Q71 木构配件 标准查询与下载

JG/T 122-2000 建筑木门、木窗

本标准规定了木门、木窗的产品分类、要求、试验方法、检验规则、标志、包装、运输及贮存。 本标准适用于建筑用木门、木窗。 本标准不适用于特殊功能的木门、木窗，如防火门、防火窗等。

Wood doors and windows for building

BS EN 12455:1999 弹性地板覆盖物.软木地板衬垫规范

This European Standard specifies the requirements of corkment underlay with linoleum cement as binder, supplied in sheet form. Corkment underlay is used in combination with floor coverings to improve impact sound reduction. The performance therefore depends on the combination of corkment and the type of floor covering used and also the installation of both. To ensure correct use of corkment underlay the instructions of the manufacturer should be followed. NOTE: For specification of cork underlays made with other binders, see EN 12103.

Resilient floor coverings. Specification for corkment underlay

DIN 68140-1 Berichtigung 1:1999 对DIN 68140-1-1998-02的堪误

The document applies to longitudinal jointing of coniferous solid wood for load-bearing and stiffening timber structures according to DIN 1052-1.

Corrigenda to DIN 68140-1:1998-02

BS EN 12103:1999 弹性地面覆盖物.聚合软木垫.规范

This European Standard specifies the requirements for cork underlays made from agglomerated cork designed to be used in conjunction with any type of resilient floor covering to improve their acoustical performance and/or to provide a base for any rigid floor coverings. Optionally, they can be used to improve thermal performance. The standard also specifies requirements for marking and labelling. NOTE The performance of the cork underlays is dependent on the cork underlays themselves, the type of floor covering used and the installation of both; the performance of the "complex" (floor covering plus underlay) is not covered by this standard. The use of cork underlays should follow the instructions of the manufacturer. Cork underlays are supplied either in sheet or roll form.

Resilient floor coverings. Agglomerated cork underlays. Specification

BOCA CHAPTER 23 NBC-1999 木材

The provisions requiring that the excavation left when an unfit structure has been removed be filled in is an obvious, but often neglected means of protecting the public health and safety.

Wood

ASTM C841-99 室内板条及垫高料安装的标准规范

1.1 This specification covers the minimum requirements for interior lathing and furring for full thick gypsum plastering. Other materials may be used provided that their physical characteristics and durability under conditions of usage are at least equal in performance to those described. Note 1-To secure desirable results, this specification should be coordinated with the provisions of Specification C 842. 1.2 The values stated in inch-pound units are to be regarded as the standard. The metric values shown in parentheses are provided for information purposes only. 1.3 For specific degree of fire resistance and the specific degree of sound control requirements see Annex A1.2 and A1.3. 1.4 General information regarding matters of a contractual nature concerning lathing and furring is contained in Annex A1. Technical information relating to lathing and furring materials is provided in Annex A2. Erection data for door frames installed in lath and plaster hollow partitions using prefabricated steel studs or channel studs is provided in Annex A3.

Standard Specification for Installation of Interior Lathing and Furring

NF B54-162:1998 饰面胶合板.框架胶合板.要求

Veneer plywood. Framework plywood. Requirements.

NF B54-112:1998 暴露于潮湿环境下使用并显现暂时危险的刨花板.要求

Particle boards for uses presenting temporary hazards of exposure in humid conditions. Requirements.

NF B54-111:1998 用于干燥环境的刨花板.要求

Particle boards for uses in dry conditions. Requirements.

DIN 68140-1:1998 木制指形接头.第1部分:承载结构用软木的指形接头

Wood finger-jointing - Part 1: Finger jointing of softwood for load-bearing structures

NF P63-204-1:1997 DTU51.11拼接地板和木面镶嵌地板.浮置拼接地板和木面镶嵌地板的铺设.第1部分机械规范

DTU 51.11. Parquet floors and wood-faced inlaid floor coverings. Laying of floating parquet floors and wood-faced, inlaid floor covering. Part 1 : technical specifications.

NF P63-204-2:1997 DTU51.11拼接地板和木面镶嵌地板.专门合同.镶木拼接地板和木面镶嵌地板的铺设.第2部分:特殊条款

DTU 51.11. Parquet floors and wood-faced, inlaid floor coverings. Private contracts. Laying of parquet floors and wood-faced inlaid floor coverings. Part 2 : special clauses.

BS 6446:1997 木材和木质板制品胶合构件的制作规范

Covers the manufacturing details of structural components such as box beams and stressed skin panels made from timber or wood-based panels that are glued together.

Specification for manufacture of glued structural components of timber and wood based panels

NF B54-114-7:1997 木屑板.规范.第7部分:潮湿条件下用重负荷板的要求(欧洲标准EN 312-7)

Particleboards. Specifications. Part 7 : requirements for heavy duty load-bearing boards for use in humid conditions.

DIN 68119:1996 盖屋顶木板

The document specifies shingles for roofs and wall out of european and non-european wood species.

Wood shingles

NF B54-020:1996 带有氨基热固表面层和木基芯(层压地板覆盖物)的地板覆盖物.特性

FLOOR COVERING WITH AN AMINOPLASTIC THERMOSETTING SURFACE LAYER AND WOOD-BASED CORE (LAMINATED FLOOR COVERINGS). CHARACTERISTICS.

BS 8103-3:1996 低层建筑物的结构设计.住宅用木地板和屋顶的实用规程

To be read in conjunction with BS 6100-2.1

Structural design of low-rise buildings - Code of practice for timber floors and roofs for housing

BOCA CHAPTER 23 NBC-1996 木材

This eleventh edition presents the code as originally issued, with changes approved through 1989, and with certain editorial changes made to maintain the sequence of the code, to standardize the format of all 1990 BOCA National Codes, and to update the

Wood

NF P63-202-1:1995 DTU 51-2.镶木地板.胶合镶木地板.第一部分:技术规格

DTU 51.2 - Parquet - Glued parquet - Part 1 : technical specifications.

NF P63-202-2:1995 DTU 51-2.镶木地板.胶合镶木地板.第二部分:特殊要求

DTU 51.2 - Parquet - Glued parquet - Part 2 : special requirements.