M42 通信线路设备 标准查询与下载

TIA-1039-2006 IP QoS支持的QoS信令

TIA Engineering Standards and Publications are designed to serve the public interest through eliminating misunderstandings between manufacturers and purchasers, facilitating interchangeability and improvement of products, and assisting the purchaser in e

QoS Signaling for IP QoS Support

YD/T 1429-2006 通信局(站)在用防雷系统的技术要求和检测方法

本标准规定了通信局(站)防雷系统的定义、分类、检验规则、检测项目、技术要求和测试方法、检测周期、检测程序和检测数据整理。 本标准适用于各类通信局(站)防雷系统现场检测与评定。

Performance requirements and Testing Methods for Lightning Protection system of Running Telecommunication Stations/Sites

TIA-945-2006 MAP对认证和密钥协商协议(AKA)的支持

TIA Engineering Standards and Publications are designed to serve the public interest through eliminatingmisunderstandings between manufacturers and purchasers, facilitating interchangeability and improvement ofproducts, and assisting the purchaser in sele

MAP Support of Authentication and Key Agreement (AKA) (Contains Color)

ITU-R INFORME SA.2065 SPANISH-2006 空间甚长底线干涉量度法(VLBI)遥测链路的保护

Very long baseline interferometry (VLBI) is used to achieve very high resolution of observed radio sources. VLBI has many scientific and engineering uses, from observing extragalactic radio sources to navigating and tracking of spacecraft [Thompson et al., 2001].

Protection of the space VLBI telemetry link

ANSI/TIA-1096-2006 电话终端设备TIA.与电话网络相连的终端设备的连接的连接器要求

The technical criteria in this standard are intended to protect the telephone network from the harms defined by the Federal Communications Commission (FCC) Part 68, Section 3 rules in Title 47 of the Code of Federal Regulations (47 CFR 68.3).

Telephone Terminal Equipment TIA - Connector Requirements for Connection of Terminal Equipment to the Telephone Network

ANSI/ATIS 0600401-2006 网络和用户装置间的接口.用于循环启动和接地启动信令的模拟音频转换访问线路

This standard provides the signaling requirements associated with analog voicegrade switched access lines that use loop-start and ground-start signaling. In this standard, the public switched network is referred to as the Network and the customer premises cabling and equipment is referred to as the Customer Installation (CI).

Network to Customer Installation Interface - Analog Voicegrade Switched Access Lines Using Loop-Start and Ground-Start Signaling

YD/T 1384-2005 住宅通信综合布线系统

本标准规定了住宅套内和住宅小区的语音、电视及数据通信（以下简称通信）布线等级、布线结构、布线元件和布线系统的安装及性能要求等。 本标准适用于住宅建筑物内及住宅建筑物间的通信布线，包括住宅套内布线和主干布线。本标准规定的布线系统支持住宅用户的多种通信应用。

Residential telecommunications generic cabling system

YD/T 1380.2-2005 V5接口技术要求 第2部分：V5.2接口

本部分规定了本地交换机（LE）和接入网（AN）之间用于V5.2接口的电气、物理、规程及协议要求。 本部分适用于交换机设备和接入网设备。

Technical requirements of V5 interface Part 2:V5.2 interface

YD/T 1380.1-2005 V5接口技术要求 第1部分：V5.1接口

本部分规定了本地交换机（LE）和接入网（AN）之间用于V5.1接口的电气、物理、规程及协议要求。 本部分适用于交换机设备和接入网设备。

Technical requirements of V5 interface Part 1:V5.1 interface

ITU-T D.4 SPANISH-2005 关于国际(欧洲和洲际)声音和电视节目电路租赁的专用业务的特殊条件.3号研究组

This Recommendation details the provisions applicable to leased international (continental and intercontinental) sound- and television-programme circuits and associated control circuits for private service. The provisions of this Recommendation should be applied in conjunction with ITU-T Rec. D.1, except where specifically stated otherwise.

Special conditions for the lease of international (continental and intercontinental) sound- and television-programme circuits for private service Study Group 3

ITU-T D.4 FRENCH-2005 关于国际(欧洲和洲际)声音和电视节目电路租赁的专用业务的特殊条件.3号研究组

This Recommendation details the provisions applicable to leased international (continental and intercontinental) sound- and television-programme circuits and associated control circuits for private service. The provisions of this Recommendation should be applied in conjunction with ITU-T Rec. D.1, except where specifically stated otherwise.

Special conditions for the lease of international (continental and intercontinental) sound- and television-programme circuits for private service Study Group 3

ITU-T T.38-2005 通过IP网络进行实时3类传真通信的规程研究组16

Procedures for real-time Group 3 facsimile communication over IP networks Study Group 16

Procedures for real-time Group 3 facsimile communication over IP networks Study Group 16

TIA TSB-141-2005 极化相关损耗:通信中的测量和应用问题

TIA Engineering Standards and Publications are designed to serve the public interest through eliminating misunderstandings between manufacturers and purchasers, facilitating interchangeability and improvement of products, and assisting the purchaser in s

Polarization Dependent Loss: Measurement and Application Issues in Telecommunications Contains Color

YD/T 590.1-2005 通信电缆塑料护套接续套管 第一部分:通用技术条件

本部分规定了通信电缆塑料护套接续套管的型式、规格、通用要求、试验方法、检验规则，以及标志、包装、运输和贮存。 本部分适用于通信电缆塑料护套接续用接续套管。其他用途的电缆附件也可参照使用。

Plastic jacket joint closure for telecommunication cable Part 1:General specification

YD/T 814.3-2005 光缆接头盒 第三部分:浅海光缆接头盒

YD/T 814的本部分规定了浅海光缆接头盒(以下简称接头盒)的术语和定义、分类和命名、要求、试验方法、检验规则及标志、包装、运输、贮存和安装。 本部分适用于海底光纤通信线路中浅海光缆之间的接续和维修用接头盒。

Closure for optical fiber cables Part 3:Closure for shallow water submarine optical fiber cables

YD/T 814.2-2005 光缆接头盒 第二部分:光纤复合架空地线接头盒

YD/T 814的本部分规定了光纤复合架空地线(OPGW)光缆接头盒(以下简称接头盒)的产品分类、型号、结构、组成、技术要求、试验方法、检验规则和标志、包装、运输、贮存和安装等要求。 本部分适用于架空电力通信线路中OPGW用接头盒。

Closure for optical fibre cables Part 2:Closure for optical fibre composite overhead ground wires

YD/T 590.2-2005 通信电缆塑料护套接续套管 第二部分:热缩套管

本部分规定了通信电缆塑料护套接续用热缩套管的型式、规格、要求、试验方法、检验规则，以及标志、包装、运输和贮存。 本部分适用于架空、管道、直埋、隧道敷设的通信电缆塑料护套接续用热缩套管。

Plastic jacket joint closure for telecommunication cable Part 2:Heat shrinkable joint closure

YD/T 590.5-2005 通信电缆塑料护套接续套管 第五部分:通气式装配套管

本部分规定了通信电缆塑料护套接续用通气式装配套管的型式、规格、要求、试验方法、检验规则，以及标志、包装、运输和贮存。 本部分适用于架空敷设和建筑物内通信电缆塑料护套接续用通气式装配套管，该产品不密封、不具有防潮性能。

Plastic jacket joint closure for telecommunication cable Part 5:Aeriferous assembly joint closure

YD/T 590.4-2005 通信电缆塑料护套接续套管 第四部分:装配套管

本部分规定了通信电缆塑料护套接续用装配套管的型式、规格、要求、试验方法、检验规则，以及标志、包装、运输和贮存。 本部分适用于架空、管道、直埋、隧道敷设的通信电缆塑料护套接续用装配套管。

Plastic jacket joint closure for telecommunication cable Part 4:Assembly joint closure

YD/T 590.3-2005 通信电缆塑料护套接续套管 第三部分:注塑熔接套管

本部分规定了通信电缆塑料护套接续用注塑熔接套管的型式、规格、要求、试验方法、检验规则，以及标志、包装、运输和贮存。 本部分适用于空气维护的架空、管道、直埋、隧道敷设通信电缆塑料护套接续用注塑熔接套管。

Plastic jacket joint closure for telecommunication cable Part 3:Plastic injection joint closure