U22 甲板机械 标准查询与下载

JIS F 2251:1990 船舶用轻载起重机吊杆

この規格は，船の貨物，てんま舶，ホース，ドラムかん，食料などのつり揚げに用いる使用荷重4.9kN{0.5tf}のデリックプームについて規定する。

Ships' light load derrick booms

DIN ISO 3730:1990 造船.锚泊绞盘

The standard specifies the minimum requirements for the design, calculation and equipment with protection and safety devices, which are necessary for operation as well as for the protection of operators and the winch itself. Moreover, indications on additional equipment are given, which can be agreed upon in the contract. These mooring winches are classified by the kind of drive, nominal size and arrangement of drums. The nominal size corresponds to the drum load.#,,#

Shipbuilding; mooring winches; identical with ISO 3730:1988

ARMY MIL-A-46100D (1)-1990 高硬度锻造钢装甲板

Paragraph 3.2.2 change last sentence to read, "It is recommended that the delay after quenching be no greater than 24 hours, see 6.15."

ARMOR, PLATE, STEEL, WROUGHT, HIGH-HARDNESS

NAVY MIL-V-17501 F-1990 弹药舱喷淋和飞机库甲板喷淋控制阀

This specification covers magazine and hangar deck sprinkler control type valves for shipboard service.

VALVES, CONTROL TYPE, MAGAZINE, AND HANGAR DECK SPRINKLER

NAVY MIL-D-21631 A VALID NOTICE 1-1990 乳汁凝结甲板覆盖物

MIL-D-2163lA(SHIPS), dated 21 August 1974, has been reviewed and determined

DECK COVERING, LATEX CONCRETE

ARMY MIL-A-12560H-1990 同质焊接钢装甲板(用于战斗用车和军火测试)

This specification covers wrought-steel homogeneous armor plate in thicknesses from 1/4 to 6 inches inclusive for use in combat-vehicles and 1/4 to 12 inches inclusive for use in proof and acceptance testing of armor defeating ammunition(see 6.1 and 6.4.3).

ARMOR PLATE, STEEL, WROUGHT, HOMOGENEOUS (FOR USE IN COMBAT-VEHICLES AND FOR AMMUNITION TESTING)

CB/T 3121-1999 电动稳索绞车

Electric prevent winches

ISO 9089:1989 海上结构物 移动式近海装置 锚绞车

Specifies requirements of anchor winches for position keeping, and temporary and emergency anchoring of mobile offshore units, particularly drill-ships, semi-submersible drilling rigs and accomodation platforms. Does not apply to anchor winches which are used for other purposes.

Marine structures; mobile offshore units; anchor winches

ISO 3730:1989 造船.锚泊绞盘

This International Standard specifies the characteristics of automatic and non-automatic mooring winches, with electric, hydraulic or steam drive, which fulfil the functions of manoeuvring, holding and storing mooring ropes on a single drum. Such winches may also be used for warping purposes. The functions of mooring winches covered by this International Standard are illustrated in table 1.

Shipbuilding; mooring winches

CB/T 3878-1999 船用载货电梯

Ship goods lift

CB/T 3877-1999 甲板机械一般要求

Shipbuilding-deck machinery.General requirements

CB/T 3883-1999 船用液压臂架起重机工作试验方法

Works trial method for marine hydraulic jib-crane

NAVY MIL-D-3134 J (1)-1989 甲板覆盖物原料(用以代替:NAVY MIL-D-003134 G)

This amendment forms a parotf MIL-D-3134J(NAVY), dated 5 October 1988,and is approved for buys e the Departmento f the Navy and is available for use by all Departments aAngde ncies of the Departmento f Defense.

DECK COVERING MATERIALS [Use In Lieu Of: NAVY MIL-D-003134 G]

DIN ISO 6555:1989 造船.顶置绞盘

The standard specifies the minimum requirements for the design, calculation and equipment with protection and safety devices, which are necessary for operation as well as for the protection of operators and the winch itself. Moreover, indications on additional equipment are given, which can be agreed upon in the contract. These topping winches are classified by the kind of drive, nominal size and arrangement of drums. The nominal size corresponds to the drumload and holding load.#,,#

Shipbuilding; topping winches; identical with ISO 6555:1988

NAVY MIL-W-8982 D SUPP 1-1989 薄壁高强度花键扳手的一般技术要求

This supplement forms a part of MIL-W-89B2D. dated 27 February 1989

WRENCHES, SPLINED, HIGH STRENGTH, THIN WALL, GENERAL SPECIFICATION FOR

NAVY MIL-STD-1322-1000 VALID NOTICE 1-1989 国内及海外典型装载装船负载

This amendment forms a part of Military Specificatior MIL-B-l6522(BuOrd), dated 8 August 1951.

UNIT LOAD FOR DOMESTIC& OVERSEAS SHIPMENT TYPICAL LOADS

NAVY MIL-STD-1325-86 VALID NOTICE 1-1989 MK53MOD0水雷板条箱MK 52 及MODS水雷危险原料铁路车装载

MIL-STD-l325/86(0S) dated 03 AUG,1976, has been reviewed and determined to be valid €or use in acquisition.

RAILCAR LOADING OF HAZARDOUS MATERIALS MINE, UNDERWATER MK 52 AND MODS IN CRATE, UNDERWATER MINE MK 52 MOD 0

NAVY MIL-STD-1325-83 VALID NOTICE 1-1989 舰队事务负载MK 76 MOD 0适配器MK 11 MOD 0 或MK 13 MOD 0 坦克弹药筒8/55推进充电危险原料铁路车装载

MIL-STD-l325/83(OS) dated 27 SEPT.1974, has been reviewed and determined to be valid for use in acquisition.

RAILCAR LOADING OF HAZARDOUS MATERIALS CHARGE, PROPELLING 8/55 CARTRIDGE TANK MK 11 MOD 0 OR MK 13 MOD 0 IN ADAPTER MK 76 MOD 0 FLEET ISSUE UNIT LOAD

NAVY MIL-STD-1325-55 VALID NOTICE 2-1989 MK 28 MOD 1容器MK 28 MOD 1危险原料适配器工具箱铁路车装载

MIL-STD-l325/55(OS) dated 08 MAR.1976, has been reviewed and determined to be valid for use in acquisition.

RAILCAR LOADING OF HAZARDOUS MATERIALS ADAPTION KIT MK 28 MOD 1 IN CONTAINER MK 182 MOD 1

NAVY MIL-STD-1325-15 VALID NOTICE 1-1989 MK 11及MODS舰队负载5/54货盘适配器射弹危险原料铁路车装载

MIL-STD-l325/15(OS) dated 22 DEC.1975, has been reviewed and determined to be valid for use in acquisition.

RAILCAR LOADING OF HAZARDOUS MATERIALS PROJECTILES 5/54 IN PALLET ADAPTER MK 11 AND MODS FLEET ISSUE UNIT LOAD