共找到 180 条与 废气排放污染物分析方法 相关的标准,共 12 页
本标准规定了测定黄磷生产废气中气态砷及其化合物二乙基二硫代氨基甲酸银分光光度法。 本标准适用于黄磷生产废气中以气态形式存在的砷及其化合物的测定。 本方法检出限为1.25μg/ml二乙基二硫代氨基甲酸银吸收液,当采气体积15L时,砷的检出限为0.08mg/m,测定下限为0.32mg/m(均以As计)。
Yellow phosphorus production emission.Determination of gaseous arsenic.Silver diethyldithiocarbamate spectrophotometric method
本标准规定了测定环境空气中五氧化二磷的抗坏血酸还原-钼蓝分光光度法. 本标准适用于空气中五氧化二磷的测定。 本标准检出限为0.8μg/50ml,当采样体积为5m时,检出限为0.2μg/m,测定下限为0.8μg/m;当采样体积为300L时,检出限为0.003mg/m,测定下限为0.012mg/m.
Ambient air.Determination of phosphorus pentoxide.Molybdenum blue ascorbiaccid to deoxidize spectrophotometric method
本标准规定了测定环境空气中汞及其化合物的巯基棉富集-冷原子荧光分光光度法。 本标准适用于环境空气中汞及其化合物的测定。 本标准方法检出限为0.1mg/10ml试样溶液。当采样体积为15L时,检出限为6.6×10mg/m,测定下限为2.6×10mg/m
Ambient air.Determination of mercury and its compounds.Cold atomic fluorescent spectrophotometry after sulfhydryl cotton preconcentraction
本标准规定了测定空气和废气中以颗粒物形态存在的砷及其化合物的二乙基二硫代氨基甲酸银分光光度法。 本标准适用于空气和废气中以颗粒物形态存在的砷及其化合物的测定。 本方法将滤筒或滤膜制备成50ml试样时,检出限为0.35μg/50ml(以As计)。 对于有组织排放废气,当采集400L气体时,检出限为0.9μg/m,测定下限为3.5μg/m(均以As计)。 对于空气样品,当采集6m气体时,检出限为0.06μg/m,测定下限为0.24μg/m(均以As计)。
Ambient air and waste gas.Determination of arsenic.Silver diethyldithiocarbamate spectrophotometric method
本标准规定了测定环境空气中铅的石墨炉原子吸收分光光度法。 本标准适用于环境空气中铅的测定。 方法检出限为0.005μg/50ml试样溶液,当采样体积为10m时,检出限为0.005μg/m,测定下限为0.020μg/m.
Ambient air.Determination of lead .Graphite furnace atomic absorption spectrometry
本标准规定了固定污染源废气中测定气态总磷的喹钼柠酮容量法。 本标准适用于固定污染源废气中气态总磷的测定。 本标准的检出限为10μg,当采样体积为10L时,气态总磷的检出限为1mg/m。
Stationary source emission.Determination of total gaseous phosphorus.Quimociac volumetric analysis
本标准规定了测定固定污染源废气中铅的火焰原子吸收分光光度法。 本标准适用于固定污染源废气中铅的测定。 方法检出限为5μg/50ml试样溶液,当采样体积为400L时,检出限为0.013mg/m,测定下限为0.052mg/。
Stationary source emission.Determination of lead.Flame atomic absorption spectrometry
이 표준은 현장 조건하의 압축 착화 엔진에서 발생하는 매연 배출의 평가를 위한 시험 사이클
Reciprocating internal combustion engines-Exhaust emission measurement-Part 10:Test cycles and test procedures for field measurement of exhaust gas smoke emissions from compression ignition engines operating under transient conditions
이 표준은 왕복형 내연 피스톤 엔진에 사용되는 지름 30 mm 이상 200 mm 이하의 N
Internal combustion engines-Piston rings-Scraper rings made of cast iron
이 표준은 일반적으로 설계 규격에서 발견되지 않지만 정의할 수 있는 품질의 측면을 규정한다
Internal combustion engines-Piston rings-Part 5:Quality requirements
이 표준은 최대 지름 200 mm까지의 왕복형 내연 피스톤 엔진에 사용되는 R, B, BA
Internal combustion engines-Piston rings-Part 1:Rectangular rings made of cast iron
이 표준은 왕복 내연 피스톤 엔진에 사용되는 지름 38 mm 이상 160 mm 이하의 지름
Internal combustion engines-Piston rings-Part 2:Half keystone rings made of cast iron
이 표준은 왕복 내연 기관 및 압축기용 피스톤 링의 일반적인 특성을 규정한다. 이 표준은
Internal combustion engines-Piston rings-Part 4:General specifications
이 표준은 피스톤 링 측정에 적용될 측정 원칙에 대해 규정하며 왕복 내연 기관의 지름 20
Internal combustion engines-Piston rings-Part 2:Inspection measuring principles
이 표준은 내연 기관에 사용되는 지름 30 mm∼160 mm의 R, B, BA 및 M형 강
Internal combustion engines-Piston rings-Part 2:Rectangular rings made of steel
이 표준은 표준가스의 제조에 사용하는 희석가스와 계측기의 영점의 눈금 정하기, 교정에 사용
Testing methods for determination of trace components in diluent gas and zero gas
이 표준은 배기가스의 처리대상가스를 제거하기 위하여 사용하는 가스처리장치에 대하여 사용상태
Method of measuring performance for gas treatment equipment
Reciprocating internal combustion engines - Exhaust emission measurement - Part 5 : test fuels.
Reciprocating internal combustion engines - Exhaust emission measurement - Part 4 : steady-state test cycles for different engine applications.
이 표준은 기체 중의 더스트를 정성 또는 정량하기 위해 여과ㆍ포집하는 여과재(이하 여과재라
Form, size and performance testing methods of filtration media for collecting airborne particulate matters
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号