共找到 223 条与 其他日用化工品 相关的标准,共 15 页
This practice defines the properties to be tested, the apparatus to be used, and the comparisons of product performance. It is recognized that considerable discretion exists among formulators and marketers of furniture polish on which properties or performance characteristics are best for their products. This practice will be flexible to honor this fact within the confines of the furniture polish definition below. The methods of testing are subjective and empirical in order to conform to the basic characteristics of the industry and to allow flexibility in testing.1.1 This practice covers the definition of properties to test and the apparatus to use in evaluating the performance of furniture polishes. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Evaluation of Furniture Polish
This Standard specifies the test methods for floor polishes.
Test methods for floor polishes
This translation has been made based on the Amendment to the origi- nal Japanese Industrial Standard revised by the Minister of Economy, Trade and Industry through deliberations at the Japanese Industrial Standards Committee as the result of proposal for revision of Japanese Industrial Standard with the draft being attached, based on the provi- sion of Article 12 Clause 1 of the Industrial Standardization Law ap- plicable to the case of revision by the provision of Article 14. Consequently, JIS K 3901:1992 is partially replaced with this Amend- ment.
Shoe polish (Amendment 1)
The methods outlined in this guide can be used to qualitatively and quantitatively describe the sensory characteristics and performance of trigger hard surface household cleaning products for nonporous surfaces. The methods are suited for descriptive analysis and may be adaptable for consumer acceptance research. This guide provides the procedure for the evaluation of package, application, performance, after-use and fragrance aspects of hard surface cleaners. Depending on the test objectives, all or some of these measures may be used. This guide, as defined by ASTM, is designed for use for product research guidance in product formulation, new product development, and quality control issues. This guide is a compendium of information or series of options that does not recommend a specific course of action. This guide is not intended for claim substantiation, as it has not been subjected to validation testing. This guide is for use by individuals who familiarize themselves with these procedures and who have previous experience with sensory evaluations. It is suggested that the individuals have some experience with developing and training a descriptive panel or work under the supervision of a sensory professional who has. This guide might involve hazardous materials. This guide does not claim to address all of the safety problems associated with its use. It is the responsibility of the user of this guide to establish appropriate safety and healthy practices and to determine the applicability of limitations prior to use.1.1 This guide presents guidelines specific to the sensory evaluation of trigger hard surface cleaners. It covers the procedure for preparing a nonporous surface with the intent to measure one or all of the various aspects of a trigger product: package, application, performance, and after-use properties, with focus on visual, tactile, fragrance, performance, and package ergonomics. It is applicable for use with assessors, highly trained assessors, and consumers. 1.2 This guide for preparing nonporous hard surfaces is intended to focus on surface preparation and evaluation, not on panel selection, training, or development. 1.3 The reader should be aware that good sensory practices are required when preparing the surfaces, and in developing and training the assessors. 1.4 The researcher is responsible for identifying the most appropriate test design and using the appropriate statistical tool to address that experimental design. 1.5 Since this guide's intended use is to provide direction on the presentation and measurement of the different aspects of spray trigger hard surface cleaners, this guide may not accurately represent all possible soils and surfaces where spray trigger hard surface cleaners may be used. 1.6 This guide provides suggested procedures and is not meant to exclude alternate procedures that may be effectively used to provide the same results. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory requirements prior to use.
Standard Guide for Sensory Evaluation of Household Hard Surface-Cleaning Products with Emphasis on Spray Triggers
Covers wax polish suitable for use on shoes, boots, and leather goods.
Wax shoe polish
Covers wax polish suitable for use on surfaces of cement, and available in three colours.
Wax stoep polish
Chemical disinfectants and antiseptics - Quantitative suspension test for the evaluation of fungicidal or yeasticidal activity of chemical disinfectants and antiseptics used in food, industrial, domestic and institutional areas - Test method and requireme
Specifies a method for the determination of the performance of wax polishes.
Performance of wax polishes
本标准规定了木制品上光蜡的产品分类、要求、试验方法、检验规则和标志、包装、运输、贮存。保质期。 本标准适用于含蜡的木制品表面涂擦的上光用品。
Wooden products wax
本标准规定了汽车上光蜡的术语和定义、要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。
Automobile polish
Specifies a method for the determination of the non-volatile matter content and the ash content of the non-volatile matter of wax polishes.
Wax polishes - Non-volatile matter content and the ash content of non-volatile matter
Specifies a method for the determination of the depth of penetration of penetrometer cones in wax (paste) polishes.
Penetration of wax (paste) polishes
This proposal document provides revisions to the current UL 283 Standard. A revision is proposed to 14.1.8 and an exception to paragraph 75.7b.
Air fresheners and deodorizers
This European Standard specifies requirements and test methods for the fire safety of candles intended to be burned indoors.
Candles - Specification for fire safety
Specifies requirements for refined petroleum jelly (petrolatum) in two colour grades (white and yellow), which is intended for use in pharmaceutical and cosmetic applications.
Petroleum jelly (petrolatum)
This European standard specifies products safety labels for burning indoor candles.
Candles - Product safety labels; German version EN 15494:2007
This European Standard specifies requirements and the test method for evaluating the sooting behaviour of burning candles. It is applicable to single wick candles with a diameter up to 100 mm or equivalent cross sectional area intended to be burned indoors.
Candles - Specification for sooting behaviour; German version EN 15426:2007
This European Standard specifies requirements and test methods for the fire safety of candles intended to be burned indoors.
Candles - Specification for fire safety; German version EN 15493:2007
This test method measures the ability of a floor polish to resist soiling by a standard soil that approximates dirt carried in from the outside.1.1 This test method covers the determination of soil resistance of floor polishes on test tile only. A carpet covered roller is used to simulate the action of foot traffic. A synthetic soil is employed in conjunction with the roller. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Soil Resistance of Floor Polishes
本标准规定了变通蜡烛的术语和定义、要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于以石蜡/或植物蜡为主要原料经加工而成的蜡烛。
Basic candle
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号