87.060.20 涂料粘合剂 标准查询与下载
共找到 547 条与 涂料粘合剂 相关的标准，共 37 页
Binders for paints and varnishes — Raw tung oil — Requirements and methods of test
- ICS
- 87.060.20
- CCS
- 发布
- 2022-11-09
- 实施
Binders for paints and varnishes — Polyisocyanate resins — General methods of test
- ICS
- 87.060.20
- CCS
- 发布
- 2022-11-09
- 实施
Paints, varnishes and binders — Determination of MEQ value of water-based coating materials and binders
- ICS
- 87.060.20
- CCS
- 发布
- 2022-11-09
- 实施
Chlorinated rubber resin for coatings
- ICS
- 87.060.20
- CCS
- G51
- 发布
- 2022-09-30
- 实施
- 2023-04-01
项 目 要 求 外观 深褐色或黑色黏稠液体 异氰酸根（—NCO）质量分数，w/% ≥20.0 黏度（23 ℃）/（mPa·s） ≥3000 HDI质量分数，w/% ≤10.0
Hexamethylene diisocyanate by-product polymer
- ICS
- 87.060.20
- CCS
- C264
- 发布
- 2022-07-21
- 实施
- 2022-10-11
1.1 This guide covers methods suitable for testing latex vehicles. Certain of these methods were developed expressly for testing latex vehicles (Table 1). Others were developed for testing or analyzing formulated wateror solvent-based coatings but would be equally applicable for testing latices. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Guide for Testing Latex Vehicles
- ICS
- 87.060.20
- CCS
- 发布
- 2022-06-01
- 实施
This document specifies the determination of the molar-mass distribution and the average molar mass values Mn (number average) and Mw (weight average) of polymers that are soluble in water by gel permeation chromatography (GPC). NOTE Also known as size exclusion chromatography (SEC). This method is applicable to neutral polymers and polyanions (e.g. polycarboxylates, polysaccharides, fully hydrolyzed polyvinyl alcohols and high-molecular polyethylene oxides). It is not applicable to polycations [e.g. polyvinylpyrrolidone, polyvinylpyridine, salts of poly(diallyl‑N,N‑dimethyl‑azacyclopentane), chitosan]. Despite good solubility in the mobile phase and even though the chromatograms obtained show good repeatability, it is possible that this method cannot be used with certain polymer types because of specific interactions (e.g. adsorption) within the sample/eluent/column system (see also Clause 12). The conditions specified in this document are not applicable to the GPC analysis of polymer samples with Mw values greater than 106 g/mol and/or polymers with elution limits outside the calibration range (see 7.6 and Annex C). This document includes no correction methods (e.g. for the elimination of peak broadening). If absolute molar mass values are required, an absolute method (e.g. membrane osmometry for Mn or light scattering for Mw) can be used.
Gel permeation chromatography (GPC) — Part 3: Water as eluent
- ICS
- 87.060.20
- CCS
- 发布
- 2022-05-12
- 实施
This document specifies a titrimetric method for determining the hydroxyl groups in resins and binders for paints and varnishes. This method is primarily suitable for neutral media. Acidic products provide higher values; neutral products provide, through neutralization of the acidic carbamates, lower values. For these products, preliminary tests are performed to ensure the applicability of the method.
Binders for paints and varnishes — Determination of hydroxyl value — Part 3: Rapid test
- ICS
- 87.060.20
- CCS
- 发布
- 2022-05-12
- 实施
This document specifies the determination of the molar-mass distribution and the average molar mass values Mn (number average) and Mw (weight average) of polymers that are soluble in DMAC (N,N-Dimethylacetamide) by gel permeation chromatography (GPC). NOTE Also known as size exclusion chromatography (SEC). Even though the chromatograms obtained show good repeatability, it is possible that this method cannot be used with certain polymer types because of specific interactions (e.g. adsorption) within the sample/eluent/column system. The conditions specified in this document are not applicable to the GPC analysis of polymer samples with Mw values greater than 106 g/mol and/or polymers with elution limits outside the calibration range (see 7.6 and Annex C). This document includes no correction method (e.g. for the elimination of peak broadening). If absolute molar mass values are required, an absolute method (e.g. membrane osmometry for Mn or light scattering for Mw) can be used.
Gel permeation chromatography (GPC) — Part 2: N,N-Dimenthylacetamide (DMAC) as eluent
- ICS
- 87.060.20
- CCS
- 发布
- 2022-05-12
- 实施
Binders for paints and varnishes — Determination of softening point — Part 2: Cup-and-ball method
- ICS
- 87.060.20
- CCS
- 发布
- 2021-12-21
- 实施
Raw, refined and boiled linseed oil for paints and varnishes —Specifications and methods of test
- ICS
- 87.060.20
- CCS
- 发布
- 2021-12-21
- 实施
Raw, refined and boiled linseed oil for paints and varnishes —Specifications and methods of test
- ICS
- 87.060.20
- CCS
- 发布
- 2021-12-21
- 实施
Binders for paints and varnishes — Determination of softening point — Part 2: Cup-and-ball method
- ICS
- 87.060.20
- CCS
- 发布
- 2021-12-21
- 实施
Binders for paints and varnishes — Determination of softening point — Part 1: Ring-and-ball method
- ICS
- 87.060.20
- CCS
- 发布
- 2021-12-21
- 实施
Binders for paints and varnishes — Determination of softening point — Part 1: Ring-and-ball method
- ICS
- 87.060.20
- CCS
- 发布
- 2021-12-21
- 实施
This document specifies the determination of the molar-mass distribution and the average molar mass values Mn (number average) and Mw (weight average) of polymers that are soluble in tetrahydrofuran (THF) by gel permeation chromatography (GPC).Even though the chromatograms obtain
Gel permeation chromatography (GPC) - Part 1: Tetrahydrofuran (THF) as eluent (ISO 13885-1:2020); German version EN ISO 13885-1:2021
- ICS
- 87.060.20
- CCS
- 发布
- 2021-11-00
- 实施
This document specifies the determination of the molar-mass distribution and the average molar mass values Mn (number average) and Mw (weight average) of polymers that are soluble in DMAC (N,N-Dimethylacetamide) by gel permeation chromatography (GPC).NOTE Also known as size exclu
Gel permeation chromatography (GPC) - Part 2: N,N-Dimenthylacetamide (DMAC) as eluent (ISO 13885-2:2020); German version EN ISO 13885-2:2021
- ICS
- 87.060.20
- CCS
- 发布
- 2021-11-00
- 实施
This document specifies the determination of the molar-mass distribution and the average molar mass values Mn (number average) and Mw (weight average) of polymers that are soluble in water by gel permeation chromatography (GPC).This method is applicable to neutral polymers and po
Gel permeation chromatography (GPC) - Part 3: Water as eluent (ISO 13885-3:2020); German version EN ISO 13885-3:2021
- ICS
- 87.060.20
- CCS
- 发布
- 2021-11-00
- 实施
Binders for paints and varnishes -- Linseed stand oil -- Requirements and methods of test (ISO 276:2019)
- ICS
- 87.060.20
- CCS
- 发布
- 2021-10-25
- 实施
- 2021-10-25
