共找到 425 条与 镁和镁合金 相关的标准,共 29 页
1.1 This specification covers magnesium-alloy die castings. Current alloy compositions are specified under the designations shown in Table 1.2 1.2 The values stated in inch-pound units are standard. The SI values in parentheses are provided for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Magnesium-Alloy Die Castings
Magnesium alloys - Determination of copper - Spectrophotometric method
Magnesium - Determination of copper - Spectrophotometric method
Magnesium and magnesium alloys -- General rules for sampling and analytical methods
Magnesium alloys -- Flammability test method
Magnesium and magnesium alloys - Unalloyed magnesium; German version EN 12421:2017
Magnesium and magnesium alloys. Unalloyed magnesium
Magnesium and magnesium alloys -- Method for spark discharge atomic emission spectrometric analysis
This European Standard specifies the grades and corresponding requirements for cast unalloyed magnesium. This European Standard specifies the chemical composition, designation, testing, marking and inspection documentation.
Magnesium and magnesium alloys - Unalloyed magnesium
3.1 The processes described in this practice clean and provide a paint base for the finishing of magnesium and magnesium alloys. Service conditions will determine, to some degree, the specific process to be applied. 1.1 This practice covers a guide for metal finishers to clean and then provide a paint base for the finishing of magnesium and magnesium alloys using chemical conversion coatings. Where applicable (for example, aerospace) secondary supplementary coatings (for example, surface sealing) can be used (see Appendix X1). 1.2 Although primarily intended as a base for paint, chemical conversion coatings provide varying degrees of surface protection for magnesium parts exposed to indoor atmosphere either in storage or in service under mild exposure conditions. An example is the extensive use of the dichromate treatment (see 5.2) as a final coating for machined surfaces of die cast magnesium components in the computer industry. 1.3 The traditional numbering of the coating is used throughout. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Applying Non-Electrolytic Conversion Coatings on Magnesium and Magnesium Alloys
Magnesium alloy sheets, plates, strips and coiled sheets
Magnesium alloy seamless pipes and tubes
Magnesium alloy sheets, plates, strips and coiled sheets
Evaluation method for cleanliness of magnesium and magnesium alloy ingots
Evaluation method for cleanliness of magnesium and magnesium alloy ingots
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号