M42 通信线路设备 标准查询与下载

YD/T 2402.2-2012 接入网技术要求 10Gbit/s无源光网络（XG-PON） 第2部分：物理层要求

本部分规定了10Gbit/s无源光网络(以下简称XG-PON)系统的物理媒质相关(PMD)层要求、ONU的X/S容忍度及上行物理层开销。本部分规定的XG-PON系统主要针对XG-PON1。本部分适用于公众电信网环境下的XG-PON设备,专用电信网也可参照使用。

Technical requirements for access network.10-Gigabit-capable passive optical networks (XG-PON).Part 2:Physical media dependent (PMD) layer requirements

ITU-T J.381-2012 高级电缆传输技术要求.9号研究组

Among the three options described in the introduction, this Recommendation limits the scope to the employed technologies to improve spectral efficiency for downstream and upstream over hybrid fibre/coax (HFC)-based networks. The requirements stated herein are intended to be technology neutral. Furthermore, this Recommendation defines the requirements for advanced digital cable transmission technologies on the physical layer, which includes modulation, channel coding, transmission schemes and frame structure for providing higher spectral efficiency.

Requirements for advanced digital cable transmission technologies (Study Group 9)

ITU-T G.996.2 AMD 2-2012 数字用户线路(DSL)的单端线路测试.修改件2.15号研究组

Amendment 2 to Recommendation ITU-T G.996.2 (2009) provides updates to Annexes E and F, defining revised new measurement parameters for a MELT-PMD and a MELT-P.

Single-ended line testing for digital subscriber lines (DSL) Amendment 2 (Study Group 15)

ANSI/ICEA S-106-703-2012 宽频段天线引入线ICEA标准

This Standard covers materials, mechanical, and electrical requirements for Broad band Aerial Service Wire (BB-ASW) of less than or equal to 12 pair, intended for use principally in extending a circuit from a broadband distribution cable terminal to a subscriber's network interface device (NID).

ICEA Standard for Broadband Aerial Service Wire

ANSI/ICEA S-107-704-2012 宽频段埋入式引入线ICEA标准

This standard covers materials, mechanical, and electrical requirements for Broadband Buried Service Wire (BB-BSW) or less than or equal to 6 pair, intended for use principally in extending a circuit from a broadband cable terminal to a subscriber's network interface device (NID).

ICEA Standard for Broadband Buried Service Wire

ITU-T G.9902-2012 ITU-T G.hnem网络用窄带正交频分复用电力线通信收发器.15号研究组

Recommendation ITU-T G.9902 contains the physical layer (PHY) and the data link layer (DLL) specifications for the ITU-T G.9902 narrowband orthogonal frequency division multiplexing (OFDM) power line communication transceivers operating over alternating current and direct current electric power lines over frequencies below 500 kHz. This Recommendation supports indoor and outdoor communications over low voltage-lines, medium-voltage lines, through transformer low-voltage to medium-voltage and through transformer medium-voltage to low- voltage power lines in both urban and long-distance rural communications. This Recommendation addresses grid to utility meter applications, advanced metering infrastructure (AMI) and other 'Smart Grid' applications such as the charging of electric vehicles, home automation and home area network (HAN) communications scenarios. This Recommendation does not contain the control parameters that determine spectral content, power spectral density (PSD) mask requirements and the set of tools to support a reduction of the transmit PSD; all of which are detailed in [ITU-T G.9901].

Narrowband orthogonal frequency division multiplexing power line communication transceivers for ITU-T G.hnem networks (Study Group 15)

ITU-T G.997.1 AMD 1-2012 数字用户线路(DSL)收发器的物理层管理.修改件1.15号研究组

Amendment 1 to Recommendation ITU-T G.997.1 (2012) contains the following additions andchanges:Additional parameter for the reporting of the actually used AELE method;Changes for the control of the INP of ROC;Add support for changes to PSD masks of ITU-T G.993.2 Annex B;Add line status parameters for ITU-T G.993.5.

Physical layer management for digital subscriber line (DSL) transceivers Amendment 1 (Study Group 15)

ITU-T G.9904-2012 电力线智能计量演化(PRIME)网络用窄带正交频分复用电力线通信收发器.15号研究组

Recommendation ITU-T G.9904 contains the physical layer (PHY) and data link layer (DLL) specification for PRIME narrowband orthogonal frequency division multiplexing (OFDM) power line communication transceivers for communications via alternating current and direct current electric power lines over frequencies below 500 kHz. This Recommendation supports indoor and outdoor communications over low-voltage lines, medium-voltage lines, through transformer low- voltage to medium-voltage and through transformer medium-voltage to low-voltage power lines in both urban and in long distance rural communications. This Recommendation addresses grid to utility meter applications, advanced metering infrastructure (AMI), and other 'Smart Grid' applications such as the charging of electric vehicles, home automation and home area networking (HAN) communications scenarios. This Recommendation removes the control parameters that determine spectral content, power spectral density (PSD) mask requirements, and the set of tools to support reduction of the transmit PSD, all of which have been moved to Recommendation ITU-T G.9901.

Narrowband orthogonal frequency division multiplexing power line communication transceivers for PRIME networks (Study Group 15)

YD/T 2338-2011 通信电缆.无线通信用50Ω泡沫聚乙烯绝缘、铜包铝管内导体、皱纹铜管外导体射频同轴电缆

本标准规定了无线通信用50Ω泡沫聚乙烯绝缘、铜包铝管内导体、皱纹铜管外导体射频同轴电缆（以下简称电缆）的要求、试验方法、检验规则、标志、包装、运输和贮存等。 本标准适用于连接无线通信设备至天线及射频电子设备之间，工作频率范围在150MHz～2500MHz的无线通信用50Ω泡沫聚乙烯绝缘、铜包铝管内导体、皱纹铜管外导体射频同轴电缆。

Telecommunication cable.foamed polyethylene dielectric,copper-clad aluminum tube inner conductor,corrugated copper tube outer conductor,50 ohm radio frequency coaxial cable,for wireless communications

YD/T 2337-2011 通信电源用光伏电缆

本标准规定了太阳能通信电源用光伏电缆的要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于连接太阳能通信电源光伏组件之间、电池陈列之间及陈列于光伏逆变器直流端之间直流额定电压为1.8kV、交流额定电压U/U为0.6/1 kV的电缆。

Photovoltaic cables for electric powers in communication system

ITU-T SERIES G SUPP 50-2011 (预发布)数字用户线路(DSL)的推荐性规范综述

This Supplement provides an overview of the family of DSL Recommendations. It describes how the various DSL Recommendations are related. This Supplement also defines a generic system reference and a protocol reference configuration for DSL Recommendations and relates it to the system reference models of the DSL Recommendations. This Supplement is of informative nature and does not imply any specific requirements.

(Pre-Published) Overview of digital subscriber line (DSL) Recommendations

ETSI TR 101 562-1-2011 电力线通信(PLT).MIMO PLT.第1部分:通用连接器的操作说明.描述(版本1.2.1)

PowerLine Telecommunications (PLT); MIMO PLT; Part 1: Universal Coupler, Operating Instructions - Description V1.2.1

YD/T 814.5-2011 光缆接头盒 第5部分：深海光缆接头盒

本部分规定了深海光缆接头盒的术语和定义、型号、要求、试验方法、检验规则及标志、包装、运输和贮存。 本部分适用于工作水深不超过8000m的两条深海光缆之间接续或转换用直通式接头盒。本部分不适用于柔性接头和分歧接头盒。

Closure for optical cable.Part 5:Closure for deep water submarine optical fibre cables

ITU-T K.72-2011 (预发布)使用金属导体防雷电风险管理的通信线路保护

This Recommendation deals with the risk management of lightning protection of telecommunication networks using cables with metallic conductors. The risk assessment is limited to physical damage and failure of insulation of telecommunication lines (buried or aerial cables, shielded or unshielded cables) which can cause the loss of service. This Recommendation provides a procedure for the evaluation of such a risk. Once an upper tolerable limit for the risk has been selected, this procedure allows the selection of appropriate protection measures to be adopted to reduce the risk to a level at or below the tolerable limit. This Recommendation shall be used together with [ITU-T K.47], which provides the risk assessment and the protection measures against lightning flashes to the telecommunication line and to connected structures, and [ITU-T K.46], which provides the risk assessment and the protection measures against lightning flashes near the telecommunication line. The protection need for line equipment (such as multiplexers, power amplifiers, optical network units) and line termination equipment is not considered in this Recommendation and it should be evaluated using the risk assessment applied to the structure where the equipment is located (i.e., exchange, customer's building, or remote electronic site). The protection of persons using telecommunication equipment inside the customer's structure, from dangerous situations caused by touch voltages is outside the scope of this Recommendation and it should be evaluated using the risk assessment applied to the customer's structure.

(Pre-Published) Protection of telecommunication lines using metallic conductors against lightning Risk management

YD/T 2275-2011 接入网技术要求.宽带用户接入线路（端口）标识

本标准规定了IPv4和IPv6环境下的DSL、PON、LAN等宽带接入网中用户接入线路（端口）标识的实现方法，并规定了DSLAM、PON设备、以太网交换机、BRAS/SR设备或DHCP服务器等网络设备通过PPPoE中继代理、DHCP/DHCPv6中继代理等方式向宽带后台管理系统（RADIUS服务器）上报用户接入线路（端口）标识的编码格式。 本标准适用于公用电信网络环境下采用PPPoE或者DHCP认证方式时涉及到的宽带接入设备（ADSL/ADSL2+、VDSL2、EPON/10G-EPON、GPON/XG-PON、LAN接入设备）、BRAS/SR、DHCP服务器和AAA系统。

Technical requirements for access network.Subscriber access loop (port) identification in broadband access networks

YD/T 2282-2011 通信设备用3GHz及以下频段对称电缆技术条件

本标准规定了通信设备用3GHz及以下频段对称电缆的要求、试验方法、检验规则、标志和包装等要求。 本标准适用于工作频率在3GHz及以下的通信设备模块间和设备之间的高速互连对称电缆。

Technical requirements for symmetrical cables at and below 3GHz used in telecommunication equipment

YD/T 2276-2011 接入网技术要求 EPON/GPON系统承载TDM业务

本标准规定了EPON/GPON系统承载TDM业务的参考模型、协议、接口、功能、性能和网络管理等的技术要求。 本标准适用于公众电信网环境下承载E1、n×64Kb/s类型的TDM业务，且应用场景为ONU发起、OLT终结TDM电路仿真的EPON/GPON系统。ONU发起、OLT透传TDM电路仿真，ONU透传、OLT终结TDM电路仿真，ONU、OLT均透传TDM电路仿真和GPON ONU发起Native TDM、OLT做Native TDM到CES的转换4种应用场景也可参照使用。

Technical requirements for access network EPON/GPON systems bearing TDM service

YD/T 2285-2011 同轴电缆接头接地保护盒

本标准规定了同轴电缆接头接地保护盒的产品分类、要求、试验方法，以及检验规则、标志、包装、运输和贮存。 本标准适用于同轴电缆接头接地保护盒。

Protection closure for coaxial cable joints and earthing

YD/T 2320-2011 通信用铜包铝电源线

本标准规定了交流额定电压600/1000V及以下通信用铜包铝电源线的分类与命名、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于通信局（站）、建筑物等电源输、配电系统中的通信用铜包铝电源线。

Copper clad aluminum power wires for communications

YD/T 1949.4-2011 接入网技术要求——吉比特的无源光网络（GPON） 第4部分：ONT管理控制接口（OMCI）要求

本部分规定了吉比特无源光网络(GPON)系统的ONT管理控制接口(OMCI)、OMCI协议无关MIB、ONT管理控制信道(OMCC)和管理控制协议,以及OMCI消息集。本部分适用于公众电信网环境下的GPON设备,专用电信网也可参照使用。

Technical requirements for access network.Gigabit-capable passive optical network (GPON).Part4: ONT management and control interface requirements