共找到 818 条与 供热器材设备 相关的标准,共 55 页
5.1 These test methods are intended to evaluate the ability of the HVAC duct system and its supporting construction to do the following: 5.1.1 Resist the effects of a standardized fire exposure, and 5.1.2 Retain its integrity. 5.2 These test methods provide for the following measurements and evaluations where applicable: 5.2.1 Ability of the fire-resistive material to resist flaming (combustion) when exposed to 1382°F (750°C). 5.2.2 Ability of the tested support system to carry the load of the HVAC duct and its fire-resistive material(s) during a standardized fire-engulfment test. 5.2.3 Ability of the firestops to meet the requirements of Test Method E814 when used as part of a HVAC duct system. 5.2.4 Ability of the HVAC duct system to resist the passage of flames and hot gases onto its unexposed surface during a standardized fire-resistance test. 5.2.5 Transmission of heat through the HVAC duct system during a standardized fire-resistance test. 5.2.6 Ability of the firestop to resist the passage of water during a standardized hose stream test. 5.2.7 Comparative measurement of temperature aging of the fire-resistive material(s) when subjected to a standardized thermal cycling during the durability test. 5.2.8 Measurement of flame spread over the surface of the fire-resistive material or HVAC duct system. 5.2.9 Ability of the covering and lining to resist flaming, glowing, smoldering or smoking while in service. 5.3 These test methods do not provide the following: 5.3.1 Full information as to performance of the fire-resistive material, supporting construction, or the HVAC duct system constructed with components, densities, or dimensions other than those tested. 5.3.2 Evaluation of the degree by which the fire-resistive material or HVAC duct system contributes to the fire hazard by generation of toxic gases, or other products of combustion. 5.3.3 Measurement of the degree of control or limitation of the passage of smoke or products of combustion through the HVAC duct system. 5.4 The test specimens are subjected to one or more specific tests under laboratory conditions. When different test conditions are substituted or the end-use conditions are changed, it is not always possible by, or from, these test methods to predict changes to the characteristics measured. Therefore, the results of these laboratory tests are valid only for......
Standard Test Methods for Fire Resistive Metallic HVAC Duct Systems
이 표준은 농업기계의 트레일러용 등화 장치(이하 “등화 장치”라 한다.)에 대하여 규정한다
Lighting and light-signalling devices of trailers for agricultural machinery
Gas infrastructure - CEN/TC 234 Pressure Definitions - Guideline Document; German version CEN/TR 16395:2012
Household and similar electrical appliances - Safety - Part 2-102: Particular requirements for gas, oil and solid-fuel burning appliances having electrical connections
Household and similar electrical appliances - Safety - Part 2-102: Particular requirements for gas, oil and solid-fuel burning appliances having electrical connections; Amendment 2
SN/T 3242的本部分规定了进出口燃气热水器的检验要求、检验方式及合格判定。 本部分适用于热负荷不大于70kw的燃气快速热水器;本部分亦适用于额定热负荷小于或等于180MJ/h(50kW)的燃气容积式热水器,大于180MJ/h(50kw)而小于360MJ/h(100kw)的燃气容积式热水器参照本部分执行,燃气容积式热水器包括封闭式和敞开式。 本部分不适用于冷凝式燃气热水器。 本部分所指燃气是GB/T 13611、GB/T 13612中规定的燃气。
Rules for the inspection of water heaters for import and export.Part 2:Gas water heaters
Gas infrastructure - Pressure testing, commissioning and decommissioning procedures - Functional requirements; German version EN 12327:2012
Gas-fired domestic appliance producing hot water - Part 5: Assessment of energy consumption of gas fired appliances combined with electrical heat pump; German version prEN 13203-5:2012
이 표준은 목재 펠릿을 연료로 사용하는 펠릿 연소 장치로서 정격 열출력 58 kW 이하의
Pellet combustion device for small heating boilers
이 표준은 1급 목재 펠릿(이하 ‘펠릿’이라 한다.)을 연료로 사용하는 연소 장치를 갖추고
Wood pellet boilers
이 표준은 액화석유가스 또는 도시가스(이하, 가스라고 한다.)를 연료로 사용하는 버너를 구
Measurement methods of electrical consumption for gas burning hot water boiler
이 표준은 KS B 8901에 따르는 목재 펠릿 보일러의 설치 방법에 대하여 규정한다.
The methods for installing wood pellet boiler
Temperature control devices and temperature limiters for heat generating systems
이 표준은 가스 압력이 3.3 kPa 이하의 액화 석유 가스 또는 도시 가스2)를 사용하는
Automatic gas valves for gas hose connection
이 표준은 액화석유가스 또는 도시가스(이하, 가스라고 한다.)를 연료로 사용하는 버너를 가
Gas burning hot water boiler
이 표준은 순간식 및 저탕식의 온수를 공급하는 가정용 가스연소기기에 적용하며, 가스 소비량
Gas-fired domestic appliances producing hot water-Appliances 70 kW heat input and 300 L water storage capacity-Part 2:Assessment of energy consumption
이 표준은 액화석유가스 또는 도시가스(이하, 가스라 한다.)를 연료로 사용하는 버너를 가지
Condensing gas burning hot water boiler
이 표준은 순간식 및 저탕식의 온수를 공급하는 가정용 가스연소기기에 적용하며, 가스소비량
Gas-fired domestic appliances producing hot water-Appliances 70 kW heat input and 300 L water storage capacity-Part 1:Assessment of performance of hot water deliveries
UL Standard for Safety Unvented Alcohol Fuel Burning Decorative Heating Appliances - Section / Paragraph Reference: Various Subject: Grates for installation in existing masonry fireplaces (Edition 1: July 18, 2011)
Gas valves for gas installations - Nozzles with conical sealing and gasket
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号