V41 导航通讯系统与设备 标准查询与下载

HB 6500-1991 飞机磁罗盘安装通用规范

本规范规定了飞机磁罗盘安装的一般要求，试验方法和检验规则。 　　本规范适用于直读磁罗盘、远读磁罗盘和精密远读磁罗盘（具有精密定向要求）在军用飞机上的安装。民用飞机、直升机可参照使用。

General specification for the installation of aircraft magnetic compass

SAE AS8009A-1991 气压高度表设备

This Aerospace Standard (AS) specifies minimum performance requirements for pressure altimeter systems other than air data computers. This AS covers altimeter systems that measure and display altitude as a function of atmospheric pressure. The pressure transducer may be contained within the instrument display case or located remotely. Requirements for air data computers are specified in AS8002. Some requirements for nontransducing served altitude indicators are included in AS791.

Pressure Altimeter Systems

SJ/T 10189-1991 机载奥米加接收设备性能要求和试验方法

本标准适用于各种类型的机载奥米加接收设备。是制订产品标准的依据之一。

Performance requirements and test methods for airborne omega receiving equipment

SJ/T 10207-1991 空中交通管制超短波地空通信发射机性能要求和测量方法

1．1 本标准规定了空中交通管制系统中地空通信的超短波地面固定电台发射机的主要电性能要求和测量方法。 1．2 本标准适用于发射机的设计、制造和测量。

Performance requirements and measurement methods for ultrashort wave ground-to-air communication transmitters for air traffic control

SJ/T 10206-1991 空中交通管制超短波地空通信接收机性能要求和测量方法

本标准规定了空中交通管制系统中地空通信的超短波地面固定电台接收机的主要电性能要求和测量方法。 本标准适用于接收机的设计、制造和测量。

Air traffic control ultrashort wave ground-to-air communication receiver performance requirements and measurement methods

SAE AS4117-1991 数字式时分制指令/响应型多路传输数据总线耦合器,终端器和数据总线电缆的试验计划

This test plan defines the requirements of data bus components which comply with the requirements of MIL-STD-1553B, Digital Time Division Command/Response Multiplex Data Bus.

Test Plan for the Digital Time Division Command/Response Multiplex Data Bus Couplers, Terminators, and Data Bus Cables

SAE ARP4102/7_APXA-1991 附件A用于电子姿态指挥仪/个人漂浮器的电子显示符号

This document recommends criteria for electronic displays on the flight deck of transport aircraft. Electronic displays include electronic flight instruments, alert displays, aircraft system displays and control/display units for flight management and radio management systems.

Appendix A Electronic Display Symbology for EADI/PFD

HB 6431-1990 机载前视红外系统通用规范

本规范规定了机载前视红外系统（以下简称系统）的通用要求。 　　本规范适用于系统的设计、制造、使用、试验、检验、包装、运输和贮存。也适用于作为制定系统各组件、部件专用规范的依据，如果超出本规范的要求时，应在其专用规范中明确规定。

General specification for airborne forward-looking infrared system

HB 6436-1990 机载飞行数据记录器最低性能标准

本标准规定了主要供飞行事故分析用的机载飞行数据记录器（以下简称“记录器”）必须要满足的产口最低性能标准要求。记录器应能在本标准第３章规定的环境条件下正常工作。 　　本标准主要适用于民用飞机上安装的三种基本娄型的至少能记录时间、高度、空速、垂直加速度、航向等５个基本参数的机载飞行数据记录器。记录介质上所应记录的各种数据信号，可以从直接的和／或间接的传感器上获得。 　　本标准所规定的附毁幸存条件也适用于“飞机综合数据系统”或“飞机状态监测系统”中带防护壳体具备防护功能的记录器。

Minimum Performance Standards for Airborne Flight Data Recorders

SAE ARP4258-1990 低速航空电子系统离散信号接口的应用

The purpose of this Aerospace Recommended Practice (ARP) is to provide recommendations on the use of four types of discrete signal interfaces for unidirectional, low power, low frequency transmission of discrete information.

Application of Low Speed Avionic System Discrete Signal Interfaces

BS G 242:1989 数据总线互连系统规范

Defines the characteristics of the data bus line and components up to the interface with electronic components of the system.

Specification for data bus interconnecting systems

HB 6186-1989 机载雷达罩通用规范

本规范规定了飞机与机载导弹雷达罩通用技术要求，作为雷达罩的设计、制造和试验的依据。（不包括民用客机雷达罩）。

General specifications for onboard radome

SAE AS4115-1989 数字式时分制指令/响应型多路传输数据总线系统的试验计划

This test plan consists of two major sections for testing of MIL-STD-1553B data bus systems: Bus Network and System Integration Tests. This test plan defines the test requirements for: a) verifying that the bus network, (that is, cabling, couplers, connectors and terminators) when in the final system design configuration, complies with the requirements of MIL-STD-1553B and b) ensuring that when the bus system (that is, bus network, remote terminals and bus controllers) is integrated, it meets the specific requirements of MIL-STD-1553B, and provides for reliable communications within its system environment.

Test Plan for the Digital Time Division Command/Response Multiplex Data Bus System

SAE AS4114-1989 时分制指令/响应型多路传输数据总线控制器的生产试验计划

This test plan consists of two major sections for the production testing of bus controllers: Electrical tests and Protocol tests. This production test plan defines the test requirements for determining that bus controllers meet the requirements of MIL-STD-1553B, Digital Time Division Command/Response Multiplex Data Bus.

Production Test Plan for the Time Division Command/Response Multiplex Data Bus Bus Controllers

SAE ARP4067-1989 适用于第23部分运输机的阴极射线管显示器的设计目标

1.1 This SAE Aerospace Recommended Practice (ARP) is intended as a guide towardstandard practice and is subject to change to keep pace with experience andtechnical advances. This report provides additional quantitativeinformation pertinent to AS8034.1.2This ARP recommends display system performance criteria for direct viewcathode-ray-tube (CRT) instrumentation on the flight deck of all aircraftsubject to Part 23 certification.1.3This ARP covers CRT electronic display devices, both single color andmulticolor, and is applicable to the following types of displays.Type I:Flight and Navigation DisplaysType II: Engine, Systems and Warning DisplaysType III: Control Displays

DESIGN OBJECTIVES FOR CRT DISPLAYS FOR PART 23 AIRCRAFT

SAE AS4074/1-1988 线型标记传送多路传输数据总线

This standard specifies the characteristics of the SAE Linear Token Passing Bus (LTPB) Interface Unit. The LTPB provides a high reliability, high bandwidth, low latency serial interconnection netwrok suitable for utilization in real time military and commercial applications. Multiple redundant data paths can be implemented to enhance reliability and survivability in those applications that require these attributes. The token passing and data exchange protocols are optimized to provide low latency and fast failure detection and correction. Physical configurations with bus lengths up to 1000 meters can be accommodated.

LINEAR TOKEN PASSING MULTIPLEX DATA BUS

SAE AS4074/2-1988 高速环形总线

A fault tolerant,real time high speed data communication standard is defined based on a ring topology and the use of a Token passing access method with distrbuted control.The requirements for the HSRB standard have been driven predominantly,but not exclusively,by military applications .Particular attention has been given to the need for low message latency,deterministic message priority and comprehensive reconfiguration capabilities.This document contains a definition ofthe semantics and protocol including delimfters ,tokens,message priority,addressing ,error detection and media.Parameters related to particullar media and bit rates are define in the Appendix.

High Speed Ring Bus

SAE ARP4102/6-1988 通信和导航设备

This document recommends criteria for the control and display of communications and navigation equipment on the flight deck. The equipment includes: a. Communications: Ultra High Frequency (UHF), Very High Frequency (VHF), and High Frequency (HF) Radios, Cabin/Service Interphones, Public Address (PA), Select Call (SELCAL), Call Select (CALSEL), Satellite Communications (SATCOM), b. Navigation: Very High Frequency Omnidirectional Range (VOR), Tactical Air Navigation (TACAN), Automatic Direction Finder (ADF), Distance Measuring Equipment (DME), Instrument Landing System (ILS), Markers (MKR), Omega, Very Low Frequency (VLF), Inertial Navigation Systems (INS), Inertial Reference Systems (IRS), Satellite Navigation (SATNAV), Low Range Radio Altimeter (LRRA).

Communications and Navigation Equipment

SAE ARP1874-1988 适用于第25部分运输机阴极射线管显示器的设计目标

This SAE Recommended Practice is intended as a guide toward standard practice and is subject to change to keep pace with experience and technical advances. The report provides additional information pertinent to AS 8034. This Aerospace Recommended Practice (ARP) recommends display system performance criteria for direct view cathode-ray-tube (CRT) instrumentation on the flight deck of all aircraft subject to Part 25 certification. This ARP covers CRT electronic display devices, both single color and multicolor, and is applicable to the following types of displays: Type I Flight and navigation Displays; Type II Engine, Systems and Warning Displays; and Type III Control Displays.

Design Objectives for CRT Displays for Part 25 (Transport) Aircraft

HB 6163-1988 超高频波段机载天线通用规范

本规范规定了超高频波段机载天线的通用要求。 　　本规范涉及的天线按规定（见３．１条）以形式分类。

General specification for UHF band airborne antenna