When sampling in accordance with the method specified in ISO 3082:2002, the experimental method specified in this section is based on the stop-band sampling method of ISO 3082:2002 as a standard method to check the sampling deviation of iron ore. A check of the mechanical sampling system is recommended prior to deviation testing. For a sampling system that does not fully comply with ISO 3082:2002, deviations are generally undesirable. Therefore, when there is any objection to the main impact that does not meet the conditions of ISO 3082:2002, a deviation checking experiment can be done. If one party believes that under some specific conditions, the deviation may be large, then when using these conditions, the deviation test should usually be done. This section applies to the experimental method for checking the sampling deviation of iron ore.
GB/T 10322.4-2014 Referenced Document
GB/T 10322.1-2014 Iron ores—Sampling and sample preparation procedures
GB/T 10322.3-2000 Iron ores-Experimental methods for checking the precision of sampling
GB/T 10322.7-2004 Iron ore-Determination of size distribution by sieving
GB/T 20565-2006 Iron ores and direct reduced iron Vocabulary
ISO 3085:2002 Iron ores - Experimental methods for checking the precision of sampling, sample preparation and measurement
GB/T 10322.4-2014 history
2014GB/T 10322.4-2014 Iron ores.Experimental methods for checking the bias of sampling
2000GB/T 10322.4-2000 Iron ores-Experimental methods for checking the bias of sampling