77.140.65 钢丝、钢丝绳和环节链 标准查询与下载

T/CISA 174-2021 钢丝球化退火炉技术规范

本文件规定了钢丝球化退火炉产品的技术要求、试验方法、检验规则和技术分级、标志、包装、运输、贮存及订购和供货。?本文件适用于在保护气氛中、额定温度在 500 ℃～950 ℃范围内的钢丝球化退火炉

Technical specification for steel wire spheroidizing annealing furnace

T/CISA 180-2021 打结刀用钢丝

本文件规定了打结刀用钢丝的标记、订货内容、尺寸、外形及允许偏差、技术要求、试验方法、检验规则、数值修约、包装、标志及质量证明书。?本文件适用于打结刀用钢丝

Steel wire for knotting knife

T/CISA 173-2021 钢丝管式电加热炉技术规范

本文件规定了钢丝管式电加热炉的术语和定义、分类与标记、技术要求、试验方法、检验规则、标志、包装、运输、贮存以及订购和供货。?本文件适用于炉内气氛为自然气氛、保护气氛或还原气氛;工作温度在500 ℃～1050 ℃范围内的钢丝管式电加热炉

Technical specifications for steel wire tube electric heating furnace

T/CISA 179-2021 波形弹性垫圈用钢丝

本文件规定了波形弹性垫圈用钢丝的标记、订货内容、尺寸、外形、重量及允许偏差、技术要求、试验方法、检验规则、数值修约、包装、标志及质量证明书。?本文件适用于波形弹性垫圈用钢丝的制造

Steel wire for wave elastic washers

T/CISA 172-2021 文具用钢丝

本文件规定了文具用钢丝的术语和定义、分类和标记、订货内容、尺寸、外形、重量及允许偏差、技术要求、试验方法、检验规则、数值修约、包装、标志及质量证明书。本文件适用于文教用品和书籍装订用钢丝

Steel wire for stationery

T/CISA 176-2021 健身器材用卷簧钢带

本文件规定了健身器材用卷簧钢带的分类和标记、订货内容、尺寸、外形、重量、技术要求、试验方法、检验规则、包装、标志及质量证明书。本文件适用于制造健身器材用卷簧钢带

Coiled spring steel belts for fitness equipment

T/CISA 177-2021 电动机轴用冷拉直条钢丝

本文件规定了电动机轴用冷拉直条钢丝的标记、订货内容、尺寸、外形及允许偏差、技术要求、试验方法、检验规则、数值修约、包装、标志及质量证明书。?本文件适用于电动机轴用冷拉直条钢丝

Cold straightened steel wire for electric motor shaft

T/CISA 178-2021 货架钢丝网用冷拉光亮钢丝

本文件规定了货架钢丝网用冷拉光亮钢丝的标记、订货内容、尺寸、外形、重量及允许偏差、技术要求、试验方法、检验规则、数值修约、包装、标志及质量证明书。?本文件适用于货架钢丝网用冷拉光亮钢丝

Cold-drawn bright steel wire for shelf wire mesh

T/CISA 175-2021 汽车安全带用平面涡卷弹簧疲劳试验方法

本文件规定了汽车安全带用平面涡卷弹簧疲劳试验的术语和定义、试验原理、试样、试验设备、试验程序。?本文件适用于汽车安全带用平面涡卷弹簧的疲劳寿命验证。对于变载荷作用下的其他弹簧产品可参照使用

Fatigue test method for plane scroll springs used in automobile safety belts

T/CISA 159-2021 超高洁净连铸高碳铬轴承钢

本文件规定了超高纯净连铸高碳铬轴承钢的订货内容、尺寸、外形、重量、技术要求、试验方法、检验规则、包装、标志和质量证明书。

Super-clean continuous casting high carbon chromium bearing steel

YB/T 097-2021 伞骨钢丝

Umbrella rib wire

DIN 1653:2021 钢丝的表面光洁度 名称和缩写

This document specifies designations and their abbreviations for the surface finish of steel wires. This standard is applicable to steel wires whose surface finish results from the operations normally used in wire refining. This standard does not apply to steel wires whose surfac

Surface finish of steel wires - Designations and abbreviations thereof

T/XYGTLM 0001-2021 工业筛网用冷拔碳素钢丝

1材料要求 增加了“盘条质量应符合GB/T 4357标准的要求”，工厂供应盘条时实际使用不低于该标准的企业标准。 最低含碳量由0.40%提高到0.42%，与45钢的下限对应。 2 外观和表面质量 排除“裂纹、凹坑、毛刺”缺陷，是因为这类缺陷容易导致钢丝压波时断裂。 3 机械性能 规定的抗拉强度区间较宽，所以增加了“买方可指定更窄的抗拉强度范围，强度范围建议不小于200MPa。”。特殊要求另外协商。 要求断面收缩率是因为低塑性材料不适合筛网生产的压波加工。 4 焊接 焊接点在钢丝压波时易断裂，但相关损失通常较低。由于水箱拉拔找出焊接点难度较大，就对切除焊接点不要求，仅要求其它技术拉拔的产品切除。

Cold-drawn Carbon Steel Wire for pre-Crimped Screen

T/SSEA 0158-2021 预应力混凝土用螺旋肋钢丝

本文件规定了预应力混凝土用螺旋肋钢丝的术语和定义、代号和标记、尺寸、外形、重量、技术要求、试验方法、检验规则、包装、标志和质量证明书、运输和储存。 本文件适用于预应力混凝土用消除应力的低松弛螺旋肋钢丝（以下简称钢丝）。

Spiral rib steel wire for prestressed concrete

21/30439845 DC BS ISO 2232 通用钢丝绳、大直径钢丝绳和矿井提升钢丝绳用圆形非合金钢丝 规格

BS ISO 2232. Round non-alloy steel wires for general purpose wire ropes, large diameter wire ropes and mine hoisting wire ropes. Specifications

KS D 3552-2021 低碳钢丝

Low carbon steel wires

ASTM A555/A555M-21 不锈钢丝和线材的一般要求标准规范

Standard Specification for General Requirements for Stainless Steel Wire and Wire Rods

ASTM B415-16(2021) 硬拉铝包钢丝的标准规范

1.1 This specification covers four conductivities of bare, hard-drawn, round, aluminum-clad steel wire for general use for electrical purposes in sizes 0.2043 to 0.0808 in. incl (4 to 12 AWG) (Note 1). This specification does not apply to wires used as reinforcement in ACSR conductors. (See Specification B502.) NOTE 1—Wire ordered to this specification is not intended for redrawing. If wire is desired for this purpose, the manufacturer shall be consulted. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for Hard-Drawn Aluminum-Clad Steel Wire

KS B 6242-2021 起重用钢丝绳索具

Wire rope slings for lifting purposes

ASTM A974-97(2021) 焊接钢丝网石笼和石笼垫（金属涂层或聚氯乙烯（PVC）涂层）的标准规范

1.1 This specification covers gabions and gabion mattresses produced from metallic-coated welded wire fabric, and metallic-coated wire for spiral binders, lacing wire, and stiffeners used to assemble the product. The metallic-coated fabric may be polyvinyl chloride (PVC) coated after fabrication. The spiral binders, lacing wire, and stiffeners may be PVC coated after metallic coating. Polyvinyl chloride hereinafter will be designated as PVC. 1.2 Welded wire fabric for gabions and gabion mattresses is produced in five styles, based on the kind of coating, as described in Section 4. 1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this specification. 1.5 The following safety hazards caveat pertains only to the test methods portion, Section 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for Welded Wire Fabric Gabions and Gabion Mattresses (Metallic-Coated or Polyvinyl Chloride (PVC) Coated)