U60 船舶电气、观通、导航设备综合 标准查询与下载

SAE J378-2011 船用推进系统的布线

This SAE Recommended Practice covers the requirements for all marine inboard engine wiring, wiring assemblies, wiring components, and wiring connectors connected to microprocessors associated with the operation of the propulsion system operating at 50 V or less. EXCEPTION: Outboard engines and engines in Personal Water Craft (PWC). NOTE: See ABYC E11 for additional requirements related to electrical installations on small craft. The purpose of this document is to insure that electrical and electronic wiring and wiring components used in a marine propulsion system meet the necessary safety and performance requirements based upon the marine mechanical and electrical environment. The recommendations include methods that may be employed by manufacturers to minimize the possibility that engine wiring may be a source of ignition of explosive or flammable vapors and provide manufacturers installing engine electrical systems sufficient information to design and develop engine wiring harnesses for marine usage.

Marine Propulsion System Wiring

SC/T 8012-2011 渔业船舶无线电通信、航行及信号设备配备要求

本标准规定了渔业船舶无线电通信、航行及信号设备配备的基本要求。 本标准适用于新建或改建的12m以上具有固定连续甲板的渔业船舶无线电通信、航行及信号设备的配备。

Outfit requirements about radio communication,navigation and signal equipment onboard a fishing vessel

IEC 60092-353:2011 船舶内电气安装.第353部分:额定电压为1 kV和3 kV的电力电缆

Scope and object This part of the IEC 60092 series is applicable to shipboard and offshore non radial field power cables with extruded solid insulation@ having a voltage rating of 0@6/1 (1@2) kV and 1@8/3 (3@6) kV intended for fixed installations. Cables for use in circuits requiring resistance to fire are included. The various types of power cables are given in 5.1. The constructional requirements and test methods shall comply with those indicated in IEC 60092-350@ unless otherwise specified in this standard. The object of this standard is: ?C to standardize cables whose safety and reliability is ensured when they are installed in accordance with the requirements of IEC 60092-352 or IEC 61892-4; ?C to lay down standard manufacturing requirements and characteristics of such cables directly or indirectly bearing on safety; ?C to specify test methods for checking conformity with those requirements.

Electrical installations in ships - Part 353: Power cables for rated voltages 1 kV and 3 kV

BS IEC 60092-509:2011 船上电气装置.电气装置操作

Electrical installations in ships. Operation of electrical installations

CB/T 4146-2011 船用计算机及外设 船用环境适用基本准则

本标准规定了船上用于控制及监视的计算机及其外设的重要程度分类、使用条件下的环境等级以及相应的环境试验方法。 本标准适用于船上法规和船级社规范明确规定要求以外的设备。

Marine computers and their peripherals.Environmental conditions criteria in ships

DIN CLC/TS 50534:2011 轨道交通.船上电气辅助动力系统用通用系统架构.德文版本CLC/TS 50534-2010

Railway applications - Generic system architectures for onboard electric auxilary power systems; German version CLC/TS 50534:2010

IEC 62613-1:2011 高压海岸连接系统(HVSC-系统)用船用耦合器,插座引线和插头.第1部分:一般要求

"This part of IEC 62613 applies to accessories with ? three phases (3 poles and Earth) with up to three pilot contacts@ ? one single pole (Neutral). These accessories have rated currents not exceeding 500 A and rated operating voltages not exceeding 12 kV 50/60 Hz. NOTE 1 In the USA@ the term ""Ground"" is used instead of ""Earth"". These accessories are primarily intended for use outdoors@ in a seawater environment@ for the shore supply of ships (ship-to-shore connection)@ in an ambient temperature within the range of -25 ??to +45 ?? NOTE 2 In some countries@ other ambient temperatures may prevail and may need to be taken into account. These accessories are not intended for use in hazardous areas. In such locations where special conditions prevail@ additional requirements may be necessary. These accessories are intended to be connected to cables of copper or copper alloy only. Socket-outlets or ship inlets incorporated in or fixed to electrical equipment are within the scope of this standard."

Plugs, socket-outlets and ship couplers for high-voltage shore connection systems (HVSC-systems) - Part 1: General requirements

SAE J1171-2011 船舶电气设备的外部点火保护

This SAE Recommended Practice covers all electrical devices suitable for use in marine engine compartments and fuel tank spaces. To recommend a test procedure for certifying the External Ignition Protection of electrical devices used on boats.

External Ignition Protection of Marine Electrical Devices

BS EN 62287-1:2011+A1:2014 海洋导航和无线电通信设备和系统.自动识别系统(AIS)的B级船载设备.载波监听分时多路访问(CSTDMA)技术

Maritime navigation and radiocommunication equipment and systems. Class B shipborne equipment of the automatic identification system (AIS). Carrier-sense time division multiple access (CSTDMA) techniques

BS EN 62287-1:2011 海洋导航和无线电通信设备和系统.自动识别系统(AIS)的B级船载设备.载波监听分时多路访问(CSTDMA)技术

Maritime navigation and radiocommunication equipment and systems. Class B shipborne equipment of the automatic identification system (AIS). Carrier-sense time division multiple access (CSTDMA) techniques

BS EN 61162-1:2011 海洋导航和无线电通信设备和系统.数字接口.单通话器和多受话器

Maritime navigation and radiocommunication equipment and systems. Digital interfaces. Single talker and multiple listeners

ANSI/IEEE 45.2:2011 船舶上电气装置的推荐实施规程.控制和自动化

Recommended Practice for Electrical Installations on Shipboard - Controls and Automation

IEEE 45.2-2011 船舶上电气装置的推荐实施规程.控制和自动化

Recommended Practice for Electrical Installations on Shipboard - Controls and Automation

IEC 61892-5:2010 移动式及固定式近海装置.电气装置.第5部分:移动装置

This part of IEC 61892 specifies the characteristics for electrical installations in mobile units, for use during transfer from one location to another and for use during the exploration and exploitation of petroleum resources. It applies to all installations, whether permanent, temporary, transportable or hand-held, to a.c. installations up to and including 35 000 V and d.c. installations up to and including 1500 V.(a.c. and d.c. voltages are nominal values).

Mobile and fixed offshore units - Electrical installations - Part 5: Mobile units

IEC 61892-1:2010 移动式及固定式近海装置.电气装置.第1部分:一般要求和条件

This part of IEC 61892 series contains provisions for electrical installations in mobile and fixed offshore units including pipeline, pumping or 'pigging' stations, compressor stations and exposed location single buoy moorings, used in the offshore petroleum industry for drilling, processing and storage purposes. This International Standard applies to all installations, whether permanent, temporary, transportable or hand-held, to a.c. installations up to and including 35 000 V and d.c. installations up to and including 1 500 V (a.c. and d.c. voltages are nominal values). This standard does not apply either to fixed equipment for medical purposes or to the electrical installations of tankers.

Mobile and fixed offshore units - Electrical installations - Part 1: General requirements and conditions

JIS F 8007 ERRATUM 1:2010 勘误表

ERRATUM

DIN EN 60945 Berichtigung 1:2010 海上航行无线电通讯设备及系统.一般要求.试验方法及要求的试验结果(IEC 60945-2002).德文版本EN 60945-2002.勘误表DIN EN 60945-2003

Corrigendum 1 to DIN EN 60945:2003-07.

Maritime navigation and radiocommunication equipment and systems - General requirements - Methods of testing and required test results (IEC 60945:2002); German version EN 60945:2002); Corrigendum to DIN EN 60945:2003-07

JIS F 0808:2009 船舶和海洋技术.电气设备.环境试验程序的一般要求

Ships and marine technology -- Electrical apparatus -- General requirements for environmental test procedure

IEC 62320-1:2009 海上导航和无线电通信设备和系统.自动识别系统(AIS).第1部分:AIS基站.最低限度和性能要求,试验方法和要求的试验结果

Maritime navigation and radiocommunication equipment and systems - Automatic identification systems (AIS) - Part 1: AIS Base Stations - Minimum operational and performance requirements, methods of testing and required test results

DIN EN 61174:2009 海上导航和无线电通信设备及系统.电子图表显示和信息系统(ECDIS).操作和性能要求、测试方法及要求的试验结果

This International Standard specifies the performance requirements, methods of testing and required test results of equipment conforming to performance standards not inferior to those adopted by the IMO in resolution MSC.232(82). This standard is based upon the performance standards of IMO resolution MSC.232(82), and is also associated with IMO resolution A.694(17) and IEC 60945. Reference is made, where appropriate, to IMO resolution MSC.232(82), and all subclauses whose wording is identical to that in the resolution are printed in italics. In association with the above IMO resolution MSC.232(82), are the International Hydrographic Organization (IHO) special publications S-32, S-52, S-57, S-61, S-63 and S-64. This standard has included extracts from the above publications where they are applicable to this equipment. Where reference is made, all subclauses whose wording is identical to that in the publications, are printed in italics. (232/A2.1) These performance standards should apply to all ECDIS equipment carried on all ships as follows: - dedicated standalone workstation. - a multifunction workstation as part of an INS. (232/A2.2) These performance standards apply to ECDIS mode of operation, ECDIS in RCDS mode of operation as specified in Annex G and ECDIS backup arrangements as specified in Annex F. (232/A2.3) Requirements for structure and format of the chart data, encryption of chart data as well as the presentation of chart data are within the scope of relevant IHO standards, including those listed in the normative references. The requirements of this standard are not intended to prevent the use of new techniques in equipment and systems, provided the facilities offered are not inferior to those stated.

Maritime navigation and radiocommunication equipment and systems - Electronic chart display and information system (ECDIS) - Operational and performance requirements, methods of testing and required test results (IEC 61174:2008); English version EN 61174: