共找到 478 条与 活塞式内燃机与其它动力设备综合 相关的标准,共 32 页
Diesel Engine Steady State Exhaust Smoke and Its Determination Method
本标准规定用加热型氢火焰离子化法,连续测定柴油机在稳定工况下排气中总碳氢化合物的浓度.
Diesel engine emissions--Determination of total hydrocarbons--Hydrogen flame ionization method(HFID)
本标准规定了一般用途的往复活塞式柴油机和汽油机的台架性能试验方法。
Performance test methods for reciprocating internal combustion engine--Test methods
本标准规定了一般用途的往复活塞式柴油机和汽油机的标准环境状况及功率、燃油消耗和机油消耗的标定方法。
Performance test methods for reciprocating internal combustion engine--Standard ambient conditions and declarations of power, fuel consumption and lubricating oil consumption
本标准规定了中小功率柴油机台架试验时的整机振动测量方法。
Measurement method of vibration for small and medium power diesel engines
Green Design Product Evaluation Technical Specification Diesel Engine
Diesel engines -- NOx reduction agent AUS 32 -- Part 3: Handling, transportation, and storage
Diesel engines -- NOx reduction agent AUS 32 -- Part 1: Quality requirements
Diesel engines -- NOx reduction agent AUS 32 -- Part 2: Test methods
Diesel engine full speed and full load test method
Diesel engine full speed overload test method
Specification for failure evaluation of diesel engine parts
Diesel engine full speed and full load test method
Diesel engine full speed overload test method
Specification for failure evaluation of diesel engine parts
Diesel engine thermal shock test method
This document specifies a data format for reporting the measurement results of exhaust emissions from RIC engines for mobile, transportable and stationary use, excluding engines for motor vehicles primarily designed for road use. It includes basic information of the engine being tested. Equivalent data formats including those that are electronically generated can be used as long as the required engine, test cell and test data information is made available. This document applies to measurement in the laboratory and, where applicable, at site. For engines used in machinery covered by additional requirements (e.g. occupational health and safety regulations, dust regulations for powerplants), additional test conditions and special evaluation methods can apply. NOTE Since the report format defined in this document is intended to be applicable to all types of internal combustion engines, some items are, in certain cases, not necessary for specific engines and/or tests, especially when measuring on site. On the other hand, some additional items can be necessary according to test purposes. Deletion and addition of items to be reported are based on agreement between the parties involved.
Reciprocating internal combustion engines - Exhaust emission measurement - Part 6: Report of measuring results and test
General technical conditions for gas pretreatment of gas internal combustion power generation units
Reciprocating internal combustion engines. Vocabulary. Terms for engine design and operation
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号