E91 石油物探测井设备与仪器 标准查询与下载

SY/T 5182-1987 绕焊不锈钢筛管

Welded stainless steel screen

ASTM D4178-82(2012) 湿度分析仪校准的标准实施规程

This practice is intended to provide a method to calibrate moisture analyzers used on-stream or in the laboratory.1.1 This practice covers a calibration technique based on the preparation of standards of known water content. This technique is applicable to the production of standards between 20 and 2000 cm3/m3 water. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Calibrating Moisture Analyzers

AIR FORCE MIL-J-7448 K-1979 L-2B应用程序保护罩

This specification covers one type of utility Jacket desißnated type G2B and furnished in the following sizes (see 6.2)

JACKET, UTILITY L-2B

ARMY MIL-HDBK-H109-1960 用于决定承制厂属性检查有效性的统计程序

Computer Instruction Performance Rate. Within its operating environment, each processing unit shall perform instructions at a rate which is at least twice that required by all other requirements specified. This increased capability is to allow for contingency growth in peak real time functionalcapability beyond the specific requireme

STATISTICAL PROCEDURES FOR DETERMINING VALIDITY OF SUPPLIERS' ATTRIBUTES INSPECTION

ARMY MIL-HDBK-109-1960 用于决定承制厂属性检查有效性的统计程序

The purpose of this handlook is CO provide approprlate statistical tests and tables of critical values to Department of Defense procurement inspection and quality control activities for use in determining the validity of suppliers' inspection records when sampling inspection by attributes is specified. Such records serve to assure the consumer that only supplies conforming with technical requirements are being offered for accept ince.

STATISTICAL PROCEDURES FOR DETERMINING VALIDITY OF SUPPLIERS' ATTRIBUTES INSPECTION

SY/T 6323-1997 中子测井仪刻度

本标准确立了中子孔隙度测井刻度体系，规定了各级刻度装置的技术性能、要求及检定间隔，确定了各级刻度装置的功能、传递与比对方法。 本标准适用于中子孔隙度测井工作标准装置、刻度器、检定器及中子测井仪的性能评价。

Neutron logging tool calibration

JJG(石油) 29-1992 钻井液切力计

Drilling Fluid Shear Meter

JJG(石油) 38-1994 钻头规

drill gauge