Y44 其他日用化工品 标准查询与下载

GB/T 13217.4-1991 凹版塑料油墨检验方法 粘度检验

本标准规定了凹版塑料油墨粘度的检验方法。 本标准适用于凹版塑料油墨粘度的检验。

Test method for viscosity of plastics gravure printing inks

GB/T 13217.3-1991 凹版塑料油墨检验方法 细度检验

本标准规定了凹版塑料油墨细度的检验方法。 本标准适用于凹版塑料油墨细度的检验。

Test method for fineness of grind of plastics gravure printing inks

GB/T 9104.3-1988 工业硬脂酸试验方法 酸值的测定

本标准规定了工业硬脂酸酸值的测定方法。 本标准适用于由动植物油脂经水解后用压榨法或蒸馏法精制生产的工业用硬脂酸酸值的测定。

The test methods for industrial stearic acids--Determination of acid value

GB/T 9104.9-1988 工业硬脂酸试验方法 组成的测定

本标准规定了用气液色谱法测定工业硬脂酸组成的方法。 本标准适用于工业硬脂酸组成的测定。

The test methods for industrial stearic acids--Determination of components

GB/T 9104.8-1988 工业硬脂酸试验方法 灰分的测定

本标准规定了工业硬脂酸中灰分的测定方法。 本标准适用于由动植物油脂经水解后，用压榨法或蒸馏法生产的工业用硬脂酸灰分的测定。

The test methods for industrial stearic acids--Determination of ash

GB/T 9104.2-1988 工业硬脂酸试验方法 皂化值的测定

本标准规定了工业硬脂酸皂化值的测定方法。 本标准适用于由动植物油脂经水解后用压榨法或蒸馏法生产的工业用硬脂酸皂化值的测定。

The test methods for industrial stearic acids--Determination of saponification value

GB/T 9104.7-1988 工业硬脂酸试验方法 无机酸的测定

本标准规定了工业硬脂酸中无机酸的测定方法。 本标准适用于由动植物油脂经水解后，用压榨法或蒸馏法生产的工业用硬脂酸中无机酸的测定。

The test methods for industrial stearic acids--Determination of inorganic acid

GB/T 9104.6-1988 工业硬脂酸试验方法 水分的测定

本标准规定了工业硬脂酸中水分的测定方法。 本标准适用于由动植物油脂经水解后，用压榨法或蒸馏法生产的工业硬脂酸中水分的测定。不适用于含十二烷酸以下的脂肪酸。

The test methods for industrial stearic acids--Determination of water content

GB/T 9104.1-1988 工业硬脂酸试验方法 碘值的测定

本标准规定了工业硬脂酸碘值的测定方法。 本标准适用于由动植物油脂经水解后用压榨法或蒸馏法精制生产的工业用硬脂酸的碘值的测定。

The test methods for industrial stearic acids--Determination of iodine value

GB/T 9104.5-1988 工业硬脂酸试验方法 凝固点的测定

本标准规定了工业硬脂酸凝固点的测定方法。 本标准适用于由动植物油脂经水解后用压榨法或蒸馏法生产的工业用硬脂酸的凝固点的测定。

The test methods for industrial stearic acids--Determination of titer

GB/T 9104.4-1988 工业硬脂酸试验方法 色泽的测定

本标准规定了用铂-钴色号分光光度法测定工业硬脂酸色泽的方法。

The test methods for industrial stearic acids--Determination of colour

GB/T 9103-1988 工业硬脂酸

本标准规定了工业硬脂酸的技术条件、试验方法、检验规则及包装要求、贮存条件等。 本标准适用于由动物、植物油脂经水解后加工精制而成的工业硬脂酸（主要成分为十八烷酸和十六烷酸）。供化妆品、橡胶、金属盐、印染和精密铸造等工业使用。

Industrial stearic acids

NF T72-700*NF EN 13623:2020 化学消毒剂和防腐剂. 水溶液系统使用的化学消毒剂的抗军团杆菌杀菌活性的评定用定量悬浮试验. 要求和试验方法(相位2,阶1).

Domaine d'applicationLe présent document décrit une méthode d'essai et les prescriptions minimales relatives à l'activité bactéricide des produits désinfectants chimiques destinés au traitement des systèmes aqueux vis-à-vis de Legionella pneumophila et donnant une préparation hom

Chemical disinfectants and antiseptics - Quantitative suspension test for the evaluation of bactericidal activity against Legionella of chemical disinfectants for aqueous systems - Test method and requirements (phase 2, step 1)

ASTM D1793-17 乳化地板抛光剂水斑的标准试验方法

4.1 This test method measures the ability of a floor polish to resist spotting by water. This test method may be used to measure the extent of damage by a large amount of water or in a separate method to measure the amount of damage by a small amount of water that has evaporated to dryness. Reference polishes should be used for comparison. Note 1: The test method may induce slight whitening, color change, noticeable change in appearance, including removal of the film, which is caused by contact with water. 1.1 This test method covers the determination of water spotting resistance of water emulsion floor polishes. The test method approximates the actual conditions of water spotting encountered in service. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Water Spotting of Emulsion Floor Polishes

ASTM D1436-17 乳化地板抛光剂对试验用基片的应用的标准试验方法

2.1 All five of the test methods described will produce polish films from emulsion floor polishes which can be used for various performance tests. The choice of test method is left up to the individual laboratory. 1.1 These test methods cover procedures for application of emulsion floor polish films to suitable substrates for testing purposes. Five test methods are covered, as outlined in Section 3. 1.2 These procedures are limited to use on flat, rigid substrates mounted, if necessary, on a nonabsorbent backing. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Methods for Application of Emulsion Floor Polishes to Substrates for Testing Purposes

ASTM D1792-17 乳化地板擦亮剂长期可除污性的标准试验方法

4.1 This test method is used to predict removability of floor polish after a treatment period that simulates aging in the field. It allows for uniform mechanical and detergent action leaving the only variable the actual removability of the polish. 1.1 This test method covers the determination of the relative ease of removal of dried films of water-emulsion floor polishes from common flooring substrates under accelerated conditions, which correspond to extended service aging. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Long-Term Removability Properties of Emulsion Floor Polishes

ASTM D1455-17 乳化地板抛光剂60度镜面光泽度的标准试验方法

4.1 This test method may be used to evaluate the difference in gloss of dried films of emulsion floor polishes when the light reflected at a 60° angle is measured. Extremely high- or low-gloss polishes may not be differentiated at a 60° angle. A20° angle measured in accordance with Test Method D523 may give better definition of gloss. 1.1 This test method covers the determination of the 60° specular gloss of films of emulsion floor polish after application to a substrate. Note 1: Specular gloss is one of several related appearance attributes that produce the sensation of glossiness. For this reason, specular gloss measurements may not always correlate well with visual rankings of glossiness. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for 60&xb0; Specular Gloss of Emulsion Floor Polish

JIS K 3920 ERRATUM 1:2016 勘误

ERRATUM

EN 14885:2015 化学消毒剂和防腐剂.化学消毒剂和防腐剂欧洲标准的应用

This European Standard specifies the European Standards to which products have to conform in order to support the claims for microbicidal activity which are referred to in this European Standard. This European Standard also specifies terms and definitions which are used in European Standards. It is applicable to products for which activity is claimed against the following microorganisms: vegetative bacteria (including mycobacteria and Legionella), bacterial spores, yeasts, fungal spores and viruses (including bacteriophages). It is intended to: a) enable manufacturers of products to select the appropriate standards to be used in order to provide data which support their claims for a specific product; b) enable users of the product to assess the information provided by the manufacturer in relation to the use for which they intend to use the product; c) assist regulatory authorities in assessing claims made by the manufacturer or by the person responsible for placing the product on the market. It is applicable to products to be used in the area of human medicine, the veterinary area and in food, industrial, domestic and institutional areas. In the area of human medicine, it is applicable to chemical disinfectants and antiseptics to be used in areas and situations where disinfection or antisepsis is medically indicated. Such indications occur in patient care, in hospitals, in community medical facilities and dental institutions; - in clinics of schools, of kindergartens and of nursing homes; - and may also occur in the workplace and in the home. It may also include services such as in laundries and kitchens supplying products directly for the patient. In the veterinary area it is applicable to chemical disinfectants and antiseptics to be used in the areas of breeding, husbandry, production, transport and disposal of animals. It is not applicable to chemical disinfectants used in the food chain following death and entry to the processing industry. In food, industrial, domestic and institutional areas it is applicable to chemical disinfectants and antiseptics to be used in processing, distribution and retailing of food of animal or vegetable origin. It is also applicable to products for all public areas where disinfection is not medically indicated (homes, catering, schools, nurseries, transports, hotels, offices etc.) and products used in packaging, biotechnology, pharmaceutical, cosmetic etc. industries. This European Standard is also applicable to active substances and products under development for which no area of application has yet been specified. This European Standard does not refer to methods for testing the toxicological and ecotoxicological properties of products or active substances.

Chemical disinfectants and antiseptics - Application of European Standards for chemical disinfectants and antiseptics

UL 283-2015 空气清新剂和除臭剂UL安全标准(第3版)

UL Standards for Safety Air Fresheners and Deodorizers (Third Edition; Reprint with Revisions Through and Including December 16, 2016)