共找到 133 条与 工业建筑工程 相关的标准,共 9 页
本标准规定了后方军械仓库储存区、作业区的防雷技术要求. 本标准适用于后方军械仓库储存区、作业区的防雷安全建设与管理。
Technical specification for protecting rear ordnance depots against lightning
本标准规定了后方军械仓库的防盗等级与抗破坏能力、防盗措施与设施设备等防盗技术要求。 本标准适用于后方军械仓库储存区、作业区的防盗安全建设和技术管理。
Technical specification of the thief resistant for rear ordnance depots
本规范适用于新建、扩建和改建加气站工程的设计。
Design code of liquefied petroleum gas fueling station for vehicle
本规范适用于工作压力不大于25MPa(表压),新建、扩建或改建的汽车用压缩天然气固定式加气站的工程设计。
Design code for compressed natural gas fueling station for vehicle
Inspection - Acception Regulation and Quality Evaluation Standard of Engineering Survey
Specifies methods of sampling, preparation and physical testing of mortars for bricklaying, screeding, plastering and rendering. Not applicable to mortars containing high alumina cement.
Methods of testing mortars, screeds and plasters - Physical testing
This British Standard gives recommendations on operations prior to entry into a silo, bunker, bin or hopper; safety and access equipment for use therein; means of access; and safety precautions when working in, and affecting rescue from, a silo, bunker, bin or hopper. NOTE 1. Statutory provisions covering safe means of access to elevated and confined working spaces are contained in the Mines and Quarries Act 1954 [1], the Factories Act 1961 [2] and regulations made under these. The Health and Safety at Work etc. Act 1974 [3] and regulations made under this have general requirements for safe systems of work including means of access and egress.
Code of practice for safe entry into silos
History: 4.1.1 For many years, brick liners have been used with an excellent record of performance. For the most part, however, the design and construction of brick liners has been based on past industry practice due to the lack of available information and knowledge of the physical properties of the brick and mortar, the thermal and seismic behavior of brick liners, and many related characteristics that were not properly or accurately defined. 4.1.2 The use of scrubbers, which lower gas temperatures and introduce highly corrosive condensates into the flue gas system, requires many new design considerations. The effect that scrubbers have on brick liners is an ongoing area of study, since a number of liners have experienced growth- and deflection-related problems which may be attributable, at least in part, to nonuniform temperature and moisture conditions within the liners. Purpose8212;The recommendations contained herein represent current industry practices and serve to define the pertinent considerations that should be followed in the design and construction of brick chimney liners.1.1 This guide covers procedures for the design, construction, and serviceability of brick liners for industrial chimneys. The structural design criteria are applicable to vertical masonry cantilever structures supported only at their base, either by a foundation, a concrete pedestal, or by some means from the outer concrete shell. Excluded from direct consideration are single-wythe, sectional brick linings that are supported on a series of corbels cast in the outer chimney shell. 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Guide for Design and Construction of Brick Liners for Industrial Chimneys
本规程适用于高度为450m以下的混凝土电视塔施工。 本规程未涉及事项,仍须遵守现行有关工程建设规范及有关规定。
CONSTRUCTION TECHNOLOGY RULES FOR CONCRETE TELEVISION TOWER
Formulation and installation. Materials based on refractory aggregates and calcium aluminate cement. Installation by gunning or casting. To be read in conjunction with BS 4076
Code of practice for the installation of monolithic linings for steel chimneys and flues
1.1.1 为使商业仓库设计更好地满足商品储存需要,充分发挥仓库使用功能和投资效益,符合适用、安全、消防等基本要求,特制定本设计规范。 1.1.2 本规范适用于新建扩建的普通商业仓库。不包括粮库、冷库和危险品仓库。 1.1.3 本规范为普通商业仓库的设计准则。在设计中,除执行本规范外,还应遵守有关设计规范的规定。
Code for design of commercial warehouse
Industrial construction; traffic ways in industrial buildings; regulations
This standard gives recommendations for the planning of and requirements for traffic ways (for pedestrians and vehicles) in industrial buildings.
Industrial construction; traffic ways in industrial buildings
Настоящий стандарт распространяется на мобильные здания, соответствующие требования, и устанавливает номенклатуру показателей качества
Product. Quality ratings system. Building. Mobile buildings. Nomenclature of characteristics
Design rules for foundation deformation of chemical buildings (structures)
Technical regulations for the installation of column-supported cone-roof large steel storage tanks
Welding process regulations for mechanical welding in chemical industry construction
Technical regulations for control and treatment of construction defects of reinforced concrete pools
Code for design of warehouse of material and equipments
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号