V41 导航通讯系统与设备 标准查询与下载

SJ 20408-1994 UHF数字接力设备电性能测量方法

Methods of measurement for electric performance of UHF digital radio relay equipment

SJ 20407-1994 UHF数字接力设备通用规范

Generic specification for UHF digital radio relay equipments

SJ 20406-1994 机载气压数字高度表通用规范

General specification for airborne dirgital altimeter based on atmospheric pressure

SJ 20405-1994 敌我识别地面应答机通用规范

General specification for lFF ground responders

SJ 20404-1994 敌我识别地面询问机通用规范

General specification for IFF ground interrogators

SJ 20402-1994 敌我识别海用询问机通用规范

General specification for IFF naval interrogators

SJ 20401-1994 平板裂缝天线孤立缝测量方法

Methods of measurement for isolated slot of planar waveguide-fed slot arrays

SJ 20400-1994 低副瓣平板裂缝天线性能近场测试方法

Methods of near-field measurement for planar waveguide-fed slot arrays with low sidelobes

SJ 20399-1994 平板裂缝天线阵面防护罩通用规范

General specification for protective cover for planar waveguide-fed slot array surface

SJ 20398-1994 机载雷达用栅控行波管钛泵电源通用规范

General specification for the grid control travelling-wave tube titanium getter pump power supply of airborne radar

SJ 20397-1994 机载雷达用栅控行波管调制器通用规范

General specification for grid control travelling-wave tube modulator of airborne radar

ISO 8668-6:1994 航空器 登机桥连接系统 第6部分:4型系统的详细规范

Specifies the specific characteristics of a Terminal Junction System (TJS), designated as type 4 and particularly designed for aircraft applications. Shall be read in conjunction with ISO 8668-1 and ISO 8668-2.

Aircraft - Terminal junction systems - Part 6: Detail specification for type 4 system

SAE AS4074/1-1993 F-1式光纤媒体接口特征R(2001)

This slash sheet specifies the operational parameters and characteristics of a particular implementation of the SAE Linear, Token Passing Bus (LTPB) Interface Unit. This slash sheet defines the following: a. the physical media interface: this slash sheet specifies the characteristics of the optical interface to the physical bus media; b. the minimum and maximum timing requirements for operation of this implementation of the LTPB; c. the data coding used to encode and decode the data for transmission; and d. the default values to be loaded into the timers of the LTPB interface at power-up prior to intervention by the host processor.

Type F-1 Fiber Optic Media Interface Characteristics R(2001)

SAE ARP4102/7_APXC-1993 附件C用于发动机显示器的电子显示符号[代替:SAE ARP 1068B]

This document recommends criteria for electronic displays on the flight deck of transport aircraft. Electronic displays include electronic flight instruments, alert displays, aircraft system displays and control/display units for flight management and radio management systems.

Appendix C Electronic Display Symbology for Engine Displays [Superseded: SAE ARP 1068B]

SAE ARP4392-1993 兼容的飞机外部夜视成像系统(NVIS)照明

This SAE Aerospace Recommended Practice (ARP) describes the recommended performance levels for equipment located on the aircraft exterior which produces radiant energy which will provide desired information when viewed with NVIS goggles. These performance intensities, normally stated in candelas for visible light, are modified to consider the goggle spectral response range. Where necessary, location of the equipment on the airplane is specified. The spectral emission characteristics may or may not include visible light. Whether or not visible energy is emitted, this document will refer to these items of equipment as lights.

Lighting, Aircraft Exterior, Night Vision Imaging System (NVIS) Compatible

SAE ARP4102/7_APXB-1993 附录B EHSI/ND电子显示符号

This document recommends criteria for electronic displays on the flight deck of transport aircraft. Electronic displays include electronic flight instruments, alert displays, aircraft system displays and control/display units for flight management and radio management systems.

Appendix B Electronic Display Symbology for EHSI/ND

HB 6627-1992 飞机磁罗盘校准的一般要求

本标准规定了飞机上磁罗盘校准和补偿的一般要求。 　　本标准适用于安装在军用歼击机、强击机、轰炸机、运输机及直升机等上的直读磁罗盘、远读磁罗盘、精密远读磁罗盘以及陀螺磁罗盘的精确航向校准。民用飞机也可参照使用。

General requirements for aircraft magnetic compass calibration

SAE AS4075-1992 高速环网(HSRB)标准.代替AS 4074.2

A fault tolerant, real time high speed data communication standard is defined based on a ring topology and the use of a token passing access method with distributed control. The requirements for the HSRB standard have been driven predominantly, but not exclusively, by military applications. Particular attention has been given to the need for low message latency, deterministic message priority and comprehensive reconfiguration capabilities. This document contains a definition of the semantics and protocol including delimiters, tokens, message priority, addressing, error detection and recovery schemes; and is written to be independent of bit rate and media. Parameters related to particular media and bit rates are defined in separate documents, the AS4075 slash sheets.

High Speed Ring Bus (HSRB) Standard Superseding AS 4074.2

HB 6558-1991 机载甚高频全向信标接收设备基本性能和要求

本标准规定了机载甚高频全向信标接收设备（含指点信标接收机）的基本性能和互换性、可测试性要求。 　　本标准适用于工作在108.00～117.95MHz民用机载甚频全向信标接收设备的设计与安装。

Basic Performance and Requirements of Airborne VHF Omnidirectional Beacon Receiving Equipment

AIAA R-004-1992 航空与航天飞行器协调系统

This document ANSVAIAA R-004-1992 gives basic definitions and deals with the motion of flight vehicles relative to various inertial axis systems or relative to the atmosphere, which may be assumed to be at rest or in translational motion at constant velocity relative to the Earth.

Atmospheric and Space Flight Vehicle Coordinate Systems