G54 颜料 标准查询与下载

QB/T 4343-2012 合成革用水性色浆

本标准规定了合成革用水性色浆的术语和定义、要求、试验方法、检验规则、标志、包装和贮存。 本标准适用于以水为分散介质，由各种有机、无机颜料及添加剂制备而成的合成革用水性色浆。

Water based colorants for synthetic leather

ASTM D1483-12 用加纳尔.科尔曼法测定颜料的吸油量的标准试验方法

The oil absorption value obtained by this test method provides information about the vehicle demand of the pigment when it is used in a pigment paste. Oil absorption values can be used to characterize batches of a given pigment. This test method differs from Test Method D281 in that D281 requires a vigorous rubbing action whereas this test method involves only a gentle stirring and folding of the pigment. Because the end points are different, the values obtained from the two test methods generally differ.1.1 This test method covers the determination of oil absorption of pigments by the Gardner-Coleman procedure. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Oil Absorption of Pigments by Gardner-Coleman Method

KS M ISO 473:2011 色漆用锌钡白颜料.规范和试验方法

이 표준은 도료용과 관련 제품에 사용되는 두 종류의 리토폰 안료의 품질 규격과 시험방법에

Lithopone pigments for paints－Specifications and methods of test

DIN EN ISO 7579:2010 颜料.有机溶剂中溶解度的测定.重量法和光度测定法(ISO 7579-2009); 德文版本 EN ISO 7579-2009

This International Standard specifies a method for determining the solubility of dyestuffs in organic solvents. It is applicable to dyestuffs that do not change chemically under the influence of the solvent, are stable and non volatile under the specified drying conditions. For volatile solvents (boiling point lower 120 ℃) we generally recommend a gravimetric, for less volatile solvents (boiling point greater 120 ℃) a photometric procedure. The individual selection should be taken on a problem specific base. The method is suitable for concentrations between 1 g and 1000 g of dyestuff per litre of solvent. In case of higher concentration the viscosity of the test solutions must be suitable for the described procedures. The method is not suitable for the determination of insoluble matter in a dyestuff.

Dyestuffs - Determination of solubility in organic solvents - Gravimetric and photometric methods (ISO 7579:2009); German version EN ISO 7579:2009

BS EN ISO 787-7:2009 颜料和填充剂通用试验方法.筛余物的测定.水方法.人工操作程序

This part of ISO 787 specifies a general method of test for determining the residue on sieve from a sample of pigment or extender dispersed in water. ISO 787-18, General methods of test for pigments and extenders - Part 18: Determination of residue on sieve - Mechanical flushing procedure, specifies a general method of test for determining the residue on sieve from a sample of pigment or extender by a mechanical flushing procedure. For most pigments and extenders, ISO 787-7 and ISO 787-18 will usually give different results, and it is therefore essential to state clearly in a specification which method is to be used and, in the test report, which method has been used. NOTE The general methods given in the various parts of ISO 787 are usually applicable to any pigment or extender. Thus only a cross-reference to the appropriate part of ISO 787 needs to be included in the International Standard giving the specification for that pigment or extender, indicating any detailed modifications that may be needed in view of the special properties of the material in question. Only when the general methods are not applicable to a particular material should a different method for determination of residue on sieve be specified.

General methods of test for pigments and extenders - Determination of residue on sieve - Water method - Manual procedure

BS EN ISO 7579:2009 颜料.在有机溶剂中溶解度的测定.重量法和光度测定法

This International Standard specifies two methods for determining the solubility of dyestuffs in organic solvents. They are applicable to dyestuffs that do not change chemically under the influence of the solvent and are stable and non-volatile under the specified drying conditions. For volatile solvents (boiling point < 120 °C), the gravimetric procedure is recommended and, for less volatile solvents (boiling point > 120 °C), the photometric procedure is recommended. The choice of procedure should be made on a case-by-case basis. The methods are suitable for concentrations between 1 g and 1 000 g of dyestuff per litre of solvent. Higher concentrations can be used provided the viscosity of the solution is such that the procedure can be carried out readily. The methods are not suitable for the determination of insoluble matter in a dyestuff.

Dyestuffs - Determination of solubility in organic solvents - Gravimetric and photometric methods

JIS K 5906 AMD 1:2009 涂料用铝颜料(修改件1)

Aluminium pigments for paints (Amendment 1)

ASTM D5145-09 电泳涂漆液非挥发物质和颜料含量的标准试验方法

The nonvolatile content and pigment content are measures of total solids and inorganic pigment solids, respectively, in electrocoat paints. In addition to production quality control, these properties are important in maintaining electrocoat baths in the optimum range. Other test methods for determining nonvolatile content of paint and paint related materials are described in Guide D 2832.1.1 These test methods cover the characterization of electrocoat baths through the determination of nonvolatile content of inorganic pigment content. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods for Nonvolatile and Pigment Content of Electrocoat Baths

DIN EN ISO 1248:2008 氧化铁颜料.规范和试验方法

This International Standard specifies the requirements and the corresponding methods of test for all manufactured and natural iron oxide pigments, in dry form, suitable for general use. These pigments are identified by Colour Index Nos.l) red 101 and 102, yellow 42 and 43, brown 6 and 7 and black 11, and includes "rapid-dispersion pigments". This International Standard does not cover micaceous iron oxide pigments (see Note 1), transparent iron oxide pigments, granular grey iron oxide (see Note 2) or magnetic iron oxide pigments other than those of Colour Index Pigment black 11. NOTE 1 The requirements and the corresponding methods of test for micaceous iron oxide pigments are specified in ISO 10601. NOTE 2 Granular grey iron oxides are too abrasive for general use.

Iron oxide pigments - Specifications and methods of test (ISO 1248:2006, including Technical Corrigendum 1:2007); German version EN ISO 1248:2008

DIN 67510-4:2008 磷光颜料和产品.第4部分:磷光安全传导系统产品.标记和应用

Phosphorescent pigments and products - Part 4: Products for phosphorescent escape route systems - Markings and applications

HG/T 3951-2007 建筑涂料用水性色浆

本标准规定了建筑涂料用水性色浆的分类、要求、试验方法、检验规则、标志、包装和贮存等内容。 本标准适用于由各种有机颜料、无机颜料、润湿分散剂以及各种助剂配制而成的水性色浆（透明色浆除外），产品主要应用于建筑内外墙涂料。其他水性涂料用色浆也可参照使用。

Water based colorants for architectural coatings

DIN 55607:2007 颜料和填充剂.施用后粉末涂层中填充剂的分散及其比色评估

Pigments and extenders - Dispersion of pigments in powder coatings and their colorimetric evaluation after application

DIN 53583:2007 颜料的测试.用粒状炭黑颜料的磨损测定精细成分和质量磨损

Testing of pigments - Determination of fines content and of loss in mass by abrasion of pelletized carbon black pigments

BS EN ISO 10601:2007 涂料用云母铁矿颜料.规范和试验方法

Micaceous iron oxide pigments for paints - Specifications and test methods

ISO 10601:2007 涂料用云母氧化铁颜料.规范和试验方法

This International Standard specifies the requirements and corresponding test methods for manufactured and natural micaceous iron oxide (MIO) pigments, in dry form, used primarily in protective coatings for steelwork. In accordance with current practice, the general requirements for micaceous iron oxide pigments have been sub-divided to give a) those requirements that are essential (see Table 2) and b) those requirements that are conditional upon prior agreement between the interested parties (see Table 3). In certain instances, reference may be made to an agreed reference pigment.

Micaceous iron oxide pigments for paints - Specifications and test methods

ASTM D185-07 颜料中粗颗粒的标准试验方法

In production of paints, smoothness of the paint film is of paramount importance. Agglomerates or coarse particles larger than 45 μm are difficult to disperse and may prevent obtaining a smooth film. These test methods are a valuable quality control test for grading raw materials. 1.1 These test methods cover the determination of the amount of coarse particles in dry pigments.1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods for Coarse Particles in Pigments

HG/T 3852-2006 颜料筛余物测定法

本方法是指颜料通过一定孔径的筛子后，剩余物质量与试样质量之比，以百分数表示。

Determination of residue on sieve of pigments

HG/T 3853-2006 颜料干粉耐热性测定法

本方法是指颜料干粉在一定温度下，经过规定时间后，与原样比较色泽的差导师来评定耐热。以℃表示。

Determination of resistance to heat of dry power of pigments

HG/T 3854-2006 颜料流动度测定法

本方法是指颜料与调墨油经研磨后，取一定体积的色浆，在一定压力和温度下经一定时间，色浆被压成圆形，量其直径。以mm表示。

Determination of mobility of pigments

HG/T 3851-2006 颜料遮盖力测定法

本方法是指颜料和调墨油研墨成色浆，均匀地涂刷于黑白格玻璃板上，使黑白格恰好被遮盖的最小用颜料量，以g/m表示。

Determination of hiding power of pigments