L86 通用电子测量仪器设备及系统 标准查询与下载

AIA/NAS NASM28728/3-2001 FSC 5355型同中心(内径1.810)多圈旋转计数器控制器

Dial, Control, Multiturn Counters, 10 - Turn Counter, Concentric (1.810 - Inch Diameter) FSC 5355

Dial, Control, Multiturn Counters, 10 - Turn Counter, Concentric (1.810 - Inch Diameter)

AIA/NAS NASM28728-2001 FSC 5355型多圈转盘计数器控制器

NAM13 12-105, “Fastener Test Methods Method 105 Stress Durability” was adopted on 29 August 1997 for use by the Department of Defense @OD). Proposed changes by DoD activities must be submitted to the DoD Adopting Activity: Commander, Naval Air Warfare Center Aircraft Division, Code 4141OOB120-3 Highway 547, Lakehurst, NJ 08733-5100. DoD activities may obtain copies of this standard fi-om the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 191 11-5094. The private sector and other Government agencies may purchase copies fi-om the Aerospace Industries Association, 1250 Eye Street NW, Washington, DC 20005.

Dial, Control, Multi-Turn Counters General Specifcation for

NAVY QPL-24021-18-2001 飞机外部电力监视器

This list has been prepared for use by or for the Government in the acquisition of products covered by the subject specification and such listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense. All products listed herein have been qualified under the requirements for the product as specified in the latest effective issue of the applicable specification. This list is subject to change without notice; revision or amendment of this list will be issued as necessary. The listing of a product does not release or otherwise affect the obligation of the manufacturer to comply with the specification requirements.

ELECTRIC POWER MONITORS, EXTERNAL, AIRCRAFT

JEDEC JESD22-A109-A-2001 气密性

The purpose of this test is to determine the effectiveness of the seal of hermetically sealed solid-state devices.

Hermeticity

JEDEC JESD35-A-2001 薄电介质的Wafer-Level测试程序

The thin dielectric integrity of MOS devices and circuits is an important reliability concern. Historically, thin oxide reliability has been driven by oxide defects. In general the intrinsic oxide lifetime is much longer than the use requirements, but defects can significantly reduce oxide lifetime. The procedures described herein were developed to estimate the integrity of a thin oxide and as a tool for driving constant improvement in the thin oxide process.

Procedure for the Wafer-Level Testing of Thin Dielectrics

AIR FORCE A-A-59707-2001 探测器/监视器,肼

This commercial item description covers a continuous detector/monitor of toxic amounts of hydrazine vapors in open and enclosed areas. The detector is intended for bench top use to monitor the level of hydrazine present in working environments when serv

DETECTOR/MONITOR, HYDRAZINE

JEDEC JESD51-9-2000 区域排列表面安装包装热测量的测试板

This specification is meant to be broad enough to incorporate a wide variety of surface mount area array package (e.g., BGA) design features and technologies. However, due to a limited number of signal layers that results in shorting some device pins in this specification, the boards described here may not be adequate for measurement of active devices as compared to applications with thermal test chips.

Test Boards for Area Array Surface Mount Package Thermal Measurements

YD/T 1068-2000 手持式光功率计技术条件

本标准规定了手持式光功率计的技术要求、试验方法、检验规则、包装、运输、标志、储存。 本标准适用于光纤通信和其他光纤技术测量光功率的光电型手持式光功率计。

Technical requirements for portable optical power meter

ECA EIA-540CAAD-A-1999 双极 5A 继电器插孔的详细规范

Information on the avail ability of components qualified to this specification is given in the Qualified Products List .

Detail Specification for 2 Pole, 5 A Relay Sockets

ECA EIA-540CAAE-A-1999 三极 10A 继电器插孔的详细规范

Diallyl phthalate or high temperature thermoplastic material meeting all requirements of this specification.

Detail Specification for 3 Pole, 10 A Relay Sockets

NAVY MIL-PRF-24021 K-1998 飞机外部电子监视器

This specification covers electric power monitors which are installed in aircraft to monitor external electric power to prevent power outside the limits of this specification from being applied to equipment in the aircraft.

ELECTRIC POWER MONITORS, EXTERNAL, AIRCRAFT [Use In Lieu Of: NAVY MIL-E-0024021 H]

SJ 20672-1998 电磁屏蔽衬垫屏蔽质量的测量方法

Measuring methods for shielding quality of electromagnetic shielding gaskets

IPC TM-650 5.5.1.3-1998 IPC-B-25 - 多用途测试板-1组和2组

This specification covers qualification and performance of rigid printed boards. The printed board may be single-sided, double-sided, with or without plated-through holes. The printed board may be multilayer with plated-through holes and with or without buried/blind vias. The printed board may be multilayer containing build up HDI layers conforming to IPC-6016. The printed board may contain active embedded passive circuitry with distributive capacitive planes, capacitive or resistive components. The printed board may contain a metal core or external metal heat frame, which may be active or nonactive. Revision level changes are described in 1.6.

IPC-B-25 - Multipurpose Test Board - Side 1 and Side 2

ECA 540CAAC-A-1998 双极10A继电器插座的详细规

This Specification does not purport to address all safety problems associated with its use or all applicable regulatory requirements. It is the responsibility of the user of this Specification to establish appropriate safety and health practices and to de

Detail Specification for 2 Pole, 10 A Relay Sockets

NAVY MIL-R-23761 B NOTICE 1-1997 飞机直流发电机控制面板及电压监视器的一般规定

This notice should be filed in front of MIL-R-23761B7 dated 1 October 1975

REGULATORS, VOLTAGE, AND CONTROL PANELS AIRCRAFT DIRECT CURRENT GENERATOR, GENERAL SPECIFICATION FOR

SJ 20626-1997 可携式短波测频接收机通用规范

本规范规定了可携式短波测频接收机的要求、质量保证规定、交货准备和说明事项等内容。 本规范适用于可携式短波测频接收机。也适用于车载式短波测频接收机。

General specification for the portable short-wave receivers with frequency measurement

SJ 20627-1997 军用射频合成信号发生器通用规范

本规范规定了军用射频合成信号发生器的要求、质量保证规定和交货准备等。 本规范适用于军用射频合成信号发生器。

General specification for military synthseized RF signal generator

ECA SP3116-A-1997 双列内存插槽,1.27毫米间距,垂直膜的详细规范.评论截止日期1997年7月8号EIA-540FAAE

The DIMM Socket covered by this Detail Specification shall have Maximum enclosure dimensions as shown in figures 1,2, 3

Detail Specification for Dual In-Line Memory Module (DIMM) Sockets, 1.27 mm Pitch, Vertical Mount Comment Period Expires: July 8, 1997; EIA-540FAAE

ECA 699-1997 石英晶体协振器视觉检验的试验方法

This document provides nomenclature, methods, and criteria for characterizing acceptable quartz resonator blanks. Its major objective is to aid in the evaluation of the crystal blank through visual inspection of quartz crystal resonator blanks for the pur

Test Method for the Visual Inspection of Quartz Crystal Resonator Blanks

SJ/T 10690-1996 数字直流微电阻测量仪通用规范

本规范规定了数字直流微电阻测量仪的要求、试验方法、检验规则和标志、包装、运输、贮存等要求。 本规范适用于数字直流微电阻测量仪。

General specification for digital directcurrent micro resistance measuring instruments