification for modular ecological treatment of rural domestic sewage with small cube

JB/T 14498-2023 生物质综合利用装备 半纤维素分离装置

Biomass comprehensive utilization equipment—Hemicellulose separation device

JB/T 14510-2023 活性污泥法一体化污水处理装置

Integrated reactor for sewage treatment using activated sludge process

JB/T 14509-2023 反渗透海水淡化设备技术规范

Sea water reverse osmosis desalination device technical specification

JB/T 14500-2023 水系统自洁消毒器

Self-cleaning disinfector for water system

JB/T 14512-2023 水处理微米曝气加药装置

Micron aeration dosing equipment for water treatment

JB/T 14494-2023 粪便消纳站设备 调试及验收规范

Night soil treatment station equipment—Code for commissioning and acceptance

JB/T 14511-2023 生物质综合利用装备 纤维素分离装置

Biomass comprehensive utilization equipment— Cellulose separation device

JB/T 14513-2023 水处理用板框式膜分离装置

Plate and frame membrane separation equipment for water treatment

DB3305/T 264-2023 生活垃圾分类工作评价规范

Standards for Evaluation of Domestic Garbage Sorting Work

ASTM D5886-95(2023) 确定特定应用土工膜流体渗透速率的试验方法选择的标准指南

1.1 This guide covers selecting one or more appropriate test methods to assess the permeability of all candidate geomembranes for a proposed specific application to various permeants. The widely different uses of geomembranes as barriers to the transport and migration of different gases, vapors, and liquids under different service conditions require determinations of permeability by test methods that relate to and simulate the service. Geomembranes are nonporous, homogeneous materials that are permeable in varying degrees to gases, vapors, and liquids on a molecular scale in a three-step process by: (1) dissolution in or absorption by the geomembrane on the upstream side, (2) diffusion through the geomembrane, and (3) desorption on the downstream side of the barrier. 1.2 The rate of transmission of a given chemical species, whether as a single permeant or in mixtures, is driven by its chemical potential or in practical terms by its concentration gradient across the geomembrane. Various methods to assess the permeability of geomembranes to single component permeants, such as individual gases, vapors, and liquids are referenced and briefly described. 1.3 Various test methods for the measurement of permeation and transmission through geomembranes of individual species in complex mixtures such as waste liquids are discussed. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Guide for Selection of Test Methods to Determine Rate of Fluid Permeation Through Geomembranes for Specific Applications