Y40 日用化工品综合 标准查询与下载

ASTM E1882-10 使用琼脂贴片法评估抗菌配方的标准试验方法

This procedure can be used to evaluate formulations containing ingredients intended to inhibit growth of bacteria on intact skin and measures the difference, post-product-exposure, between numbers of bacterial colonies on active test formulation plates and numbers on control plates, expressed as percent inhibition. This procedure may also be used to test for persistence of activity, as a function of time elapsed between application of active test formulation and application of active test plates. Because no procedure for neutralization of the antimicrobial action of active ingredients can be included in the test, the agar patch method is limited to the extent that results expressed as percent inhibition do not differentiate between bacteristatic and bactericidal effects and, hence, must not be portrayed as “reductions.”1.1 This test method determines the antibacterial activity and persistence of test formulations, as measured by the inhibition of a test organism on an agar surface exposed to test sites on human skin treated with the formulations. 1.2 A knowledge of microbiological techniques is required for these procedures. 1.3 It is the responsibility of the investigator to determine if Good Laboratory Practice (GLP) and Good Clinical Practice (GCP) are required and to adhere to these practices, as appropriate. 1.4 In this test method, SI units are used for all applications except linear measure. In that case, inches are used and SI units follow in parentheses. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Performance of this procedure requires the knowledge of regulations pertaining to the protection of human subjects (see 21 CFR, Ch. I, Parts 50 and 56 ).

Standard Test Method for Evaluation of Antimicrobial Formulations by the Agar Patch Technique

SN/T 2206.5-2009 化妆品微生物检验方法.第5部分：肠球菌

SN/T 2206的本部分规定了化妆品中肠球菌的检验方法。 本部分适用于化妆品中肠球菌的检验。

Determination of microbiogical in cosmetics.Part 5:Enterococci

SN/T 2206.4-2009 化妆品微生物检验方法.第4部分：链球菌

SN/T 2206的本部分规定了化妆品中链球菌的检验方法。 本部分适用于化妆品中链球菌的检验。

Determination of mierobiological in cosmetics.Part 4:Streptococcus spp.

SN/T 2206.3-2009 化妆品微生物检验方法.第3部分：肺炎克雷伯氏菌

SN/T 2206的本部分规定了化妆品中肺炎克雷伯氏菌的检验方法。 本部分适用于化妆品中肺炎克雷伯氏菌的检验。

Determination of microbiogical in cosmetics.Part 3:Klebsiella pneumoniae

SN/T 2206.2-2009 化妆品微生物检验方法.第2部分：需氧芽孢杆菌和蜡样芽胞杆菌

SN/T 2206的本部分规定了化妆品中尤其是水分含量较少的粉类化妆品中需氧芽孢杆菌和蜡样芽孢杆菌的检验方法。 本部分适用于化妆品中需氧芽孢杆菌和蜡样芽孢杆菌的检验。

Determination of microbiological in cosmetics.Part 2:Aerobic spore-former bacteria and Bacillus cereus

DB44/ 495-2008 贵金属饰品标识标注方法

本标准规定了贵金属及贵金属镶嵌饰品（包括首饰和工艺品）的产品标识的基本要求和标注方法。本标准适用于贵金属及贵金属镶嵌饰品标识标注。

Labeling method of precious metal jewelry

QB/T 2949-2008 磷酸酯

本标准规定了磷酸酯产品的分类、要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于分别以脂肪醇、脂肪醇醚或烷基酚醚与五氧化二磷、三氯化磷、五氯化磷或聚磷酸为原料制得的磷酸酯产品，是应用于生产化妆品及各种工业助剂的阴离子型表面活性剂。

Phosphoric acid ester

KS H ISO 1041:2006 精油.冻点的测定

이 규격은 정유의 어는점을 측정하는 방법을 규정한다. 장미 정유와 같은 특별한경우에는

Essential oils-Determination of freezing point

KS H ISO 4715:2006 精油.蒸发后残留物的定量评估

이 규격은 정유의 증발 후에 남아 있는 잔유물의 정량적 평가에 대한 방법을 규정한다.

Essential oils-Quantitative evaluation of residue on evaporation

KS H ISO 7660:2006 精油.含难以皂化的酯类精油脂值的测定

이 규격은 KS H ISO 709(1)에 명시된 방법이 적용될 수 없는 비누화가 어려운 에

Essential oils-Determination of ester value of oils containing difficult-to-saponify esters

KS H ISO 3794:2006 精油(含叔醇)(containing tertiary alcohols).用乙酰化后酯值的测定评估游离醇含量

이 규격은 아세틸화 반응(1) 후 에스터값을 측정함으로써 정유 중의 유리 알코올 함량을

Essential oils(containing tertiary alcohols)-Estimation of free alcohols content by determination of ester value after acetylation

ASTM D1792-06 乳化地板擦亮剂长期可除污性的测试方法

This test method is used to predict removability of floor polish after a treatment period that simulates aging in the field. It allows for uniform mechanical and detergent action leaving the only variable the actual removability of the polish.1.1 This test method covers the determination of the relative ease of removal of dried films of water-emulsion floor polishes from common flooring substrates under accelerated conditions, which correspond to extended service aging. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Long-Term Removability Properties of Emulsion Floor Polishes

DB37/T 376-2003 复配次氯酸钠消毒液通用技术条件

本标准规定了过氧乙酸溶液中硫酸盐含量的测定方法

General technical specification for compound sodium hypochlorite disinfectant

DB37/T 374-2003 商业零售业态

本标准规定了过氧乙酸含量的测定方法

Commercial retail format

ISO 1272:2000 精油 酚类含量的测定

This International Standard specifies a method for the determination of the percentage, by volume, of phenols in essential oils. NOTE See 8.2.2 which establishes some limits to the application of this method.

Essential oils - Determination of content of phenols

DB31/T 230-1999 日化行业产品能耗定额及其计算细则

Energy consumption quotas and calculation rules for products in the daily chemical industry

ISO 1242:1999 精油 酸值的测定

This International Standard specifies a method of determining the acid value of essential oils. This method is not applicable to essential oils containing appreciable quantities of lactones.

Essential oils - Determination of acid value

ASTM D3430-95 液态水基透明地板抛光剂透明度及泛黄度的标准试验方法

1.1 This test method covers measurement of the degree of clarity and depth of yellowness of water-based clear floor polishes. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Clarity and Yellowness of Liquid Water-Based Clear Floor Polishes

ASTM D2834-95(2002) 水乳液地板抛光剂、溶剂基地板抛光剂和聚合物乳液地板抛光剂中的不挥发物(总固体)的标准测试方法

Nonvolatile matter determination is useful as a quality control test, when used in conjunction with other tests, to assure specification compliance.1.1 This test method covers the determination of nonvolatile matter (total solids) in a water-emulsion, organic solvent- base liquid and paste floor polishes, and polymer-emulsion-type floor polishes. 1.2 This test method recognizes that the products may contain material that will slowly volatilize or change chemically with a resulting change in weight of the nonvolatile matter. Therefore, since drying to constant weight is impractical, specific drying times have been selected. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Nonvolatile Matter (Total Solids) in Water-Emulsion Floor Polishes, Solvent-Based Floor Polishes, and Polymer-Emulsion Floor Polishes

ASTM D2834-95(2001) 水乳液地板抛光剂、溶剂基地板抛光剂和聚合物乳液地板抛光剂中的不挥发物(总固体)的标准测试方法

1.1 This test method covers the determination of nonvolatile matter (total solids) in a water-emulsion, organic solvent- base liquid and paste floor polishes, and polymer-emulsion-type floor polishes. 1.2 This test method recognizes that the products may contain material that will slowly volatilize or change chemically with a resulting change in weight of the nonvolatile matter. Therefore, since drying to constant weight is impractical, specific drying times have been selected. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Nonvolatile Matter (Total Solids) in Water-Emulsion Floor Polishes, Solvent-Based Floor Polishes, and Polymer-Emulsion Floor Polishes