13.080.40 土壤的水文特性 标准查询与下载



共找到 147 条与 土壤的水文特性 相关的标准,共 10

Soil quality - Method for measuring equivalent horizontal hydraulic conductivity and in situ drainage porosity - Guyon method.

ICS
13.080.40
CCS
Z18
发布
1995-08-01
实施
1995-08-05

1.1 This test method covers the determination of elastic moduli of intact rock core specimens in undrained triaxial compression. It specifies the apparatus, instrumentation, and procedures for determining the stress-axial strain and the stress-lateral strain curves, as well as Young''s modulus, E, and Poisson''s ratio, v. Note 1--This test method does not include the procedures necessary to obtain a stress-strain curve beyond the ultimate strength.1.2 For an isotropic material, the relation between the shear and bulk moduli and Young''s modulus and Poisson''s ratio are: Equation 1 - G = E/2(1 + v) Equation 2 - K = E/3(1 - 2v)where: G = shear modulus,K = bulk modulus, E = Young''s modulus, andv = Poisson''s ratio. 1.2.1 The engineering applicability of these equations is decreased if the rock is anisotropic. When possible, it is desirable to conduct tests in the plane of foliation, bedding, etc., and at right angles to it to determine the degree of anisotropy. It is noted that equations developed for isotropic materials may give only approximate calculated results if the difference in elastic moduli in any two directions is greater than 10 % for a given stress level.Note 2--Elastic moduli measured by sonic methods may often be employed as preliminary measures of anisotropy.1.3 This test method given for determining the elastic constants does not apply to rocks that undergo significant inelastic strains during the test, such as potash and salt. The elastic moduli for such rocks should be determined from unload-reload cycles, that is not covered by this test method.1.4 The values stated in SI units are to be regarded as the standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific safety precautions are given in Section 6.

Standard Test Method for Elastic Moduli of Undrained Intact Rock Core Specimens in Triaxial Compression Without Pore Pressure Measurement

ICS
13.080.40
CCS
发布
1995
实施

The standard is Soil quality; determination of dry matter and water content on a mass basis; gravimetric method; technical corrigendum 1

Soil quality; determination of dry matter and water content on a mass basis; gravimetric method; technical corrigendum 1

ICS
13.080.40
CCS
B11
发布
1994-05
实施

This International Standard specifies a method for the determination of the dry matter content and water content of soil samples on a mass basis. This method can be applied to all types of soil sam-ples. Different procedures are specified for air-dried soil samples, for example samples pretreated accord-ing to ISO 11464, and for field-moist soil samples. For the determination of soil water content on a vol-ume basis, refer to ISO 11461.

Soil quality. Chemical methods. Determination of dry matter and water content on a mass basis by a gravimetric method

ICS
13.080.40
CCS
B11
发布
1994-03-15
实施
1994-03-15

The method specified can be applied to all types of soil samples. Different procedures are specified for air-dried soil samples, e.g. samples pretreated according to ISO 11464, and for field-moist soil samples. Its principle is drying soil samples to constant mass at 105 鳦 and using the difference in mass of an amount of soil before and after the drying procedure to calculate the dry matter and water contents on a mass basis. For the determination of soil water content on a volume basis, refer to ISO 11461.

Soil quality; determination of dry matter and water content on a mass basis; gravimetric method

ICS
13.080.40
CCS
P13
发布
1993-12
实施

Soils. Methods of determination of moisture, maximum hygroscopic moisture and moisture of steady plant fading

ICS
13.080.40
CCS
发布
1989
实施
1990-06-01

Настоящий стандарт устанавливает метод определения потенциальной опасности эрозии почв под воздействием дождей с разбивкой по классам и

Nature protection. Soils. Method for determination of potential danger of erosion due to rains

ICS
13.080.40
CCS
发布
1986
实施
1987-07-01



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号