This standard specifies the terminology, classification, requirements, test methods, inspection rules, signs, packaging, transportation and storage of automatic weighing instruments for dynamic road vehicles (hereinafter referred to as weighing instruments). This standard applies to weighing instruments for weighing the single axle load (or axle group load) and the total weight of the vehicle. This standard applies to weighing instruments that meet the following conditions: ——installed in the weighing control area; ——weighing speed is specified by the manufacturer. This standard does not apply to the following weighing instruments: - weighing instruments installed directly on ordinary roads; - weighing instruments using the method of multiplying the load of a single wheel to determine the load of each axle; - weighing systems installed on vehicles, for Vehicle axle loads are measured. If the dynamic road vehicle automatic weighing instrument can work in the non-automatic weighing (static weighing) mode during use, it should also meet the relevant requirements of 0IML R76 "Non-automatic weighing instruments".
GB/T 21296-2007 Referenced Document
GB/T 13384 General specifications for packing of mechanical and electrical product*, 2008-07-18 Update
GB/T 14250 Terminology of weighing instruments*, 2008-12-30 Update
GB/T 17626.11 Electromagnetic Compatibility Testing and Measurement Techniques Part 11: Voltage Dips, Short Interruptions and Voltage Variation Immunity Tests for Equipment with Input Current Less than or Equal to 16 A per Phase*, 2023-05-23 Update
GB/T 17626.6 Electromagnetic compatibility—Testing and measurement techniques—Immunity to conducted disturbances,induced by radio-frequency fields*, 2017-12-29 Update
GB/T 191 Packaging.Pictorial marking for handling of goods*, 2008-04-01 Update
GB/T 2423.1-2001 Environmental testing for electric and electronic products Part 2: Test methods Tests A: Cold
GB/T 2423.2-2001 Environmental testing for electric and electronic products Part 2: Test methods Tests B: Dry heat
GB/T 2423.3-2006 Environmental testing for electric and electronic products-Part 2:Tesing method-Test Cab:Damp heat,steady state