共找到 2366 条与 航空航天用流体系统和零部件 相关的标准,共 158 页
Aerospace series - Cap, protective, non-metallic, for EN 6123 fitting ends
Aerospace — Fluid systems — Thermal shock testing of piping and fittings
Aerospace — Fluid systems — Thermal shock testing of piping and fittings
Aerospace series - Plug, protective, non-metallic, for NAS1760 fitting ends and AS33649 boss ports
Aerospace series - Cap, protective, non-metallic, for EN 6123 fitting ends
Aerospace series - Cap, protective, non-metallic, for EN 6123 fitting ends
Aerospace series - Plug, protective, non-metallic, for EN 6123 fitting ends
Aerospace series - Plug, protective, non-metallic, for EN 6123 fitting ends
Aerospace series - Plug, protective, non-metallic, for NAS1760 fitting ends and AS33649 boss ports
Aerospace series - Cap, protective, non-metallic, for EN 6123 fitting ends
Aerospace series - Plug, protective, non-metallic, for NAS1760 fitting ends and AS33649 boss ports
Aerospace series - Plug, protective, non-metallic, for EN 6123 fitting ends
1 Scope This document specifies the dimensions, tolerances and required characteristics of protective plugs, non‑metallic, for NAS1760 fitting ends and AS33649 boss ports to seal fluid ports during transportation and storage in order to prevent — contamination by moisture, fluids, chemicals and particles, — spillage inside package or aircraft section, — port and pipe end damages and — port and pipe clogging due to plug ingestion. Because of the cleanliness requirements, parts shall only be used once.
Aerospace series. Plug, protective, non-metallic, for NAS1760 fitting ends and AS33649 boss ports
What is BS EN 6141 about? BS EN 6141 discusses standards for plug, protective, non-metallic, for EN 6123 fitting ends. BS EN 6141 specifies the dimensions, tolerances, and required characteristics of protective plugs, non-metallic, for EN 6123 fitting ends to seal fluid ports during transportation and storage in order to prevent: Contamination by moisture, fluids, chemicals, and particles Spillage inside package or aircraft section
Aerospace series. Plug, protective, non-metallic, for EN 6123 fitting ends
This document specifies the dimensions of connections for starting aircraft engines by air, which are necessary to ensure international interchangeability of connectors with adaptors. lt also gives the minimum clearances required on the aircraft to provide adequate access for the ground adaptor.
Aircraft — Connections for starting engines by air
1.1 This practice describes procedures for taking a sample of cryogenic aerospace fluid for analysis. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use. For hazard statement, see Section 5. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Sampling Cryogenic Aerospace Fluids
BS ISO 24567. Aerospace series. Pipe coupling 8°30' in titanium alloy. Thrust wire nuts
BS ISO 24568. Aerospace series. Pipe coupling 8°30' up to 28 000 kPa Dynamic beam seal. Metric series. Technical specification
Aerospace-Instrument mounting sheet spring nut
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号