P67 港口与航道工程 标准查询与下载

DB45/T 1306-2016 港口控制性详细规划编制内容及文本格式规范

Specifications for the content and text format of the compilation of port regulatory detailed planning

JTS 239-2015 水运工程混凝土结构实体检测技术规程

本规程适用于水运工程混凝土结构的实体检测。

Technical Specification for Solid Inspection of Concrete Structure in Port and Waterway Engineering

JTS 218-2014 船闸工程施工规范

本规范适用于新建、扩建和改建船闸工程的施工。

Code for Construction of Shiplock Engineering

PD CEN/TS 15901-15:2014 道路和机场表面特征.第15部分：用纵向控制滑动装置（LFCI）测定路面抗滑性的程序:图像

This Technical Specification describes a method only used on airports for determining the skid resistance of pavements by measurement of the longitudinal friction coefficient LFCI. The method provides a measure of the wet skid resistance properties of a bound surface by measurement of the longitudinal friction coefficient using a trailer with a standard slip ratio of 15%. The slip ratio can be chosen between 0% and 100% for research application. The test tyre is dragged over a pre-wetted pavement under vertical force and constant speed conditions while the test tyre is parallel to the direction of motion. This Technical Specification covers the operation of the IMAG device. The skid resistance of a pavement is determined by friction measurements at different speeds. Tests can be performed between 40 km/h and 120 km/h but standard test speeds are 40 km/h, 65 km/h and 95 km/h. Low speed measurements asses the microtexture while high speed measurements asses the macrotexture. The skid resistance is reported as friction measurements at these speeds and by comparison with the minimum friction level.

Road and airfield surface characteristics - Part 15: Procedure for determining the skid resistance of a pavement surface using a device with longitudinal controlled slip (LFCI): The IMAG

JTS 116-4-2014 水运工程测量概算预算编制规定

本规定适用于水运工程中陆域和水域的工程测量概算预算编制。

Stipulations on Compiling Estimate and Budget for Port and Waterway Engineering Survey

JTS 115-2014 水运工程建设项目投资估算编制规定

本规定适用于新建、改建、扩建的水运工程建设项目预可行性研究报告和工程可行性研究报告投资估算的编制;交通运输支持系统的水运工程可参照执行。

Regulations on Preparation of Cost Estimate for Maritime Structure Construction Project

JTS 273-2014 水运工程测量定额

一、本篇定额适用于水运工程中陆域和水域工程测量的工、料、机消耗量计算。 二、本篇定额应与《水运工程测量概算预算编制规定》（JTS 116-4-2014）和第二篇水运工程测量船舶、仪器艘（台）班费用定额配套使用。 一、本篇定额适用于水运工程中陆域和水域的工程测量项目。 二、本篇定额是编制水运工程测量概算预算的依据，应与《水运工程测量概算预算编制规定》（JTS 116-4-2014）和第一篇水运工程测量预算定额配套使用。

Quota for Port and Waterway Engineering Survey

DB33/T 927-2014 长管节后张法预应力混凝土大管桩设计与施工规程

Design and Construction Rules for Post-tensioned Prestressed Concrete Large Pipe Pile with Long Pipe Sections

DIN 19703:2014 内河航道船闸. 尺寸和设备原理

Locks for waterways for inland navigation - Principles for dimensioning and equipment

JTS 165-7-2014 游艇码头设计规范

本规范适用于新建、扩建和改建的游艇码头的设计。

Code for Design of Marinas

BS 6349-3:2013 海上工程结构.船坞和海闸设计的实施规程

This part of BS 6349 gives recommendations and guidance on the design of shipyard waterfront layouts, dry docks, piers, quays, slipways, shipbuilding berths, shiplifts, floating docks, sea locks, hydrolifts, dock and lock gates, mechanical and electrical services distribution and control systems. It focuses on shipyard-specific design considerations. It does not apply to general maritime works design or to the detailed planning and design of sea locks, as well as their hydraulic design, which are covered by other parts of BS 6349 and PIANC publications. This part of BS 6349 is applicable to the design of both commercial and naval base facilities.

Maritime works. Code of practice for the design of shipyards and sea locks

DB33/T 386-2013 内河航道工程质量检验规范

Specifications for quality inspection of inland waterway engineering

JTS/T 231-7-2013 港口工程离心模型试验技术规程

本规程适用于港口工程离心模型试验。通航建筑物和船厂水工建筑物的离心模型试验可参照执行。

Code for Centrifugal Model Test for Port Engineering

JTS 320-3-2013 船闸检修技术规程

本规程适用于I~V级内河船闸的大修。Ⅵ级、Ⅶ级内河船闸和海船闸的大修,可根据工程的具体情况参照执行。

Technical Code of Overhaulfor Shiplocks

JTS 165-2013 海港总体设计规范

本规范适用于新建、改建和扩建的海港工程的水域、陆域、装卸工艺及相应配套设施的总体设计。对以潮汐作用为主而停靠海船或内河船舶的河口港,既有河流水文特性又受潮汐影响停靠海船的河港,总体设计可根据不同情况按本规范和现行行业标准《河港工程总体设计规范》(JTJ 212)的有关规定执行。

Design Code of General Layout for Sea Ports

SL 161.2-2013 船闸水力模拟技术规程

本标准适用范围为:1 船闸水力学模型试验。包括输水系统水力学整体模型试验、输水系统水力学局部模型试验、输水阀门水力学模型试验、工作闸门水力学模型试验。2 船闸输水系统水力特性数值模拟。

Technical regulation of modelling for hydraulics of shiplocks

SL 161.1-2013 坝区航道水力模拟技术规程

本标准适用范围为:1 坝区航道和中间渠道水力学模型试验。坝区航道模型试验包括枢纽通航水流条件模型试验、船闸引航道水力学模型试验和施工期航道模型试验等。2 坝区航道水流运动数值模拟。

Technical regulation of modelling for hydraulics of dam region waterway

JTS 111-2013 水运工程定额编写规定

本规定适用于水运工程定额的编写。

Stipulations on Compiling Quota of Port and Waterway Engineering

JTS 133-2013 水运工程岩土勘察规范

本规范适用于港口工程、航道工程、渠化工程和修造船厂水工建筑物工程等的岩土勘察。

Code for Geotechnical Investigation on Port and Waterway Engineering

JTS 110-7-2013 水运工程施工图文件编制规定

本规定适用于沿海和内河新建、扩建和改建水运工程施工图文件的编制。

The Stipulation for the Preparation of Detail Design Documents of Port and Waterway Engineering