59.080.20 纱线 标准查询与下载

T/SDTAA 2004-2023 涤 纶 缝 包 线

涤纶缝包线的技术要求分为理化性能和外观质量。理化性能包括单线断裂强度、单线断裂强力变异系数、线密度偏差率、耐摩擦色牢度、长度允许偏差率、结头个数等六项。外观质量包括表面结头、污渍、色差、色花、麻懈线、蛛网等六项。

Polyester bag sewing thread

T/CCTA 30601-2023 抑菌微纳米镶嵌纺再生纤维素纤维本色纱

规定了抑菌微纳米镶嵌纺再生纤维素纤维本色纱的术语和定义、产品分类、标记、要求、试验方法、检验规则和标志、包装。抑菌微纳米镶嵌纺再生纤维素纤维本色纱要求包括线密度偏差率、线密度变异系数、单纱断裂强度、单纱断裂强力变异系数、条干不匀变异系数、千米棉结（+200%）、十万米纱疵、毛羽数、抑菌率九项指标。

Antibacterial micro-nano mosaic spinning regenerated cellulose fiber natural color yarn

T/CASME 198-2022 植物纤维混纺抗菌纱线

本文件规定了植物纤维抗菌混纺纱线的术语和定义、原材料要求、技术要求、试验方法、检验规则、标志、包装、运输及贮存。

Plant fiber blended antibacterial yarn

KS K ISO 2-2022 纺织品.纱线和相关产品捻度方向的命名

Textiles — Designation of the direction of twist in yarns and related products

KS K 0546-2022 织物纱线卷曲的试验方法:负荷伸长法

Test method for crimp in yarns from fabrics: Load-elongation method

KS K ISO 2:2022 纺织品.纱线和相关产品捻度方向的命名

Textiles — Designation of the direction of twist in yarns and related products

KS K 1200-2022 棉缝纫线

Cotton sewing thread

KS K 1305-2022 Polynosic缝纫线

Polynosic sewing thread

KS K 1303-2022 亚麻和苎麻缝纫线

Linen and ramie sewing thread

KS K 1104-2022 棉纱

Cotton yarns

T/CTES 1052-2022 聚酯纤维原位聚合着色用乙二醇基色浆

本文件规定了聚酯纤维原位聚合着色用乙二醇基色浆技术要求、试验方法、检验规则、标志、包装和贮存等内容。 本文件适用于以乙二醇为分散介质，由各种颜料、颜料改性剂及分散稳定剂配制而成的聚酯纤维原位聚合着色用乙二醇基色浆。

Glycol-based colorants for in-situ polymerization dyeing of polyester fiber

ASTM D5344-22 部分取向纱拉伸力的标准试验方法

1.1 This test method covers the measurement of extension force developed while drawing a partially oriented filament yarn between pairs of draw rolls of different surface speeds. 1.2 Extension force provides an estimate of the yarn orientation. 1.3 This test method applies to partially oriented filament yarns less than 33.3 tex (300 denier), but it can be used for higher deniers by applying the test conditions as directed in Appendix X1. 1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Extension Force of Partially Oriented Yarn

ASTM D1059-17(2022) 基于短长度样品的纱线数的标准试验方法

1.1 This test method covers the determination of the yarn number of all types of cotton, woolen, worsted, and man-made fiber yarns taken from packages; or from any textile fabrics in which the yarns are intact and can be removed in measurable lengths. The test method is not applicable to yarns taken from napped or cut pile fabrics. Because this test method is based on short-length specimens, the results should only be considered as approximations of yarn number. NOTE 1—For a more precise procedure for the determination of yarn number, refer to Test Method D1907. NOTE 2—The following additional methods for the determination of yarn number have been approved for yarns made from specific fibers: Specification D541, D578, and D681. 1.2 This test method is applicable to yarns which stretch less than 5 % when tension on yarn is increased from 0.25 to 0.75 cN/tex (0.25 to 0.75 gf/tex). By mutual agreement it may be adapted to yarns which stretch more than 5 % by use of tension lower than that specified in the method for elastomers or use of tension higher than that specified in the method to pull the crimp out of textured yarns. 1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Yarn Number Based on Short-Length Specimens

T/CNTAC 123-2022 干、湿状态下纱线间耐磨性试验方法

"本文件规定了在干、湿两种状态下纱线间的耐磨性能的试验方法。 本文件适用于原料为棉、麻、丝、毛及化学纤维的纯纺或混纺纱线。"

Test method for wet and dry yarn-on-yarn abrasion resistance

T/CCTA 30901-2022 含循环再利用棉色纺纱

含循环再利用棉色纺纱技术要求包括线密度偏差率、线密度变异系数、单纱断裂强度、单纱断裂强力变异系数、条干不匀变异系数、千米棉结（+200%）、明显色结、十万米纱疵、毛羽数、色牢度、色差十一项指标。

Contains recycled cotton dyed yarn

T/CCTA 30505-2022 喷气涡流纺涤纶莱赛尔纤维混纺本色纱

喷气涡流纺涤纶莱赛尔纤维混纺本色纱要求包括线密度偏差率、线密度变异系数、单纱断裂强度、单纱断裂强力变异系数、条干不匀变异系数、千米棉结(+200%)、十万米纱疵、纤维含量偏差八项指标。

Air-jet vortex spinning polyester lyocell fiber blended natural color yarn

T/CASME 23-2022 聚酯薄膜金银丝

本文件规定了聚酯薄膜金银丝的技术要求、试验方法、检验规则、标志、包装、运输和贮存。

Polyester film metallic yarn

KS K 0044-2022 毛纺纱线的标准公差

Standard tolerances for yarn spun on the woolen system

T/CASMES 78-2022 机织聚酯雪尼尔色纱

本文件规定了机织聚酯雪尼尔色纱的术语和定义、产品规格标示、技术要求、试验方法、检验规则、标志、包装、运输和贮存。 本文件适用于以聚酯纤维为单纱、股线或长丝经环锭纺制成的机织雪尼尔色纱，仅适用于家纺类产品。

Woven polyester chenille colour yarn

T/CCTA 30201-2022 棉粘胶纤维/锦纶长丝包芯本色纱

本文件规定了棉粘胶纤维/锦纶长丝包芯本色纱产品的术语和定义、分类、标记、要求、试验方法、检验规则和标志、包装。本文件适用于锦纶长丝（22.2?44.4dtex）为芯纱，外包精梳棉和粘胶纤维，经环锭纺加工的包芯本色纱。

Cotton viscose fiber/nylon filament core-spun natural color yarn