L26 波导同轴元件及附件 标准查询与下载

IEC PAS 61338-1-5:2010 波导型电介质谐振器.第1-5部分:基本资料和试验条件.微波频率下导体层和电介质基片间接口传导性测量方法

Microwave circuits are popularly formed on multi-layered organic or non-organic substrates. In the microwave circuits, the attenuation of planar transmission lines such as striplines, microstrip lines, and coplanar lines are determined by their conductor loss, dielectric loss and radiation loss. Among them, the conductor loss is a major factor in the attenuation of the planar transmission lines. A new measurement method is needed to evaluate the conductivity of transmission line on or in the substrates such as the organic, ceramic and LTCC (low temperature co-fired ceramics) substrates.

Waveguide type dielectric resonators - Part 1-5: General information and test conditions - Measurement method of conductivity at interface between conductor layer and dielectric substrate at microwave frequency

GJB 1510A-2009 软波导组件通用规范

本规范规定了可扭和不可扭软波导组件的通用要求、质量保证规定和交货准备等。 本规范适用于可扭和不可扭软波导组件(以下简称组件)。

Waveguide assemblies,fexible,general specification for

BS EN 62431:2008 毫米波频中电磁波吸收器的反射率.测量方法

Reflectivity of electromagnetic wave absorbers in millimetre wave frequency - Measurement methods

KS C IEC 60153-3:2008 空心金属波导.第3部分:扁矩形波导的有关规范

Hollow metallic waveguides-Part 3:Relevant specifications for flat rectangular waveguides

KS C IEC 61580-7:2008 波导测量方法.第7部分:图解法测定波导管性能

이 표준은 도파관의 성능에 적용된다.1 GHz에서 27 GHz까지의 주파수 범위에 걸친

Methods of measurement for waveguides－Part 7：Graphical method for the determination of waveguide performance

KS C IEC 60966-4:2008 射频同轴电缆组件.第4部分:半硬性同轴电缆组件分规范

이 표준은 TEM 모드(transverse electromagnetic mode)에서 작동

Radio frequency and coaxial cable assemblies-Part 4:Sectional specification for semi-rigid coaxial cable assemblies

KS C IEC 61580-4:2008 波导测量方法.第4部分:波导和波导组件的衰减

이 표준은 도파관과 도파관 부속품의 감쇠량에 적용되는 표준이다. 아래에서 설명하는 시험 절

Methods of measurement for waveguides－Part 4：Attenuation of waveguide and waveguide assemblies

IEC 62431:2008 毫米波频中电磁波吸收器的反射率.测量方法

This International Standard specifies the measurement methods for the reflectivity of electromagnetic wave absorbers (EMA) for the normal incident, oblique incident and each polarized wave in the millimetre-wave range. In addition, these methods are also equally effective for the reflectivity measurement of other materials: - measurement frequency range: 30 GHz to 300 GHz; - reflectivity: 0 dB to-50 dB; - incident angle: 0~ to 80~. NOTE This standard is applicable not only to those EMA which are widely used as counter-measures against communication faults, radio interference etc., but also to those used in an anechoic chamber in some cases. EMAs may be any kind of material, and may have any arbitrary shape, configuration, or layered structure as pointed out below. Material: Conductive material, dielectric material, magnetic material. Shape: planar-, pyramidal-, wedge-type, or other specific shapes. Layer structure: single layer, multi layers, or graded-index material.

Reflectivity of electromagnetic wave absorbers in millimetre wave frequency - Measurement methods

KS C IEC 60154-4:2007 波导法兰盘.第4部分:圆波导法兰盘的有关规范

Flanges for waveguides-Part 4:Relevant specifications for flanges for circular waveguides

KS C IEC 60153-1:2007 空心金属波导.第1部分:通用要求和测量方法

이 규격은 전자기기 도파관용 중공 금속 직관을 규정한다.

Hollow metallic waveguides-Part 1:General requirements and measuring methods

KS C IEC 60154-7:2007 波导法兰盘.第7部分:方波导法兰盘的有关规范

Flanges for waveguides-Part 7:Relevant specifications for flanges for square waveguides

KS C IEC 60153-2:2007 空心金属波导.第2部分:普通矩形波导的有关规范

Hollow metallic waveguides-Part 2:Relevant specifications for ordinary rectangular waveguides

KS C IEC 60154-3:2007 波导法兰盘.第3部分:扁矩形波导法兰盘的有关规范

Flanges for waveguides-Part 3:Relevant specifications for flanges for flat rectangular waveguides

KS C IEC 60154-2:2007 波导法兰盘.第2部分:普通矩形波导法兰盘的有关规范

Flanges for waveguides-Part 2:Relevant specifications for flanges for ordinary rectangular waveguides

KS C IEC 60154-6:2007 波导法兰盘.第6部分:中等扁矩形波导法兰盘的有关规范

Flanges for waveguides-Part 6:Relevant specifications for flanges for medium flat rectangular waveguides

IEEE 287-2007 精密同轴连接器(直流110GHz)

This standard specifies coaxial connectors for precision electrical measurements to 110 GHz. It presents minimum performance requirements to standardize both hermaphroditic and pin and socket type connectors. It provides recommended electrical and mechanical test procedures for general and laboratory precision connectors.

Precision Coaxial Connectors (DC to 110 GHz)

DIN EN 61338-1-4 Berichtigung 1:2007 波导介电谐振器.第1-4部分:一般信息和试验条件.毫米波频率时介电谐振器材料的相对复介电常数测量方法

This corrigendum adds annex ZA

Waveguide type dielectric resonators - Part 1-4: General information and test conditions - Measurement method of complex relative permittivity for dielectric resonator materials at millimetre-wave frequency (IEC 61338-1-4:2005); German version EN 61338-1-

SJ 51425/2-2006 BFU32- IC 型波导假负载详细规范

本规范规定了BFU32- IC 型波导假负载（以下简称假负载）的详细要求。 本规范适用于BFU32- IC 型波导假负载。

Dummy load, electrical, waveguide, type BFU32- IC detail specification for

SJ 51425/1-2006 BFU84- IC 型波导假负载详细规范

本规范规定了BFU84- IC 型波导假负载（以下简称假负载）的详细要求。 本规范适用于BFU84- IC 型波导假负载。

Dummy load, electrical, waveguide, type BFU84- IC detail specification for

IEC 61580:1995/COR1:2006 波导和波导组件回波损耗的测量.勘误1

This standard is about Measurement of return loss on waveguide and waveguide assemblies - Corrigendum 1

Measurement of return loss on waveguide and waveguide assemblies - Corrigendum 1