P30 工业与民用建筑工程综合 标准查询与下载

DB42/ 321-2005 新建与改建车用乙醇汽油加油站设计施工规范

Regulations of Technical Examination for the Design and Construction/Reconstruction of Ethanol Gasoline Filling Stations

BS EN 1462:2005 檐沟撑架.要求和检验

Specifies both eaves and rafter brackets for use with gutters, manufactured to EN 607 and EN 612. However, roll fronted (bead, stiffened) metal gutters of the type specified in EN 612 are not, generally used in the UK and stronger brackets than those specified in EN 1462 are required for use with the heavier UK metal gutters.

Brackets for eaves gutters - Requirements and testing

CECS 182-2005 智能建筑工程检测规程

本规程适用于对建筑或建筑群的通信网络系统、信息网络系统、建筑设备监控系统、火灾自动报警和消防联动系统、安全防范系统、综合布线系统、智能化系统集成、电源与接地、环境和住宅(小区)智能化等的功能、性能和安装质量的最终检测。本规程亦适用于智能建筑工程实施和质量控制全过程的质量检验和自检。

Specification for checking and measuring of intelligent building

DIN 4149:2005-04 德国地震区建筑物.建筑物设计载荷、分析和结构设计

(1) This standard deals with the planning, structural design and detailing of conventional buildings made from reinforced concrete, steel, timber or masonry in German earthquake zones. The purpose of the standard is to save human lives, to limit damage and to ensure that structures of importance for public safety as well as infrastructure remain in working order in the event of an earthquake. (2) This standard does not apply to structures and parts of such (e.g. nuclear power plants, chemical plants etc.) which may present additional potential hazards in the event of an earthquake. (3) This standard does not generally substitute the general rules to be observed when designing and planning structures, but provides supplementary rules that are applicable in earthquake zones. (4) Those parts of Germany which, within the scope of this standard, are more liable to be affected by earthquakes are grouped into earthquake zones 1 to 3 (see Figure 2). The extent of hazards due to earthquakes (seismicity) in areas outside of earthquake zones 1 to 3 can be assumed to be so Iow that this standard need not be applied in such areas.

Buildings in german earthquake areas - Design loads, analysis and structural design of buildings

ASHRAE 4784-2005 在2005年ASHRAE手册-基本RP-1273中气候条件计算设计

The Calculation of Climatic Design Conditions in the 2005 ASHRAE Handbook - Fundamentals RP-1273

The Calculation of Climatic Design Conditions in the 2005 ASHRAE Handbook - Fundamentals RP-1273

KS F ISO 11925-2:2004 建筑材料的不燃性试验方法.单一火源直接燃烧

이 규격은 수직 방향으로 시험체를 설치하여 빛이 없는 조건에서 단일 발화원에 직접 접염

Method of ignitability test method of building products subjected to direct impingement of flame of single flame source

KS F ISO 1182:2004 建筑材料不可燃性试验

이 규격은 건축물의 균질의 건축 재료와 실제 구성재인 불균질의 건축 재료의 불연 성능을

Method of non-combustibility test of building products

KS F ISO 13640:2004 建筑物建造.接缝产品.试验衬底规范

이 규격은 실링재 시험을 위한 모르타르, 유리, 산화 처리된 알루미늄 피착체의 제작 방

Specifications for test substrates for sealing and glazing in building

KS F ISO 13638:2004 房屋建筑.密封胶.耐长期浸泡的试验方法

이 규격은 장시간 물 속에 침지시킨 후 실링재의 신축 변화에 대한 저항성을 평가하는 시

Determination of resistance to prolonged exposure to water for sealing and glazing in building

ANSI FM4474-2004 用静态正和/或负差压评价屋顶组件耐模拟风吹起的试验标准

Presents a test method for determining and categorizing wind uplift resistance of roof assemblies including the structural deck. The objective of this test is to evaluate the comparative resistance of roof assemblies to positive and/or positive and negative pressures. The test evaluates the deck and roof covers including all components for their method of attachment to each other and to their supports.

Test Standard for Evaluating the Simulated Wind Uplift Resistance of Roof Assemblies Using Static Positive and/or Negative Differential Pressures

CSA S304.1-04-2004 建筑泥水工程的设计(限定状态设计)

Design of masonry structures Second Edition

Design of masonry structures Second Edition

ANSI Z765-2003 单元式居住房屋.方形尺码.计算方法

The changes that are the subject of this public review are substantive changes to the body of the standard that resulted from the 1st public review. These substantive changes provide for another calculation method that allows measurement of a structure b

Single-Family Residential Buildings – Square Footage – Method for Calculating

DB31/ 283-2002 户外广告设施设置技术规范

Technical specifications for setting up outdoor advertising facilities

DB15/T 373-2002 冷轧带肋钢筋混凝土楼板配筋代换表

本代换表只适用以普通低碳钢或低合钢热轧圆盘条为母材，经冷轧减径后，在其表面冷轧成具有三面或两面月牙形横肋的钢筋。本代换表适用于不直接承受重复荷载的工业与民用建筑的普通钢筋混凝土楼板。本代换表适用于I级钢配筋及冷轧带肋钢筋配筋之间的相互代换；亦适用于不同直径冷轧带肋钢筋之间及采用单筋配筋与并筋（不超过两根）配筋之间的相互代换。

substitution table into equivalent cold rolled ribbed steel wires & bars for on-site-cast floor & ceiling plates

DB13(J) 05-2002 建筑结构设计统一技术措施

本统一技术措施是根据河北省建设厅冀建标[2002]第23号文的要求，对(河北 省建筑结构设计统一技术措施)DB13(J)05-94进行全面修订而成。 修订的规范依据是建设部近年来陆续颁发的《建筑结构可靠度设计统一标准》 GB50068-2001等8本结构设计的国标、行标，以及《CL结构体系技术规程》等4本河北省工程建设标准。 本次修订后共有8章15个附录，主要修订内容是:保留了我省普遍采用的烧结粘 土砖、多孔粘土砖砌体结构和钢筋混凝土结构，在钢筋混凝土结构中充实了楼盖部分的 内容，补充了CL结构、异形柱框轻结构和轻钢骨混凝土结构三种类型;增加了轻型钢 结构房屋一章;保留了工业厂房设计部分并合并为一章;增加了地方建设行政主管部门保证工程质量的技术法规性内容和国家规范没有述及的某些条款。 在修编方法上，突出了保证结构设计质I的统一技术措施特点，着重对建筑材料强度等级、设计荃本规定和抗展构造措施作出详尽规定，对结构计算则区别情况只列出计算要点或须提请设计人员应予注意的部分公式和参数;对同一构件或问题将多本规范的相关规定汇集到同一条款，对其中不协调的部分作出明确规定，并对某些国标未涉及或需I化的问题予以明确。本统一技术措施既是结构设计人员使用方便的工具书，也是建筑施工图审查、工程建设监理、质I监督人员的重要参考资料。为使我省的一般民用与工业建筑结构设计贯彻执行国家的现行设计规范和《工程建设标准强制性条文（房屋建筑部分）》，结合河北省的工程建设实际情况，制定本统一技术措施。 凡本技术措施严于或高于国标、行标相应条款者，应按本技术措施执行。

Unified Technical Measures for Building Structure Design

KS F ISO 6707-2:2002 城市建筑设计.合同术语

이 규격은 건축 및 토목 공사에 적용되는 계약 용어를 규정한다.

Building and civil engineering－Vocabulary－Contract Terms

ASTM E1886-02 由导弹冲击以及在循环压力差下的外墙、幕墙、门和防风窗性能的标准试验方法

1.1 This test method determines the performance of exterior windows, curtain walls, doors, and storm shutters impacted by missile(s) and subsequently subjected to cyclic static pressure differentials. A missile propulsion device, an air pressure system, and a test chamber are used to model some conditions which may be representative of windborne debris and pressures in a windstorm environment. This test method is applicable to the design of entire fenestration or shutter assemblies and their installation. The performance determined by this test method relates to the ability of elements of the building envelope to remain unbreached during a windstorm.1.2 The specifying authority shall define the representative conditions (see 10.1).1.3 The values stated in SI units are to be regarded as the standard. Values given in parentheses are for information only. Certain values contained in reference documents cited herein may be stated in inch-pound units and must be converted by the user.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.

Standard Test Method for Performance of Exterior Windows, Curtain Walls, Doors, and Storm Shutters Impacted by Missile(s) and Exposed to Cyclic Pressure Differentials

DB65/ 041-2001 建筑与建筑群计算机信息网络布线标准

Building and building complex computer information network wiring standards

KS F ISO 9882:2001 建筑物性能标准.无预浇负载情况下预制钢盘钢筋混凝土地板的性能试验

이 규격은 프리캐스트 장선(joist) 위에 충전재 블록(filler black)을 사용하

Performance standards in building－Performance test for precast concrete floors－Behaviour under non-concentrated load

KS F ISO 6242-3:2001 建筑结构.用户要求事项.第3部分:声学要求

이 규격은 건물 사용자의 음향 요구를 파악, 표현, 정량화 하기 위한 방법을 규정한다. 이

Building construction-Expression of users′ requirements-Part 3:Acoustical requirements