共找到 589 条与 绝缘子 相关的标准,共 40 页
Technical specifications for the manufacture of semiconducting glazes for electric porcelain
Definition, test method and criterion of impact breakdown test in air for high voltage line insulators
Technical requirements, test methods and interface evaluation of composite insulator interface characteristics for high voltage AC and DC systems
Specifications for construction, operation and maintenance of post insulators for AC and DC systems
10kV~35kV Line Post Composite Insulator Technical Specifications
On-site pollution degree measurement and assessment part 4: test salt density correction method for natural pollution
Post Composite Insulators for Power System Stations--Definition, Test Methods and Acceptance Criteria
Measurement and evaluation method of hydrophobicity of high voltage polymer insulators for AC and DC systems
Technical specifications for cores for AC and DC composite insulators
Specifications for zero-value high-voltage shock testing of disc-shaped suspension porcelain insulators
Insulators for overhead lines with a nominal voltage above 1 000 V. Ceramic insulators for AC systems. Characteristics of insulator units of the long rod type
This International Standard is applicable to string insulator units of the long rod type with insulating parts of ceramic material intended for use in AC overhead power lines with a nominal voltage greater than 1000 V and a frequency not greater than 100 Hz. It is also applicable
Insulators for overhead lines with a nominal voltage above 1000 V - Ceramic insulators for AC systems - Characteristics of insulator units of the long rod type
Guide on the Selection of Transmission and Distribution Insulators with Respect to Cold Weather Conditions
Technical requirements for inspection of complete sets of equipment for the imported electronics and electrical industry Part 6: Special equipment for manufacturing ceramic insulators
本标准规定了绝缘子用常温固化硅橡胶防污闪涂料(简称RTV)的基本技术要求、检验规则、包装与贮存、选用原则、验收、施工、运行维护和技术管理等。 本标准适用于交流系统额定电压高于1000V、环境温度-40℃~+40℃、污秽条件下运行绝缘子使用的RTV涂料。 本标准可参照用于直流系统。
Room temperature vulcanized silicon rubber anti-pollution coating for insulators
Guidelines for the use of long rod-shaped porcelain insulator string components for AC and DC overhead lines
Guidelines for the use of insulators for overhead lines with nominal voltages above 1000V Part 4: Rod suspension composite insulators for DC systems
Guidelines for the use of insulators for overhead lines with nominal voltages above 1000V Part 1: Porcelain or glass insulators for AC systems
Management specification for construction, operation and maintenance of high voltage AC and DC hollow composite insulators
This part of IEC 61466 is applicable to composite string insulators units with a specified mechanical load (SML) of 40 kN and 70 kN to 600 kN for AC overhead distribution lines with a nominal voltage greater than 1000 V and a frequency not greater than 100 Hz. It also applies to insulators of similar design used in substations or on electric traction lines for railway applications. This standard applies to string insulator units of composite type with couplings fittings in accordance with IEC 61466-1. This standard prescribes specified specifies values for electrical and dimensional characteristics of for composite string insulators units for overhead distribution lines with a highest minimum lightning impulse withstand voltage (BIL) level of 325 kV up to 3100 kV and a specified mechanical load (SML) of 40 kN and 70 kN to 600 kN. NOTE General definitions and methods of testing are given in IEC 61109.
Composite string insulator units for overhead lines with a nominal voltage greater than 1000 V - Part 2: Dimensional and electrical characteristics
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号