共找到 222 条与 其他防护设备 相关的标准,共 15 页
This specification covers minimum performance criteria and describes test methods for body protectors for use in horse sports and horseback riding. It is not the intention of this specification to bar from consideration materials of improved quality or performance not known at the time of development of this specification. The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
SPECIFICATION FOR BODY PROTECTORS USED IN HORSE SPORTS AND HORSEBACK RIDING
Personal protective equipment against falls from a height - General requirements for instructions for use, maintenance, periodic examination, repair, marking and packaging
A-A-52490A, dated 8 December 1995, has been reviewed and determined to be valid for use in acquisition
BELTS, V: LIGHT-DUTY OR FRACTIONAL-HORSEPOWER
A-A-52422, dated 12 January 1993, has been reviewed and determined to be valid for use in acquisition
BELTS, V: INDUSTRIAL DRIVE, NARROW TYPE
This Publicly Available Specification (PAS) specifies requirements for filled collective fall arrest systems used to absorb kinetic energy of a falling person from a height not exceeding 2 m above the impact surface. NOTE Filled collective fall arrest systems covered by the scope of this PAS are principally for use inside a building during construction, where the cushioning mats will be enclosed by walls or partitions, or externally, where the cushioning mats will be restrained by other means. It includes a test method for dynamic performance and requirements for design, construction, instructions for use and maintenance, warning labels, quality control and conformity marking. It does not include installation requirements. This PAS is applicable to filled collective fall arrest systems intended for installation on a firm surface and not suspended. This PAS is not applicable to personal protective equipment against falls from a height. This PAS is not applicable to containment of falling debris.
Filled collective fall arrest systems
本标准规定了地质灾害危险性评估工作的技术原则;本标准适用于重庆市规划用地地质灾害调查评价、建设工程用地和矿山地质灾害危险性评估,不适用于在建工程和已建工程用地及矿山井下的地质灾害危险性评估。
Regulations on Risk Assessment of Geological Hazards
Specifies the requirements, test methods, marking, information supplied by the manufacturer and packaging for guided type fall arresters including a rigid anchorage line usually attached to or integrated in fixed ladders or rungs adequately adjusted to suitable structures.
Personal protective equipment against falls from a height - Guided type fall arresters including a rigid anchor line
Specifies the requirements, test methods, marking, information supplied by the manufacturer and packaging for energy absorbers.
Personal protective equipment against falls from a height - Energy absorbers
Specifies the requirements, test methods, marking, information supplied by the manufacturer and packaging for guided type fall arresters including a flexible anchor line which can be secured to an upper anchor point.
Personal protective equipment against falls from a height - Guided type fall arresters including a flexible anchor line
Specifies the requirements, test methods, marking, information supplied by the manufacturer and packaging for non-adjustable and adjustable lanyards.
Personal protective equipment against falls from a height - Lanyards
Specifies the terminology and the general requirements for fall arrest systems which serve as personal protective equipment against falls from a height. Also describes examples of how components or assemblies of components may be connected into a fall arrest system, which should enable the purchaser or user to assemble all components in a correct manner and to build up a fall arrest system.
Personal protective equipment against falls from a height - Fall arrest systems
Specifies the requirements, test methods, marking, information supplied by the manufacturer and packaging for retractable type fall arresters.
Personal protective equipment against falls from a height - Retractable type fall arresters
Specifies the requirements, test methods, marking,information supplied by the manufacturer and packaging for full body harnesses.
Personal protective equipment against falls from a height - Full body harnesses
本标准规定了防刺服的术语和定义、要求、试验方法、检验规则和标志、包装、运输及贮存。 本标准适用于防刺服。
Stab resistance of personal body armor
本标准规定了防弹盾牌术语和定义、产品分类、技术要求、试验方法和检验规则、标志、包装、运输和储存。 本标准适用于防弹盾牌。
Ballistic shields
本标准规定了防暴服的术语和定义、产品分类及命名、要求、试验方法、检验规则和标志、包装、运输及贮存等。 本标准适用于防暴服。
Anti-riot suit
本标准规定了防暴盾牌的术语和定义、产品分类与命名、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于防暴盾牌。
Anti-riot shield
Personal protective equipment against falls from a height - Part 2: Guided type fall arresters including a flexible anchor line
Personal protective equipment against falls from a height - Energy absorbers
Personal protective equipment against falls from a height - Part 1: Guided type fall arresters including a rigid anchor line
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号