共找到 2467 条与 化学分析 相关的标准,共 165 页
Guide for the analysis of the printed circuit board surface contamination—Auger electron spectroscopy
Determination of the chemical state of micro-iron in silicate—Auger electron spectroscopy
本标准规定了锅炉用水和冷却水中电导率的测定方法。 本标准适用于锅炉用水、冷却水、除盐水中的电导率在0.055 μS/cm~10 μS/cm(25 ℃)的测定。本标准也适用于天然水及生活用水的电导率的测定。
Analysis of water used in boiler and cooling system.Determination of electrical conductivity
本标准给出了采用XPS对基材上薄膜的分析报告所需的最少信息量要求的说明。这些分析涉及化学组成和均匀薄膜厚度的测量,以及采用变角XPS、XPS溅射深度剖析、峰形分析和可变光子能量XPS的方式对非均匀薄膜作为深度函数的化学组成的测量。
Surface chemical analysis—X-ray photoelectron spectroscopy—Reporting of results of thin-film analysis
本标准规定了锅炉用水和冷却水中硬度的测定方法。 本标准适用于锅炉用水和冷却水硬度的测定。本标准中的铬黑T法测定范围为0.01 mmol/L~5 mmol/L,超过5 mmol/L时,可适当减少取样体积,稀释后测定;酸性铬蓝K法测定范围为1 μmol/L~100 μmol/L;电位滴定法测定范围为0.25 mmol/L~10 mmol/L(均以Ca、Mg为基本单元)。本标准也适用于天然水、冷却水、软化水及锅炉给水硬度的测定。
Analysis of water used in boiler and cooling system.Determination of hardness
本标准规定了工业硼酸中硼酸含量、水不溶物含量、硫酸盐含量、重金属含量、砷含量、杂质元素(钠、铁、钙、镁、铝、二氧化硅)含量、阴离子(氟、氯、溴、硫酸根、硝酸根、磷酸根)含量和硼(B/B)丰度比,工业硼酸、氧化硼和四硼酸二钠中氯化物含量,工业硼酸、氧化硼、四硼酸二钠、过硼酸钠和粗硼酸钠中铁含量的测定方法。 本标准适用于工业硼化物中相应物质含量的测定。
Boron compound for industrial use.Methods of test
本标准规定了工业循环冷却水和锅炉用水中氯离子含量的测定方法。 本标准中摩尔法和电位滴定法适用于天然水、循环冷却水、软化水、锅炉炉水中氯离子含量的测定,摩尔法测定范围为3 mg/L~150 mg/L,超过150 mg/L时,可适当减少取样体积,稀释后测定;电位滴定法测定范围为5 mg/L~1 000 mg/L;共沉淀富集分光光度法适用于除盐水、锅炉给水中氯离子含量的测定,测定范围为10 μg/L~100 μg/L。
Determination of chloride in water for industrial circulating cooling system and boiler
本标准规定了液态水处理剂产品密度测定的通用方法。 本标准适用于液态水处理剂密度的测定。
Water treatment chemicals.General rules for determination of density
本标准规定了利用扫描电子显微镜(SEM)及能谱仪(EDS)观测环境空气中细粒子单颗粒形貌、定性分析元素,对环境空气颗粒物进行分类的方法。扫描电镜用于颗粒物的形貌观察和粒径测量,X射线能谱仪用于颗粒物主要元素定性分析。 本标准适用于在电子束轰击下稳定的颗粒物分析,不适用于硝酸盐、铵盐等热不稳定的颗粒物分析。
Microbeam analysis—Scanning electron microscopy with energy dispersive X-ray spectrometry—Morphology and element analysis of single fine particles in ambient air
本标准规定了使用透射电子显微镜对植物病毒进行形态学观察和鉴定的步骤、质量要求及鉴定报告的发布。 本标准适用于各种类型透射电镜对植物病毒形态的观察和鉴定。
Microbeam analysis—Transmission electron microscopy—Morphological identification method of plant viruses by transmission electron microscopy
本标准规定了利用扫描电镜测量环境空气中石棉等无机纤维状颗粒计数浓度的方法。此方法同时利用X射线能谱分析技术(EDX)分析纤维状颗粒的元素组成,并根据此数据区分石棉纤维、硫酸钙纤维和其他无机纤维。 本标准适用于环境空气中石棉等无机纤维状颗粒计数浓度的测定,也适用于建筑物内空气中石棉等无机纤维状颗粒计数浓度的检测。例如含石棉建筑材料拆除更换后,空气中残留石棉纤维状颗粒浓度的测定。 如果检测时未发现纤维(纤维根数为0),此时其95%置信区间上限为2.99根。如果每平方厘米样品膜上通过1.0 m空气,用扫描电镜分析这张膜上1.0 mm面积,即通过被分析面积膜的空气体积为0.010 m时,检出限大约是300根/m纤维。 滤膜试样上的纤维状颗粒浓度检测范围大约在3根/cm~200根/cm。空气中的浓度值(纤维根数/m)取决于采样体积,可计算得出。
Microbeam analysis—Scanning electron microscopy with energy dispersive X-ray spectrosmetry—Determination of numberical concentration of inorganic fibrous particles in ambient air
本标准规定了通过并行接口或串行接口经由线缆、局域网、广域网络或其他通信线路将扫描探针显微镜(SPM)数据从计算机传输到计算机的格式。传输的数据采用出现在普通计算机显示器或打印机上的那些字符进行编码。 该格式是为SPM的数据设计的,例如扫描隧道显微镜(STM)、原子力显微镜(AFM)和使用在样品表面上扫描的尖锐探针的相关表面分析方法。本格式涵盖了由单通道成像、多通道成像和单点谱得到的数据,在未来版本中可扩展至二维谱成像。
Surface chemical analysis—Data transfer format for scanning probe microscopy
Nanotechnology—Silver nanomaterials—Guidance for the characterization of biological effect-related physicochemical properties
Evaluation of thickness, density and interface width of thin films by X-ray reflectometry—Instrumental requirements, alignment and positioning, data collection, data analysis and reporting
Classification of the mixture gas—Part 3:Flammable classification
Classification of the mixture gas—Part 2:Corrosive classification
General rule for liquid chromatography-mass spectrometry
Determination of impurity fluorine ion in water soluble chemicals—Ion chromatography method
Gas analysis—Contents of certificates for calibration gas mixtures
Gas analysis—General quality assurance aspects in the use of calibration gas mixtures—Guidelines
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号