共找到 840 条与 机床综合 相关的标准,共 56 页
Machine tools — Test conditions for surface grinding machines with vertical grinding wheel spindle and reciprocating table — Testing of the accuracy
Machine-tools safety -- Safety requirements for the design and construction of work holding chucks
Safety of machinery — Electrical equipment of machines — Part 1: General requirements
This part of ISO 13041 specifies, with references to ISO 230-1 and ISO 230-4, certain kinematic tests for numerically controlled (NC) turning machines and turning centres, concerning the spindle speeds, the feed speeds of the individual NC linear axes, and the accuracy of the paths described by the simultaneous movement of two or more NC linear and/or rotary axes. NOTE This part of ISO 13041 applies to numerically-controlled turning machines and turning centres with horizontal, vertical, and inverted vertical type workholding spindle(s).
Test conditions for numerically controlled turning machines and turning centres - Part 5: Accuracy of speeds and interpolations
La présente partie de l'ISO 10791 spécifie, par référence à l'ISO 230-1 et à l'ISO 230-4, des essais cinématiques fiables pour centres d'usinage, concernant les vitesses de broche, l'avance et l'exactitude des trajectoires décrites par le mouvement simultané de deux axes ou plus, linéaires et/ou rotatifs à commande numérique.
Test conditions for machining centres - Part 6 : accuracy of speeds and interpolations
Test conditions for machining centres Part 1 : Geometric tests for machines with horizontal spindle (horizontal Z - axis)
Test conditions for machining centres. Accuracy of speeds and interpolations
Machine tools. Safety. Turning machines
Test code for machine tools. Part 4. Circular tests for numerically controlled machine tools
Machine tool spindles. Evaluation of machine tool spindle vibrations by measurements on spindle housing. Spindles with rolling element bearings and integral drives operating at speeds between 600 min
Test conditions for machining centres. Accuracy of finished test pieces
Test code for machine tools-Part 2 : Determination of accuracy and repeatability of positioning numerically controlled axes
Numerically controlled routing machines — Test methods for performance and accuracy
Safety standards for construction of single surface planers
Safety standards for construction of rip saw and gang rip saw
Band dryer — Test and inspection methods
Electromagnetic multiple disc clutches(wet type)
Oil hydraulic multiple disc clutches(wet type)
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号